ページ1に含まれる内容の要旨
®
HeatMaster
Installation, Operating and
Servicing Instructions
®
HeatMaster 200 N
®
HeatMaster 200 F
excellence in hot water
04/03/2004 - 66412600
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
INDEX INTRODUCTION INTRODUCTION 1 TARGET GROUP Target group 1 This manual is intended for the use of: Symbols 1 - final users of the appliance; Certification 1 - the engineer installing and starting up the appliance; Information and safety instructions 2 - the engineering and design department; - the installer responsible for servicing or maintaining the appliance. USER GUIDE 2 SYMBOLES Use of the boiler 2 The following symbols are used in this manual: DESCRIPTION 3 Operating principle 3 Packing
ページ4に含まれる内容の要旨
INTRODUCTION USER GUIDE GENERAL INFORMATION USING THE BOILER AND SAFETY INSTRUCTIONS General information It is compulsory to have your system serviced every This documentation forms part of the items delivered with the year by a competent engineer. In the event of heavy appliance and must be given to the user to keep in a safe place! use of the boiler, it may require servicing on a more regular basis than once a year. In this case, contact This appliance must be serviced and repaired by an appro
ページ5に含まれる内容の要旨
USER GUIDE DESCRIPTION 5. Time clock OPERATING PRINCIPLE ® This allows the HeatMaster to be timed on and off and operates on a 24 hour sequence. Around the outside of the clock there are a ® The HeatMaster is a high performance, direct fired hot water number of white tabs, these allow 15 minute switching periods. To storage heater, which has indirect heat transfer due to its Tank-in- set the time clock simply push outwards the number of tabs required Tank construction. for ON period. ® At the he
ページ6に含まれる内容の要旨
DESCRIPTION CONSTRUCTION FEATURES 1 5 Outer body The outer body, containing the primary water, is made from STW 22 carbon steel. TANK-IN-TANK heat exchanger The ring-shaped inner tank with its large heating surface for producing domestic hot water is built of Chrome/Nickel 18/10 stainless steel. It is corrugated over its full height by an exclusive 6 production process and entirely argon arc welded by the TIG 2 (Tungsten Inert Gas) method. Combustion gas circuit The combustion gas circuit is pai
