ページ1に含まれる内容の要旨
POWER CENTER
For Models R2060, R3060, R5010, R2020, R3020, R5020,
R6010, R6020, R1020, R1220
All models are suitable as service entrance equipment.
INSTALLATION AND OPERATING INSTRUCTIONS
Warning: Gen/Tran transfer switches should be installed by a professional electrician familiar with electrical wiring and codes, and experienced in working
with generators. Gen/Tran accepts no responsibility for accidents, damages or personal injury caused by incorrect installation. These tran
ページ2に含まれる内容の要旨
What is the Power Center? The PowerStay™ Power Center is a combined indoor/outdoor transfer switch and distribution panel. It can be used as service entrance equipment for 60 Amp, 100 Amp and 200 Amp services. In addition to being a transfer switch, the Power Center adds additional circuits for outdoor applications such as air conditioner compressors, sewage lift pumps, boat docks, outbuildings, garages, pump houses, barns and the like. The 200 amp series models will accommodate 12 sing
ページ3に含まれる内容の要旨
For “Hard-wired” Generator Connection: (Models R6010, R6020, R1020, R1220) 1. Follow steps 1 - 6 as described above. 2. Installer to determine size of conduit for bringing power from generator to the Power Center. KOs on bottom of Power Center should be used, although alternate entry is adequate when necessary. Watertight hubs should be used above live breaker terminals. NOTE: If a 2” KO is cut in the side of the Power Center enclosure, the dead front panel may need to be “notched”
ページ4に含まれる内容の要旨
Transferring from Generator Power to Utility Power: 1. On the Power Center, turn OFF Generator MAIN breaker and turn ON Utility MAIN breaker. On 200 amps Main breaker models, this will require sliding the interlock mechanism up with the left hand while turning ON the 200 amp circuit breaker. 2. Turn ON any branch circuit breakers in the Power Center and Main Load center that are OFF. 3. Shut down the generator, following the procedures in the generator Owner’s Manual. 4. Unplug the power
