Rinnai Q175SPの取扱説明書

デバイスRinnai Q175SPの取扱説明書

デバイス: Rinnai Q175SP
カテゴリ: ボイラー
メーカー: Rinnai
サイズ: 1.93 MB
追加した日付: 11/18/2013
ページ数: 32
説明書を印刷

ダウンロード

使い方は?

私たちの目的は、皆様方にデバイスRinnai Q175SPの取扱説明書に含まれたコンテンツを可能な限り早く提供することです。オンラインプレビューを使用すると、Rinnai Q175SPに関してあなたが抱えている問題に対する解決策の内容が素早く表示されます。

便宜上

説明書Rinnai Q175SPをこちらのサイトで閲覧するのに不都合がある場合は、2つの解決策があります:

  • フルスクリーン表示 – 説明書を(お使いのコンピュータにダウンロードすることなく)便利に表示させるには、フルスクリーン表示モードをご使用ください。説明書Rinnai Q175SPのフルスクリーン表示を起動するには、全画面表示ボタンを押してください。
  • コンピュータにダウンロード - Rinnai Q175SPの説明書をお使いのコンピュータにダウンロードし、ご自身のコレクションに加えることもできます。デバイス上のスペースを無駄にしたくない場合は、いつでもManualsBaseサイトでダウンロードすることもできます。
Rinnai Q175SP 取扱説明書 - Online PDF
Advertisement
« Page 1 of 32 »
Advertisement
印刷版

多くの人々は画面表示ではなく印刷された説明書を読むほうを好みます。説明書を印刷するオプションも提供されており、上記のリンクをクリックすることによりそれを利用できます - 説明書を印刷。説明書Rinnai Q175SPを全部印刷する必要はなく、選択したページだけを印刷できます。紙を節約しましょう。

要旨

次のページにある説明書Rinnai Q175SPの内容のプレビューは、以下にあります。次のページにある説明書の内容をすぐに表示したい場合は、こちらをご利用ください。

内容要旨
ページ1に含まれる内容の要旨

User information manual
High efficiency condensing gas boiler
Q85SN/Q130SN/Q175SN/Q205SN/Q175CN
Q85SP/Q130SP/Q175SP/Q205SP/Q175CP
WARNING!
Installation and service must be
performed by a qualified installer ,
service agency or the gas supplier.
Pictured: Q85SN, Q130SN
Q85SP, Q130SP
WARNING!
If you do not follow these instructions exactly , a fire or
explosion may result causing property damage, personal
injury or loss of life.
- Do not store or use gasoline or other flammable
v

ページ2に含まれる内容の要旨

Contents of instructions These instructions contain important information for the safe use of Rinnai Q-Series gas boilers. These user instructions are intended for the owner or responsible tenant of the premises where the boiler is installed. Subject to technical changes Changes may be made to the illustrations, process steps and technical data as a result of our policy of continuous improvement without prior notice. Updating of documentation Please contact us if you have any suggestions for

ページ3に含まれる内容の要旨

Safety and general instructions Please observe these instructions in the interest of your own safety. Designated use The boiler is designed to heat water for a central heating system and, if applicable, generating domestic hot water. The boiler is delivered with a burner controller pre-installed.The boiler can be fitted with a modulating outdoor reset control ARV12 (included), a room controller RS100 (optional), a zone controller (optional) or an On/Off thermostat or relay panel end sw

ページ4に含まれる内容の要旨

These operating instructions describe the operation of the Rinnai Q-Series condensing gas boilers. This manual is for the end user. For installation and servicing there is a installation & servicing instructions manual for the installer. Read this manual fully before operating the boiler. In case of doubt or errors contact your installer. The manufacturer reserves the right to change the specifications and dimensions without prior notice. Work on the boiler must be carried out by a Sta

ページ5に含まれる内容の要旨

Safety FOR YOUR SAFETY READ BEFORE OPERATING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the burner. Do NOT try to light the burner by hand. B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and

