ページ1に含まれる内容の要旨
E
N
T
E
R
U
N
SOURCE AUTO ADJUST
SELECT
STATUS
/
ON STAND BY
POWER
E
M
C
A
N
C
E
L
USB PC-CARD
/
RGB MONITOR
AUDIO OUTPUT
AUDIO RGB INPUT 1
C CONTROL MOUSE REMO AUDIO RGB INPUT 2
OUT CONTR
INPU
S-VIDEO
L MONO R VIDEO
MultiSync MT1055/MT1050/MT850
LCD Projector
User’s Manual
English
E – 1
AC IN
ページ2に含まれる内容の要旨
IMPORTANT INFORMATION Precautions RADIACION LASER REMOTE Please read this manual carefully before using your NEC MultiSync CAUTION NO MIRE AL RAYO CONTROL PRODUCTO LASER CLASSE2 MODEL: MT1055/MT1050/MT850 Projector and keep the manual handy for fu- LASER RADIATION- RD-367E LASER-STRAHLUNG DO NOT STATE INTO BEAM ture reference. 7N900011 NICHT IN DEN STRAHL WAVE LENGTH: 650nm BLICKEN ! LASER KLASSE2 Your serial number is located under the name plate label on the left MAX. OUTPUT: 1mW RAYONNEMENT L
ページ3に含まれる内容の要旨
Important Safeguards Lamp Replacement These safety instructions are to ensure the long life of your projector • To replace the lamp, follow all instructions provided on page E-47. and to prevent fire and shock. Please read them carefully and heed all • Be sure to replace the lamp when the message "The Lamp has warnings. reached the end of its usable life. Please replace the lamp." appears. If you continue to use the lamp after the lamp has reached the end of its usable life, the lamp bulb may sh
ページ4に含まれる内容の要旨
TABLE OF CONTENTS Source Display .............................................................. E-35 1. INTRODUCTION Direct Button (Volume Bar and Keystone Bar) .............. E-35 Introduction to the MultiSync MT1055/MT1050/MT850 Projector .......... E-5 Menu Display Time ........................................................ E-35 Getting Started ............................................................................. E-5 Setup ............................................................
ページ5に含まれる内容の要旨
1. INTRODUCTION 1 * Do not attempt to mount the projector on a ceiling yourself. The pro- Introduction to the MultiSync MT1055/MT1050/ jector must be installed by qualified technicians in order to ensure MT850 Projector proper operation and reduce the risk of bodily injury. In addition, the This section introduces you to your new MultiSync MT1055 and MT1050 ceiling must be strong enough to support the projector and the in- (XGA)/ MT850 (SVGA) Projector and describes the features and con- stalla
ページ6に含まれる内容の要旨
E N T E R U N SOURCE AUTO ADJUST SELECT STATUS ON/STAND BY POWER E M C A N C E L RGB MONITOR AUDIO OUTPUT USB PC-CARD AUDIO RGB INPUT 1 AUDIO RGB INPUT 2 C CONTROL MOUSE REMO OUT CONTR INPU S-VIDEO L/MONO R VIDEO OFF ON VIDEO S-VIDEO AUTO ADJ. RGB 1 RGB 2 PJ MENU LASER - + R-CLICK /CANCEL HELP POINTER PC CARD KEYSTONE MAGNIFY SLIDE FREEZE VOL. FOLDER - PIC MUTE SLIDE LIST Quick Connect Guide User's Manual What's in the Box? Make sure your box contains everything listed. If any pieces are missi
ページ7に含まれる内容の要旨
E N T E R U N SOURCE AUTO ADJUST SELECT STATUS ON/STAND BY POWER E M C A N C E L RGB MONITOR AUDIO OUTPUT USB PC-CARD AUDIO RGB INPUT 1 C CONTROL MOUSE REMO AUDIO RGB INPUT 2 OUT CONTR INPU S-VIDEO L/MONO R VIDEO Getting to Know Your MultiSync MT1055/MT1050/MT850 Projector Front/Side Features Remote Sensor Zoom Controls Focus USB (Mouse) Terminal Remote Sensor Air-Filter Lenscap PC Card Slot Slot for Kensington Micro saver Security System Air Filter AC Input Connect the supplied power cable’s
