ページ1に含まれる内容の要旨
®
EIP-5000
EIP-5000L
OWNER’S MANUAL
EIKI INDUSTRIAL CO., LTD.
ページ2に含まれる内容の要旨
IMPORTANT • For your assistance in reporting the loss or theft of Model No.: your Projector, please record the Model and Serial Numbers located on the bottom of the projector and retain this information. Serial No.: • Before recycling the packaging, please ensure that you have checked the contents of the carton thoroughly against the list of “Supplied accessories” on page 11. SPECIAL NOTE FOR USERS IN THE U.K. The mains lead of this product is fitted with a non-rewireable (moulded) plug incorpor
ページ3に含まれる内容の要旨
Before using the projector, please read this owner’s manual carefully. Introduction ENGLISH 1. WARRANTY This is to assure that you immediately receive the full benefit of the parts, service and labor warranty applicable to your purchase. 2. CONSUMER PRODUCT SAFETY ACT To ensure that you will promptly receive any safety notification of inspection, modification, or recall that EIKI may be required to give under the 1972 Consumer Product Safety Act, PLEASE READ CAREFULLY THE IMPORTANT “LIMITED WARR
ページ4に含まれる内容の要旨
WARNING: The cooling fan in this projector continues to run for about 90 seconds after the projector enters the standby mode. During normal operation, when putting the projector into standby mode always use the STANDBY-ON button on the projector or on the remote control. DURING NORMAL OPERATION, NEVER TURN THE PROJECTOR OFF BY DISCONNECTING THE POWER CORD. FAILURE TO OBSERVE THIS WILL RESULT IN PREMATURE LAMP FAILURE. PRODUCT DISPOSAL This projector utilizes tin-lead solder, and a pressurized la
ページ5に含まれる内容の要旨
How to Read This Owner’s Manual • • • • • In this owner’s manual, the illustrations and on-screen displays are simplified for explana- tion. This may differ from the actual on-screen display. Using the Menu Screen The menu can be operated to achieve two functions, adjustments and settings. (For setting the menu items, see pages 58 and 59. ) Mouse/ adjustment ENTER button button ('/"/\/|) MENU button Buttons used in this MENU button ENTER Buttons used in this button UNDO button operation operat
ページ6に含まれる内容の要旨
Contents Preparing Introduction How to Read This Owner’s Manual .............. 3 Using the Remote Control ........................... 17 Usable Range .................................................... 17 Contents.......................................................... 4 Inserting the Batteries ....................................... 17 How to Access the PDF Owner’s Manuals ....... 7 Using the Remote Control with a Signal Cable .. 18 IMPORTANT SAFEGUARDS .......................... 8 Switching
ページ7に含まれる内容の要旨
Using Basic Operation Adjusting the Volume ......................................... 46 Turning the Projector On/Off....................... 37 Turning Off the Sound Temporarily .................... 46 Image Projection .......................................... 38 Displaying an Enlarged Portion of an Image ....... 46 Shifting the Lens ................................................ 38 Freezing a Moving Image .................................. 47 Using the Adjustment Feet ........................
ページ8に含まれる内容の要旨
Contents Reference Appendix Maintenance ................................................. 93 Specifications ............................................. 104 Maintenance Indicators ............................... 94 Glossary ...................................................... 105 Regarding the Lamp .................................... 96 Index ............................................................ 106 Lamp ................................................................. 96 Caution Conc
ページ9に含まれる内容の要旨
How to Access the PDF Owner’s Manuals PDF owner’s manuals in several languages are included in the CD-ROM, so that you can ® ® work with the projector. To utilize these manuals, you need to install Adobe Reader on your ® ® computer (Windows or Macintosh ). ® ® Please download Adobe Reader from the Internet (http://www.adobe.com). Accessing the PDF manuals ® ® For Windows : For Macintosh : 1 Insert the CD-ROM in the CD-ROM drive. 1 Insert the CD-ROM in the CD-ROM drive. 2 Double click the “My Com
ページ10に含まれる内容の要旨
IMPORTANT SAFEGUARDS CAUTION: Please read all of these instructions before you operate this product and save these instructions for later use. Electrical energy can perform many useful functions. This product has been engineered and manufactured to assure your personal safety. BUT IMPROPER USE CAN RESULT IN POTENTIAL ELECTRICAL SHOCK OR FIRE HAZARDS. In order not to defeat the safeguards incorporated in this product, observe the following basic rules for its installation, use and servicing. 1. R
ページ11に含まれる内容の要旨
Ensure that you read the following safeguards when setting up your projector. Caution concerning the lamp unit The projector may be safely tilted to a ■ Potential hazard of glass particles if lamp rup- maximum angle of 9 degrees. tures. In case of lamp rupture, contact your ■ Placement should be within 9 degrees of nearest EIKI Authorized Dealer or Service horizontal. Center for replacement. See “Replacing the If you have application requiring tilt angle Lamp” on page 96. exceeding 9 degrees, pl
ページ12に含まれる内容の要旨
IMPORTANT SAFEGUARDS Do not block the intake and exhaust Using the projector in other countries vents. ■ The power supply voltage and the shape of 13 ■ Allow at least 11 /16 inches (30 cm) of space the plug may vary depending on the region between the exhaust vent and the nearest or country you are using the projector in. wall or obstruction. When using the projector overseas, make ■ Be sure that the intake vents and the exhaust sure you use an appropriate power cord for vent are not obstructed.