ページ6に含まれる内容の要旨

Should overheating occur or the gas supply DANGER ! fail to shut off, do not turn off or disconnect the electrical supply to the pump. Instead, shut off the gas supply at a location external to the appliance. Protection for corrosion WARNING ! Do not use any sprays, chlorine containing agents, solvents, paint etc. around the boiler or around the air intake supply entrance of the boiler. These substances have negative influences on the boiler and can lead to corrosion resulting in failure

ページ7に含まれる内容の要旨

Description of the boiler The Rinnai Q boiler is a room sealed, condensing and modulating central heating boiler. The Q175C has an integrated domestic hot water feature. The boiler is provided with a integrated control system. Because an outdoor sensor is connected to the boiler, the boiler works weather dependantly. This means that the boiler control measures the outside temperature and flow temperature. With this data the boiler calculates the optimal flow temperature for the installa

ページ8に含まれる内容の要旨

Explanation of the function buttons 1 2 3 7 4 5 6 8 Only qualified personel who are trained for NOTICE these boilers are permitted to make alterations i in the controller to chronolize the boiler to the installation. 1. Display. See following pages for further information. 2. ON-OFF Switch This switch turns the power supply to the boiler on or off. 3. Central Heating program button. Switching the Central Heating on or off (Led on/off); 4. Hot Water program button. Switching the

ページ9に含まれる内容の要旨

6 Mode-button. Only for Service personel 7 Step-button. After briefly pressing, the water pressure can be retrieved. After pressing for 5 seconds it switches from the Good-state to technical read out and vice versa (see following pages); 8 Reset-button. When a fault occurs it will be shown by the flashing E (Error) with a number code after which the boiler is shut down. After pressing the reset key you can try to start the boiler again. If the error message keeps occurring contact

ページ10に含まれる内容の要旨

The boiler display Two boiler displays, “Good or Technical” see below. Good or standard read out. During this reading the display will only show what is necessary. Under normal circumstances the display will give a Good reading. In case of a fault this will be shown with, alternate display of Good, with an E or BL code. See further "Errors, maintenance and warranty" . Technical The second way is a technical read out. In normal situations the following will be shown: • on the left the

ページ11に含まれる内容の要旨

Water pressure in the central heating system The installation will function optimally with a water pressure of between 22 and 25 PSI. If the water pressure drops below 14.5 PSI, the display will show FILL. During this message the boiler will remain functioning at a reduced level. After replenishing the system (see following chapter) just above 22 PSI the message FILL will disappear and the boiler will function normally again. When the water pressure drops below 10 PSI, the display will

ページ12に含まれる内容の要旨

Replenishing the central heating system The central heating installation needs to be filled with potable (drinking) water. For topping up the installation you use the filling loop according to the following procedure: Contact your installer if your installation is not NOTICE i provided with a filling loop. 1 Switch all functions off (heating, DHW and pump); 2 Briefly push the 'STEP'-button: P x.x = water pressure in PSI; 3 Slowly open the filling loop (Indication on display increases); 4 Fil

ページ13に含まれる内容の要旨

The boiler will not function directly. The automatic de-aeration program of about 17 minutes will start after one of the three program buttons is pressed. The display will show where A stands for Automatic de-aeration program Active and the number on the right indicates the actual water temperature of the boiler. Check the water pressure regularly and top up the installation when necessary. The working pressure of the installation should be between 22 and 25 PSI It can take a while

ページ14に含まれる内容の要旨

Error, maintenance and warranty If a fault is detected the boiler will be blocked. This will be reflected, by an alternate display of Good, with an E of Error or a BL of Blocking and a number code. You can try to reset the boiler by pressing the NOTICE Reset key once. If the problem remains please i contact your installer and inform them about the fault and give them the number code. If you discover any leaks from the boiler NOTICE i contact your installer. We advise you to obtain a ser

