ページ1に含まれる内容の要旨
Introduction
Operation Maintenance Troubleshooting
Instruction Manual
NEOREST 600
MS990CG
Important Safety Instructions .......... 2
Operational Instructions.................. 5
Tips for Using the NEOREST 600.... 6
Performance Features .................... 7
Parts and Features ......................... 9
Before Using the NEOREST 600.... 11
How to Use the NEOREST 600...... 13
For Best Results ............................. 15
Adjusting the Temperature .............. 15
Deodorizing.............
ページ2に含まれる内容の要旨
Important Safety Instructions When using electrical products, especially when children are present, basic safety precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING To reduce the risk of electrocution: DANGER 1. Do not use while bathing. 2. Do not place or store products where it can fall or be pulled into tub or sink. 3. Do not place in or drop into water or other liquid. 4. Do not reach for a product that has fallen into water. Unplug immediately.
ページ3に含まれる内容の要旨
Introduction To reduce the risk of electrocution: DANGER 13. Periodically remove dust and dirt from the power plug and make sure they are tightly plugged into the wall outlet. Failure to do so may result in electrical shock or fire. Pull the plug out from the outlet and wipe clean with a dry cloth. 14. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord. Pulling on the cord may cause damage and result in electrical shock or fire. To reduce the risk of burns, electrocu
ページ4に含まれる内容の要旨
To reduce the risk of burns, electrocution, fire WARNING or injury to persons: 17. Always use the NEOREST at a room temperature of 32°F (freezing temperature) or above to prevent frozen pipes and hoses. Frozen water pipes will cause the toilet and the pipes to break resulting in water leakage. Refer to Page 38 for instructions on how to prevent frozen pipes. GROUNDING INSTRUCTIONS This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electr
ページ5に含まれる内容の要旨
Introduction Operational Instructions Always follow these precautions to ensure the safe use of your product. Do not wipe the toilet unit or seat Do not expose the NEOREST to with a dry cloth or toilet paper. direct sunlight. Use of a dry cloth or toilet paper to wipe Use of the product under direct sunlight the toilet bowl, seat or lid will scratch the may result in discoloration of the plastic, surface. inconsistent temperature control of the toilet seat or malfunction of the remote Refer
ページ6に含まれる内容の要旨
Tips for Using the NEOREST 600 Protect the environment and reduce the use of water and electricity. Use the timer and Use the Auto save energy. Energy Saver. Set the timer so that it Use the Auto Energy 81-97¡F shuts off the toilet seat Saver to automatically heater each day at the reduce the toilet seat same time to save temperature when the Auto preset is set to . 79¡F energy. The shutoff toilet is not being used. time can be set for 3, See page 25. Shut f of for 3 hours 6 and 9 hours. to con
ページ7に含まれる内容の要旨
Introduction Performance Features Washing Functions Page Rear cleansing The Pulsating wash alternates cycles strong and soft sprays of water approximately 70 times per second for a very thorough Soft rear cleansing rear wash. 13 The soft wash and Front features provide a soft, yet thorough, Front cleansing whirling flow of water. Wash position The wand can be adjusted forward or backward. 13 adjustment Water pressure The water pressure can be adjusted to soft or strong. 13 adjustment Osc
ページ8に含まれる内容の要旨
Energy Saving Features Page Timer ON/OFF Conserve energy by pre-setting the timer to turn off the toilet seat heater for the same time period each day.(Can be set for 23, 24 3, 6 or 9 hour periods of time). Auto ON/OFF The unit memorizes the time of day at which the toilet is least used and automatically reduces the toilet seat temperature to 25-27 conserve energy. ON/OFF Button Turn the button to the OFF position to stop warming the toilet 12 seat and conserve energy. Sanitary Features Pa
ページ9に含まれる内容の要旨
Introduction Parts and Features Lid anti-bacterial Remote controller Label Remote controller hanger Main unit oilet T seat sensor ashlet W water f shutof valve (See page 14) Heated toilet seat anti-bacterial Connection hose (See page 15) Power plug (see page 12, 34) and W and (W head is anti-bacterial .) (See page 36) ater W f shutof valve oilet T bowl (equipped with water supply (The surface of the toilet bowl , filter See page 12, 34) is anti-bacterial .) (See page 37) Main Unit Controls Motio
ページ10に含まれる内容の要旨
The main control buttons have imprints for vision-impaired users. Remote Controller a digital “ping” will sound off while the main unit is receiving signals from the remote controller. Cover Closed The control buttons have been Anti- treated with an anti-bacterial bacterial finish. Remote Control button for flushing the toilet bowl (See page 20) Remote Control transmitter Remote Control button for OPEN/CLOSE toilet seat and lid (See page 17) Rear ash W button Remote Control transmitter Stop bu
