ページ1に含まれる内容の要旨
VBP5000
VIDEO IN A BAG SYSTEM WITH
5.6" LCD MONITOR VCP & DVD PLAYER
ページ2に含まれる内容の要旨
A. INTRODUCTION Thank you for selecting the VBP5000 “Video in a Bag” System. The system's main features include a 5.6" Liquid Crystal Dis- play (LCD) Monitor Video Cassette Payer (VCP) and a DVD Player. The VBP5000 utilizes state of the art electronics and is designed for use in Vehicles, Hotels, the Office and Home. The “Video in a Bag” System is constructed to provide years of reli- able, trouble-free service. The system is compact so that you can take it with you anywhere and is designed
ページ3に含まれる内容の要旨
IMPORTANT NOTICE It is unlawful in most jurisdictions for a person to drive a motor vehicle which is equipped with a television viewer or screen that is located in the motor vehicle at any point forward of the back of the driver’s seat, or that is visible, directly or indirectly, to the driver while operating the vehicle. In the interest of safety, this system should never be installed where it will be visible, directly or indi- rectly, by the operator of the motor vehicle.
ページ4に含まれる内容の要旨
B. CAUTIONS AND WARNINGS The Monitor is best kept in the fully closed position when it is at- tached to the VCP/DVD Player and not in use. Before putting on headphones always adjust the volume setting to the lowest posi- tion. Do not apply pressure to the screen. Caution children to avoid touching or scratching the screen, as it may become dirty or damaged. 1. PLACEMENT To prevent fire or electric shock, do not expose this appliance to rain or moisture. Do not place the set on an unstable cart
ページ5に含まれる内容の要旨
3. POWER This system MUST be powered from the type of switched (Acces- sory) power indicated on the marking label (i.e. not directly from the car battery). Power should be applied to the unit when the ignition key is in the Run and/or Accessory positions. To prevent battery discharge, disconnect the “Video in a Bag” System jack from the cigarette lighter socket when the unit is not in use. Use only the supplied power cable matching this set to avoid electric hazards. Always disconnect the power
ページ6に含まれる内容の要旨
to direct sunlight or heat sources such as hot air ducts. Do not touch the surface of disc. Handle the disc by its edge. Clean the disc by wiping the disc from the center out with a cleaning cloth. Remove the disc from the unit and store it in its case after playing. Some playback operations of discs may be intentionally fixed by software producers. Since this unit plays discs according to the disc contents the software producers designed, some playback features may not be available. Also refer
ページ7に含まれる内容の要旨
C. CONTENTS 1. 1 x Detachable Monitor & VCP & DVD Player Combo 2. 1 x DIN Cable 3. 1 x AC to DC Adapter 4. 1 x Cigarette Lighter Adapter 5. 1 x Remote Control with 2 AAA Batteries 6. 1 x Pouch 7. 1 x Mounting Bag with 4 Straps 8. 1 x Storage Bag 9. 1 x Instruction Manual D. INDOOR PLACEMENT (IN A HOTEL, OFFICE, HOME, ETC) To remove the VBP5000 from the protective mounting/storage bag, place the open end of the unit face down on a flat surface. Unfasten the Velcro Strap and pull it through the lo
ページ8に含まれる内容の要旨
Refer to the Figure 2. There are different ways to place the main unit, monitor or combo on a table or other level surface. You can detach* the monitor from the main unit by depressing the button below the screen with one hand and removing the monitor with the other hand. You can insert the monitor into the slot on the main unit with the screen facing either front or back. Adjust the screen for the desired viewing angle. The placement can be done with or without the unit inside its mounting bag
ページ9に含まれる内容の要旨
a. Refer to Figure 4. Take one of the supplied straps from the storage bag, and connect the latch to the upper side metal ring on the left side of the mounting bag. Attach the "S" hook to the same ring after looping the strap around the headrest of the driver's seat. Repeat this process for the right side (Passenger Seat). b. Take another strap and connect the latch to lower metal ring on the left side of the bag. Attach the "S" hook to the same ring after looping the strap around the driver's
ページ10に含まれる内容の要旨
strap to fasten the monitor in the pouch. Then loop the strap of the pouch around the headrest, and pull the loose end of the strap while holding the buckle until the pouch is tightly secured. f. If a second video monitor (optional) is used, remove the addi- tional monitor and pouch from the storage bag, making sure to feed the bottom piece of the pouch into the long slot of the moni- tor and attach the Velcro strap to fasten the monitor in the pouch. Then loop the strap of the pouch around t
ページ11に含まれる内容の要旨