ページ8に含まれる内容の要旨
E N T E R U N Top Features 1 2 SOURCE AUTO ADJUST 3 4 SELECT 6 5 7 9 STATUS ON/STAND BY POWER 8 1. Source Button 6. Cancel Button Use this button to select a video source such as a PC, VCR, DVD Press this button to exit "Menus". Press this button to return the adjust- player or PC Card Viewer (PC card). ments to the last condition while you are in the adjustment or setting Each time this button is pressed, the input source will change as fol- menu. lows: → RGB1 → RGB2 → Video → S-Video → PC Card
ページ9に含まれる内容の要旨
U N RCE AUTO ADJUST E M PC-CARD USB C CONTROL MOUSE REMO OUTPUT CONTR INPU Terminal Panel Features RGB MONITOR AUDIO OUTPUT 12 3 8 AUDIO RGB INPUT 1 USB 9 4 AUDIO RGB INPUT 2 MOUSE REMOTE PC CONTROL OUTPUT CONTROL 10 INPUT 6 S-VIDEO / L MONO R VIDEO 5 7 11 12 13 1. USB Terminal Connect a commercially available mouse that supports USB. You can operate the menu or PC Card Viewer with the USB mouse via this terminal. Note that this terminal is not used with a computer and that there may be some bra
ページ10に含まれる内容の要旨
3. LED Remote Control Features Flashes when any button is pressed. NOTE: If you are using a Macintosh computer, you can click either the right- click or left-click button to activate the mouse. 4. Power On Button If the main power is applied, you can use this button to turn your pro- NOTE: If any one of the buttons is pressed and held for 60 seconds or more, jector on. the button operations will cease to operate. This is not a malfunction, rather it is a feature used to prolong battery power. To
ページ11に含まれる内容の要旨
EL PC CARD MAGNIFY SLIDE FREEZE VOL. FOLDER PIC-MUTE SLIDE LIST 15. Enter / Left Click Button 16. Cancel/ Right Click Button When you are in the Computer mode, this button works as the mouse When you are in the Computer mode, this button works as the mouse left button. right button. When you are in the Projector mode, which is indicated by lighting the When you are in the Projector mode, which is indicated by lighting the PJ button: PJ button: Use this button to enter your menu selection. It wor
ページ12に含まれる内容の要旨
Remote Control Battery Installation Operating Range 1. Press firmly and slide the battery cover off. 7m 2. Remove both old batteries and install new ones (AA). Ensure that you have the batteries' polarity (+/–) aligned correctly. Remote Control Precautions • Handle the remote control carefully. • If the remote control gets wet, wipe it dry immediately. • Avoid excessive heat and humidity. 3. Slip the cover back over the batteries until it snaps into place. • If you will not be using the remote c
ページ13に含まれる内容の要旨
Switching operation mode between mouse and projector The three shaded buttons shown on the drawing work as a computer mouse in the Computer mode. In the Computer mode the PJ button is not lit. • When the MENU button is pressed, the PJ button lights red to indicate that you are in the Projector mode, which allows the projector menu operation using the three buttons. • When the POINTER button is pressed, the PJ button lights red to indicate that you are in the Projector mode and that the MOUSE
ページ14に含まれる内容の要旨