ページ15に含まれる内容の要旨

Maintenance or changes to the appliance may only NOTICE i be carried out by a qualified technician. You can find the warranty conditions in the warranty card which is supplied with the boiler. 15 Operating instructions Rinnai Q-Series

ページ16に含まれる内容の要旨

16 Operating instructions Rinnai Q-Series

ページ17に含まれる内容の要旨

M o d e d' e m p l o i Chaudière à gaz à condensation à haut rendement Q85SN/Q130SN/Q175SN/Q205SN/Q175CN Q85SP/Q130SP/Q175SP/Q205SP/Q175CP AVERTISSEMENT! L'installation et l'entrétien doivent être assurés par un installateur ou un service d'entrétien qualifié ou par le fournisseur de gaz. Illustré: Q85SN, Q130SN Q85SP, Q130SP AVERTISSEMENT! Assurez-vous de bien suivre les instructions données dans cette notice pour réduire au minimum le risque d'incendie ou d'explosion ou pour éviter t

ページ18に含まれる内容の要旨

Contenu des instructions Ces instructions contiennent d’importantes informations pour l’utilisation en toute sécurité des chaudières à gaz de la série Rinnai Q. Ces instructions d’utilisation sont destinées au propriétaire ou au responsable locataire des locaux où la chaudière est installée. Susceptible de modifications techniques Des modifications peuvent être effectuées sur les illustrations, les étapes du processus et les données techniques résultant de notre politique d’amélioration cont

ページ19に含まれる内容の要旨

Sécurité et instructions générales Veuillez observer ces instructions dans l’intérêt de votre propre sécurité. Utilisation prévue La chaudière est conçue pour chauffer de l’eau pour un circuit de chauffage central et, le cas échéant, pour produire de l’eau chaude domestique. La chaudière est livrée avec un contrôleur de brûleur pré installé. La chaudière peut être équipée d’une commande de réinitialisation modulante extérieure ARV12 (compris), d’un contrôleur de pièce RS100 (en option),

ページ20に含まれる内容の要旨

REMARQUE : REMARQUE i Indique des instructions particulières sur l’installation, le fonctionnement ou la maintenance qui sont importantes mais non liées à des blessures corporelles ou des dégâts matériels. Ces instructions de fonctionnement décrivent le fonctionnement des chaudières à gaz à condensation de la série Rinnai Q. Ce manuel est destiné à l’utilisateur final. Pour l’installation et l’entretien, il existe un manuel d’instructions d’installation et d’entretien pour l’installateu


類似の説明書
# 取扱説明書 カテゴリ ダウンロード
1 Rinnai E110CN 取扱説明書 ボイラー 14
2 Rinnai Q130SP 取扱説明書 ボイラー 4
3 Rinnai E110CP 取扱説明書 ボイラー 5
4 Rinnai Q175C 取扱説明書 ボイラー 1
5 Rinnai E75CN 取扱説明書 ボイラー 17
6 Rinnai E75CP 取扱説明書 ボイラー 1
7 Rinnai EPA-09-0001 取扱説明書 ボイラー 1
8 Rinnai Q175S 取扱説明書 ボイラー 0
9 Rinnai Q130SN 取扱説明書 ボイラー 0
10 Rinnai Q175CP 取扱説明書 ボイラー 0
11 Rinnai EPD-09-0001 取扱説明書 ボイラー 0
12 Rinnai Q175SN 取扱説明書 ボイラー 2
13 Rinnai Q175CN 取扱説明書 ボイラー 1
14 Rinnai Q205SN 取扱説明書 ボイラー 0
15 Rinnai Q205SP 取扱説明書 ボイラー 5
16 Sony HDV 1080I HVR-M15N/M15P 取扱説明書 ボイラー 67
17 Sony HDV 1080I HVR-M25N/M25P 取扱説明書 ボイラー 50
18 A.O. Smith 200 取扱説明書 ボイラー 2
19 A.O. Smith 201 取扱説明書 ボイラー 7
20 A.O. Smith 750 & 1000 取扱説明書 ボイラー 6