2. ON THE SEAT BACK (Refer to Figure 8) Figure 7 a. Hang the bag onto the seat back by looping the shoulder strap of the bag around the headrest of the seat. b. Take one of the supplied straps from the storage bag, and con- nect the latch to the lower metal ring on the left side of the mounting bag. Attach the "S" hook to the same ring after loop- ing the strap around the seat rail. Repeat this process for the right side. In some vehicles, it may be necessary to attach the "S" connector to the
ページ12に含まれる内容の要旨
3. On the Back Seat a b Figure 8 a. The Monitor can be inserted into the slot with the screen facing either front (refer to Figure 8a) or rear (refer to Figure 8b). Care- fully place the system with the DVD facing up on the back seat. Guide the vehicles safety belt through the short strap sewn on the bottom of the mounting bag. Then secure and adjust the safety belt so that the unit is not free to move around. Finally uncover the attached monitor and adjust the screen for a de- sired viewing a
ページ13に含まれる内容の要旨
b. Refer to Figure 9. The monitor can be detached from the sys- tem by depressing the button below the screen with one hand and removing the monitor with the other (Refer to Figure 3). Slide the monitor into the monitor pouch, feed the bottom piece of the pouch into the long slot of the monitor, and attach the Velcro strap to fasten the monitor in the pouch. Then loop the strap of the pouch around the headrest, and pull the end of the strap while holding the buckle until the pouch is tightly s
ページ14に含まれる内容の要旨
F. POWER SUPPLY 1. Powering the system indoors (Refer to Figure 10) Figure 10 Take the AC to DC adapter from the storage bag. Plug one end of the AC to DC adapter into the DC 12V jack on the side of the main unit, then plug the other end into the 110V AC power receptacle. 2. POWERING THE SYSTEM IN THE VEHICLE (Refer to Figure 11) Figure 11 Take the cigarette lighter adapter from the storage bag. Plug one end into the DC 12V jack on the side of the main unit, then plug the other end into the ciga
ページ15に含まれる内容の要旨
3. POWERING THE DETACHED MONITOR INDOORS (Refer to Figure 12) Figure 12 The monitor can be detached from the system by depressing the button below the screen with one hand and removing the video monitor* with the other hand. *NOTE: During the Removal and Reinstallation of the Video Moni- tor, rotate the monitor and the monitor’s hinged base so that they are aligned in a straight line. The Video Monitor is inserted into the ° slot on the main unit at a 45 (refer to Figure 3 ). Take the AC to D
ページ16に含まれる内容の要旨
Take the cigarette lighter adapter from the storage bag, plug one end into the DC 12V jack on the side of the monitor, then plug the other end into the cigarette lighter socket. NOTE: When the monitor is combined with the main unit DC 12V power will be supplied from the main unit to the monitor, so there is no need for another power source to be connected to the DC 12V jack on the side of the monitor. *Optional Second Video Monitor Part #VBDV56 Figure 14 5. POWERING THE SYSTEM WITH MULTIPLE MO
ページ17に含まれる内容の要旨
2) Refer to Figure 15. In the vehicle, the cigarette lighter adapter can drive up to 3 monitors combined with the main unit and con- nected to the main unit with the DIN cable. *Optional Video Monitors Figure 15 14
ページ18に含まれる内容の要旨
G. CONTROLS, INDICATORS, AND CONNECTORS 1. UNIT VIEW (Refer to Figure 16) MONITOR RIGHT SIDE 1) Brightness UP/DOWN Thumbwheel 2) Volume UP/DOWN Thumbwheel 3) Headphone Input # 2 4) Headphone Input # 1 Right Side MAIN UNIT 5) REMOTE CONTROL SENSOR 6) MAIN POWER 7) VCP STOP/EJECT Button 8) VCP REWIND Button 9) VCP PLAY Button 10) VCP FAST FORWARD Button 11) DVD/AV and VCP SELECT Switch 12) DVD OPEN Button 13) DVD STOP Button 14) DVD PREVIOUS Button 15) DVD PLAY Button 16) DVD NEXT B
ページ19に含まれる内容の要旨
2. REMOTE CONTROL VIEW (Refer to Figure 17) 1) POWER Button 2) DISPLAY Button 3) DVD ANGLE Button 4) DVD SUBTITLE Button 5) DVD AUDIO Button 6) DVD ZOOM Button 7) DVD UP/DOWN/LEFT/RIGHT/ ENTER Buttons 8) DVD MENU Button 9) DVD Return Button 10) DVD A-B Button 11) DVD NEXT Button 12) DVD PREVIOUS Button 13) DVD REVERSE Button 14) DVD FORWARD Button 15) VCP EJECT Button * 16) VCP POWER Button 17) VCP PAUSE Button 18) VCP STOP Button 19) DVD NUMBER Button 20) DVD SETUP Button 21) DVD REPEAT Butt
ページ20に含まれる内容の要旨
H. PLAYING A DVD After connecting power to the unit, momentarily press the ‘Power’ button on the Main Unit, then press the ‘Power’ button on the side of the Monitor. Press the ‘OPEN’ button on the Main unit to open the DVD Player, insert a disc and close the DVD Player. The system will start playing automatically. If the ‘POWER’ button is pressed ‘ON’ when there is already a disc in the unit, the system will automatically start playback of the disc. 1. BASIC DVD OPERATION POWER............