AC IN USB AC IN 2. INSTALLATION This section describes how to set up your MultiSync MT1055/MT1050/ Selecting a Location MT850 projector and how to connect video and audio sources. The further your projector is from the screen or wall, the larger the image. The minimum size the image can be is approximately 30" (0.76 Setting up Your Projector m) measured diagonally when the projector is roughly 4 feet (1.3 m) Your MultiSync MT1055/MT1050/MT850 Projector is simple to set up from the wall or screen
ページ15に含まれる内容の要旨
E L L AC IN AC IN Adjusting the Tilt Foot Press and hold the Tilt button on the left side of the projector. Lift the front edge of the projector to the height you want, and release the button to lock the Adjustable Tilt Foot. To fine-tune the image’s position vertically on the screen, rotate the foot. Each of the rear feet height can be changed up to 0.6” (4mm). E – 15 E E N N T T E E R R U U N N SOURCE AUTO ADJUST SELECT STATUS ON/OFF POWER SOURCE AUTO ADJUST SELECT STATUS ON/OFF POWER E E M M
ページ16に含まれる内容の要旨
Distance Chart Throwing Distance (C) Screen top Screen center B Throwing Angle (α) Lens Center 2.9” (79.5mm) D Projector Foot Screen Bottom B=Vertical distance between lens center and screen center C=Throw distance D=Vertical distance between lens center and screen bottom (screen top for ceiling installation) Ceiling Installation Screen top Projector Foot D 2.9” (79.5mm) Lens Center Throwing Angle (α) B Screen center Screen Bottom Throwing Distance (C) If your projector is mounted on the ceiling
ページ17に含まれる内容の要旨
MT1055 Screen Size B C D α Diagonal Width Height wide telephoto wide telephoto 40 inch 32 inch 24 inch 10.2 inch 56.3 inch – 68.6 inch 1.8 inch 10.3 degree – 8.5 degree 1016 mm 812.8 mm 609.6 mm 259.5 mm 1430.3 mm 1743.7 mm 45.3 mm 60 inch 48 inch 36 inch 15.3 inch 86.1 inch – 104.3 inch 2.7 inch 10.1 degree – 8.4 degree 1524 mm 1219.2 mm 914.4 mm 389.2 mm 2185.8 mm 2649.9 mm 68.0 mm 67 inch 53.6 inch 40.2 inch 17.1 inch 96.5 inch – 116.8 inch 3.0 inch 10.1 degree – 8.3 degree 1701.8 mm 1361.44
ページ18に含まれる内容の要旨
Monitor Wiring Diagram Supplied mouse adapter Macintosh or Compatibles Supplied serial cable (For Macintosh or USB) (Desktop type or notebook type) MOUSE REMOTE PC CONTROL OUTPUT CONTROL INPUT Supplied mouse adapter IBM VGA or Compatibles (For IBM PS/2 or USB) RGB MONITOR (Desktop type or notebook type) AUDIO OUTPUT AUDIO RGB INPUT 1 Signal cable (supplied) AUDIO RGB INPUT 2 To mini D-Sub 15-pin connector on the projector. It is recommended that you use a commercially available distribu- tion am
ページ19に含まれる内容の要旨
E N T E R U N SOURCE AUTO ADJUST SELECT STATUS ON/STAND BY POWER E M C A N C E L RGB MONITOR AUDIO RGB MONITOR AUDIO OUTPUT OUTPUT USB PC-CARD AUDIO RGB INPUT 1 AUDIO RGB INPUT 2 C CONTROL MOO UU ST E R C E O M N O TR INPU S-VIDEO / RGB INPUT L MONO R VIDEO AUDIO AUDIO RGB INPUT 1 AUDIO RGB INPUT 2 S-VIDEO / L MONO R VIDEO Connecting Your PC IBM VGA or Compatibles (Notebook type) RGB signal cable (supplied) To mini D-Sub 15-pin connector on the projector. It is recommended that you use a co
ページ20に含まれる内容の要旨
E N T E R U N SOURCE AUTO ADJUST SELECT STATUS ON/STAND BY POWER E M C A N C E L RGB MONITOR AUDIO RGB MONITOR AUDIO OUTPUT OUTPUT USB PC-CARD AUDIO RGB INPUT 1 AUDIO RGB INPUT 2 C CONTROL MOO UU ST E R C E O M N O TR INPU S-VIDEO L/ MONO R VIDEO RGB INPUT AUDIO AUDIO RGB INPUT 1 AUDIO RGB INPUT 2 S-VIDEO / L MONO R VIDEO Connecting Your Macintosh Computer Macintosh (Notebook type) RGB Signal cable (supplied) Audio cable (not supplied) Macintosh (Desktop type) The new Macintosh computer suc
