ページ1に含まれる内容の要旨 
                    
                        User's Guide
TR-966D 
10/100Mbps WDM Fiber Bridge                                                                                                                                                                                                                                                                                                                                                                                                                                                                   
                    
                    ページ2に含まれる内容の要旨 
                    
                        COPYRIGHT & TRADEMARKS Table of Content Specifications are subject to change without notice. Package Contents........................................................................1 is a registered trademark of TP-LINK Introduction...................................................................................1 Technologies Co., Ltd. Other brands and product names Features........................................................................................1 are trademarks or registered tr
                    
                    ページ3に含まれる内容の要旨 
                    
                        Package Contents The following contents should be found in your box:   One WDM Fiber Bridge   One AC adapter   This User’s Guide   Warranty card Introduction The TR-966D product is 10/100Mbps WDM Fiber Bridge.  By  deploying WDM technology (Wavelength Division Multiplexer),  only single-mode fiber is needed to transmit and receive optical  Ethernet packets. The TR-966D mediates between a 10/100Base-TX segment  and a 100Base-FX segment. It is primarily designed for large,  more high speed/ban
                    
                    ページ4に含まれる内容の要旨 
                    
                          Auto-detection of half/full duplex transfer mode for RJ45           port. TR-966D 10/100M WDM Fiber Bridge   Auto-negotiation of 10/100Mbps rate and Auto-MDIX for TR-966D Front Panel           RJ45 port.   Fiber port only support full duplex transfer. 2. Rear Panel   Extend fiber distance up to 20km for fiber port. The rear panel of the TR-966D consists of one AC power    Easy-to-view LED indicators provide status to easily monitor connector, two 10/100Mbps RJ45 ports and two SC Fiber    
                    
                    ページ5に含まれる内容の要旨 
                    
                          T1_Link/ Act/ T2_Link/ Act(Green): Steady green   Make sure that the length of twisted pair cable (Category-         indicates that a valid link exists. Flashing green indicates        5) between 10/100Base-TX device and converter is not           that the TR-966D is receiving or transmitting data from the          longer than 100 meters.           RJ-45 port.   Connect one end of twisted pair cable to RJ45 jack on the   F1_Link/Act/ F2_Link/Act (Green): Steady green        TR-966D and the
                    
                    ページ6に含まれる内容の要旨 
                    
                        71035589 Appendix Specification General  Standard IEEE 802.3 10Base-T  IEEE 802.3u 100Base-TX/100Base-FX  Topology Star  Protocol CDMA/CD  Data Transfer Ethernet: 10Mbps(Half Duplex);   Rate                  20Mbps(Full  Duplex)  Fast Ethernet: 100Mbps(Half Duplex);                                             200Mbps(Full Duplex)   Ports 2 10/100Mbps RJ-45 ports  2 SC Fiber ports   ( F1: 1310/1550 nm Single- mode single Fiber   F2: 1550/1310 nm Single-mode single Fiber)  LED indicator POWER Powe