Cisco Systems RV0041の取扱説明書

ページ1に含まれる内容の要旨

Connect the Router Configure the Router
1 2
®
A Division of Cisco Systems, Inc.
A Before you begin, make sure In Step 2, you will need the setup
E Connect the included AC
that all of your hardware is instructions provided by your Inter-
power cable to the Router’s
powered off, including the net Service Provider (ISP). If you do
Power port on the back of the
Router, PCs, hubs, switches, not have this information, then con-
Router, as shown in Figure E,
and cable or DSL modem. tact your ISP

ページ2に含まれる内容の要旨

C The Router’s Web-based Utility 1 Obtain an IP Automatically 3PPPoE G If you haven’t already done so, will appear with the System click the Save Settings button. Summary screen showing. a If your ISP says that you are a If your ISP says that you are Then, close the web browser. Click on the Setup tab, which is connecting through DHCP or a connecting through PPPoE or if the next tab over, then con- dynamic IP address from your you normally enter a user H Power your cable or DSL tinue with th