ページ13に含まれる内容の要旨
Accessories Supplied accessories Remote control Two R-6 batteries (“AA” size, UM/SUM-3, HP-7 or similar) Power cord* (1) (2) For U.S., Canada, etc. For Europe, except U.K. (6' (1.8 m)) (6' (1.8 m)) 9NK3090204900 9NK3090152700 * Use the power cord that corresponds to the wall outlet in your country. Remote mouse receiver RGB cable Cap for the standard zoom lens (5'3" (1.6 m)) (10' (3.0 m)) (Only supplied with EIP-5000) 9NK3790199300 9NK3080431000 Projector manual and QUICK GUIDE Owner’s manual (t
ページ14に含まれる内容の要旨
Accessories Optional lenses ■ Lens Projection distance for 100" screen size Fixed wide lens (× 0.8) AH-45201 5'4" (1.6 m) Wide-zoom lens (× 1.5 – 1.8) AH-45301 10' – 12' (3.0 m – 3.7 m) Standard zoom lens (× 1.8 – 2.2) AH-51401 12' – 14'8" (3.7 m – 4.5 m) (Standard equipment with EIP-5000) Tele-zoom lens (× 2.25 – 3.00) AH-45501 15' – 20' (4.6 m – 6.1 m) Tele-zoom lens (× 3.0 – 4.5) AH-45601 20' – 30' (6.1 m – 9.1 m) Tele-zoom lens (× 4.5 –7.0) AH-45701 30' – 46'8" (9.1 m – 14.2 m) No lens is at
ページ15に含まれる内容の要旨
Part Names and Functions Numbers in refer to the main pages in this owner’s manual where the topic is explained. Projector Top View Power indicator 14 14·94 Lamp indicator 1 STANDBY-ON button 37 14·94 Lamp indicator 2 For turning the power on or putting the projector Temperature warning 14·94 into standby mode. indicator 46 Volume buttons For adjusting the speaker ZOOM button 40 sound level. For adjusting the projected 45 INPUT 1, 2, 3 button image size. For switching input mode 1, 2 or 3
ページ16に含まれる内容の要旨
Part Names and Functions About the Indicators on the Projector Power indicator ... Green on Normal (Standby) ... Red on Normal (Power on) ... Green blinks The intake vent cover is open. (See page 93.) Lamp indicators 1, 2 ... Green on Normal ... Green blinks The lamp is warming up. ... Red on The lamp has been shut down abnormally or needs to be changed. (See pages 94 and 95.) Temperature warning indicator ... Off Normal ... Red blinks/on The internal temperature is abnormally high. (Se
ページ17に含まれる内容の要旨
Numbers in refer to the main pages in this owner’s manual where the topic is explained. Projector (Side View) Terminals Refer to “INPUT/OUTPUT Terminals and Connectable Main Equipment” on page 24. INPUT 1 terminal 27 INPUT 3 terminal 29 Terminal for computer RGB Terminal for DVI digital RGB and component signals. and digital component signals. AUDIO input (1) terminal 27 36 OUTPUT (FOR INPUT 1, 2) Audio input terminal for terminal INPUT 1. Output terminal for computer RGB and component sign
ページ18に含まれる内容の要旨
Part Names and Functions Numbers in refer to the main pages in this owner’s manual where the topic is explained. Remote Control FOCUS buttons 40 18 ADJ./MOUSE switch For bringing the projected image For switching the remote control into focus. modes. STANDBY-ON button 37 39 H & V LENS SHIFT button For turning the power on or putting For shifting the lens horizontally the projector into standby mode. and vertically. ZOOM buttons 40 For adjusting the projected MENU button 56 image size. For
ページ19に含まれる内容の要旨
Using the Remote Control Front View Remote control sensor Usable Range 30° The remote control can be used to control the projector within the ranges shown in the 30° illustration. Remote control signal transmitters 30° 23' (7 m) Note • The signal from the remote control can be re- Remote control flected off a screen for easy operation. How- ever, the effective distance of the signal may Rear View differ depending on the screen material. Remote control sensor 30° When using the remote control: •E
ページ20に含まれる内容の要旨
Using the Remote Control Using the Remote Control with a Signal Cable When the signals from the remote control cannot be reached due to the positioning of the projector, use a ø3.5 mm minijack cable to connect the remote control to the projector. Now you can control the projector with the remote control. Remote control Side view To WIRED REMOTE terminal To WIRED R/C JACK ø3.5 mm minijack cable (commercially available) Note • The wireless remote function is not possible when the ø3.5 mm minijack
