Xpress Ethernet Bridge XEB09-Cの取扱説明書

ページ1に含まれる内容の要旨

™
XPress Ethernet Bridge
Product Manual - Commercial/Indoor XEB09-C
Create long range wireless links in minutes!
Connect any Ethernet device to the XPress Ethernet Bridge
RF Modems and the bridge will function in place of
an Ethernet cable. The Ethernet bridge provides a
transparent wireless point-to-point cable replacement.
www.maxstream.net
© 2006 MaxStream, Inc. All rights reserved. M100257
Introduction
This manual provides step-by-step instruction on how to s

ページ2に含まれる内容の要旨

LED Display The XPress RF Modem has 16 LEDs that display the status of the device. LED Name Function Color 1 Power Unit has power and has successfully booted. Red 2 RF Link RF modem has successfully linked with its partner. Green 3 RF TX Radio transmission is occurring. Green 4 RF RX Radio reception is occurring. Green 5 Eth Link Ethernet port has a valid Ethernet connection. Green 6 Activity RF modem is processing data. Green 7 1 (channel) To determine the current radio channel, add the numbers

ページ3に含まれる内容の要旨

Advanced Settings Automatic Frequency Selection Mode (All DIP Switches OFF (up)) The RF modem is designed to automatically select and continuously optimize the performance of its radio channel. The radio channel is monitored to ensure it is providing low error rates necessary for successful radio transmission. In the event that the error rate rises, the RF modem will autonomously change to a new channel. There are 12 non- overlapping channels. Figure 2. DIP Switches ‐ 

ページ4に含まれる内容の要旨

Technical Specifications Specification Description Power Output 125 mW (21 dBm) conducted, 4 Watts EIRP w/ 15 dBi antenna RF Data Rate 1.5 Mbps Throughput Data Rate 935 Kbps -4 Receiver Sensitivity -97 dBm @10e BER (-112 dBm w/ 15 dBi antennas) Latency < 1ms - assuming a dedicated wireless link to client device Jitter ±0.5 ms - depending upon packet size, interference and SNR Radio channels 12 Non-overlapping Automatic frequency select Yes - radio channel automatically selected and adaptively