ページ11に含まれる内容の要旨
Introduction Before Using the NEOREST 600 Preparation Insert batteries into the remote controller. ➀ Remove the remote controller from its wall hanger. Grasp the remote controller at each side and pull straight up. ➁ Open the battery cover on the back of the remote controller. ➂ Insert 2 AA batteries into the battery compartment. 2 AA batteries ➃ Close the battery cover. 1 close open back side battery cover If the batteries are properly inserted, the remote controller Remote Control Display
ページ12に含まれる内容の要旨
Insert the plug into the wall outlet. Connect the power cord to a 120V (60 Hz) GFCI protected power outlet. Open the water shutoff valve. Use the wrench provided or a flat head screwdriver to turn to the left open the water shutoff valve. water f shutof Use the wrench valve provided or a flat head screwdriver Check the [Main Unit Display]. Main Unit display Is the “POWER” light on the Main Unit POWER light oilet T seat light display ON? If the light is not ON, push the “POWER” button on
ページ13に含まれる内容の要旨
Operation How to Use the NEOREST 600 When you stand at a distance of approximately 1 foot from the front of the toilet, the lid will automatically open. (Auto OPEN/CLOSE, see page 17, 18) Sit on Seat Functions become available when toilet seat sensor is activated In preparation for wash, water is released from wand Deodorizer starts automatically Wash Front ash W Button Soft ash W Button Rear ash W Button ashes W the front ashes W from the rear with a ashes W the rear soft spray of . water
ページ14に含まれる内容の要旨
Dryer YER DR button Stop Button Dry wet areas with the urns T the Dryer . OFF warm air . dryer Wipe excess water away with a piece of toilet paper for faster drying. Move away from the toilet The deodorizer is automatically shut off after 1 minute. Flush by using the flush button on the remote control. (Auto flush, see page 21). Close the seat and lid by using the button on the remote control. (Auto open/close, see page 17, 18). About the Seat Sensor: The seat sensor detects when a person
ページ15に含まれる内容の要旨
Operation For Best Results Adjusting the Temperature Use the remote controller to adjust the water temperature, toilet seat temperature, or dryer heat to the desired setting. Open the Remote 1 Controller Cover. Cover Adjust the temperature 2 Adjust the temperature setting for the water and toilet seat by pushing the and buttons. To turn off the temperature display, push down on the button until the display goes out. 1 The dryer temperature can be adjusted to 5 different
ページ16に含まれる内容の要旨
Deodorizing Sit on the toilet seat 1 (lights up) The deodorizer funciton automatically starts The “DEODORIZER” light on the main unit display lights up. Move away from the 2 toilet seat (lights goes out) The deodorizer function automatically stops after 1 minute. The "DEODORIZER" light on the main unit display goes out. 16
ページ17に含まれる内容の要旨
Operation Opening and Closing the Toilet Seat and Lid There are 2 settings for opening and closing the toilet seat and lid. The remote controlled setting and the auto setting. Remote Controlled Opening/Closing of Toilet Seat and Lid The toilet seat and lid can be opened and closed by pushing the desired button on the remote controller. 1 Push the desired button Both the toilet seat and lid close. The lid opens and on the remote controller. the toilet seat lowers. Both the toilet seat and lid o
ページ18に含まれる内容の要旨
Motion Detection Stand in front of the 1 Sensor toilet. The Lid automatically opens If the lid does not open, move at least 1 foot away from the toilet, wait 10 seconds, and then stand in front of the toilet (lights up) again. The lid will automatically open. 1 When the motion detection sensor detects motion, the "sensor" light on the Main Unit Display will light up. The motion detection sensor detects motion and the lid opens automatically. When Sitting on the Toilet Seat When raised w
ページ19に含まれる内容の要旨
Operation When Standing in Front of the Toilet Raise the toilet seat with the Remote Controller. You must stand in front of the toilet for at least 6 seconds or the lid will not automatically close. Motion Detection Sensor After using the toilet, move at least 1 foot away (light goes out) from the toilet. The toilet seat and lid will automatically close after 90 seconds. When the motion detection sensor fails to detect motion, the "sensor" light on the Main Unit Display will go out. If you
ページ20に含まれる内容の要旨
Flushing Water There are 2 settings for flushing water. The remote controlled setting and the auto setting. Remote Controlled Flushing The toilet can be flushed by pushing the flush button on the remote controller. 1 Push the flush button on the remote controller. Flush The toilet bowl is flushed. 1.6 Gallons per Flush (6 LPF) If the remote controller batteries need replacing Use the flush button located on the main unit controls to flush the toilet. Push the flush button on the main unit co
