ページ1に含まれる内容の要旨
English
Owner’s Manual
Video Projector
TDP-MT700
ページ2に含まれる内容の要旨
SAFETY PRECAUTION The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the pres- ence of important operating and maintenance (servicing) instructions in the literature accom- panying the applia
ページ3に含まれる内容の要旨
English IMPORTANT SAFETY INSTRUCTIONS CAUTION: PLEASE READ AND OBSERVE ALL WARNINGS AND INSTRUCTIONS GIVEN IN THIS OWNER'S MANUAL AND THOSE MARKED ON THE UNIT. RETAIN THIS BOOKLET FOR FUTURE REFERENCE. This set has been designed and manufactured to assure personal safety. Improper use can result in elec- tric shock or fire hazard. The safeguards incorporated in this unit will protect you if you observe the follow- ing procedures for installation, use and servicing. This unit is fully transisto
ページ4に含まれる内容の要旨
7. Water and Moisture 12. Lightning storms Do not use this product near water. For added protection for this product during - for example, near a bath tub, wash bowl, storm, or when it is left unattended and kitchen sink, or laundry tub; in a wet base- unused for long periods of time, unplug it from ment; or near a swimming pool and the like. the wall outlet. This will prevent damage to the product due to lightning and power-line surges. However, while it is thundering or light- ning, do not t
ページ5に含まれる内容の要旨
English 16. Stack Inhibited 20. Damage Requiring Service Do not stack other equipment on this product Unplug this product from the wall outlet and or do not place this product on the other refer servicing to qualified service personnel equipment. Top and bottom plates of this under the following conditions: product develops heat and may give some a) When the power-supply cord or plug is dam- undesirable damage to other unit. aged. b) If liquid has been spilled, or objects have fallen into the p
ページ6に含まれる内容の要旨
POWER SUPPLY CORD SELECTION If your line voltage is 220 to 240V, use one of the following types of cable. Plug Plug type Line Plug Plug type Line configuration voltage configuration voltage EURO 220 - 240V Australian 200 - 240V 240V 10A UK 220 - 240V Switzerland 200 - 240V 240V 6A Use a 5A fuse which is approved by ASTA North 200 - 240V or BSI to BSI362. American Always replace the fuse cover after 240V changing the fuse. 15A IMPORTANT PRECAUTIONS Save Original Packing Materials The original sh
ページ7に含まれる内容の要旨
English IMPORTANT PRECAUTIONS (Continued) Avoid Volatile Liquid Do not use volatile liquids, such as an insect spray, near the unit. Do not leave rubber or plastic prod- ucts touching the unit for a long time. They will leave marks on the finish. If cleaning with a chemically saturated cloth, be sure to follow the product's precautions. In the spaces provided below, record the Model and Serial No. located at the bottom of your projec- tor. Model No. Serial No. Retain this information for future
ページ8に含まれる内容の要旨
OTHER CAUTIONS AND INFORMATION Copyrights Showing or transmitting commercial imaging software or broadcast or cable-broad casting programs with the purpose of other than the personal and private viewing, including modifying images using the freeze or resize functions, or displaying with the varying aspect ratio of the images, could violate the direct or indirect copyrights of the imaging software or broadcast program, etc., if done without first consulting with the copyright holder. For this rea
ページ9に含まれる内容の要旨
English CONTENTS SAFETY PRECAUTION ..............................................................................2 IMPORTANT SAFETY INSTRUCTIONS .....................................................3 POWER SUPPLY CORD SELECTION .......................................................6 IMPORTANT PRECAUTIONS .....................................................................6 EXEMPTION CLAUSES ..............................................................................7 OTHER CAUTIONS AND INFOR
ページ10に含まれる内容の要旨
Picture menu ....................................................................................... 26 Display menu ...................................................................................... 27 Options menu ...................................................................................... 28 Setup menu ......................................................................................... 28 Advanced menu ........................................................................
ページ11に含まれる内容の要旨
MENU + - English Overview Shipping contents The projector is shipped with the cables required for connection to a video and PC equipment. Some of the items may not be available depending on the region. Please check with your place of pur- chase. Some of the accessories may vary from country to country. Projector User’s manual Power cord Remote control Batteries Optional accessories 1. HDMI cable 2. Ceiling mounting kit Installing or replacing batteries Push on the cover and slide it to open. I
ページ12に含まれる内容の要旨
Projector exterior view Front / Upper side 1. Ventilation holes (exhaust) 2. Control panel p.13 2 3. Focus ring and zoom ring 4. Projection lens 1 3 5. Front IR sensor 4 5 Rear side 6. Connector panel (See below.) 7. Main AC power switch HDM1 S-VIDEO VIDEO COMPONENT 1 6 8. Power cord socket PR / CR PB / CB CONTROL COMPONENT 2 / GBR VD HD PR/R PB/B Y/G 7 8 Bottom and left sides 9 9 11 10 9. Front adjuster feet 10. Ceiling mounting holes 11. Kensington lock slot 10 Connector panel 12. Rear IR sen
ページ13に含まれる内容の要旨
English Controls and functions Control panel 5. MENU Turns the on-screen display control menu on. Exits and saves the menu settings. 6 6. Focus Ring p.21 7 Adjusts the focus of the projected image. 7. Zoom Ring p.21 Adjusts the size of the projected image 8 8. Temperature warning light p.32 Lights up or flashes red if the projector’s 1 9 2 temperature becomes too high. 3 3 9. LAMP indicator light p.32 10 Indicates the status of lamp. Lights up or flashes red when the lamp has 4 11 develope
ページ14に含まれる内容の要旨
The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting. In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation. Due to some functions are not available for certain input signals, an icon will appear on the screen when the button press is not effective. 1. ON/STANDBY p. 20, , p. 24 p. 32 Press and hold th
ページ15に含まれる内容の要旨
English Positioning your projector Choosing a location Your projector is designed to be installed in one of four possible installation locations: 1. Floor in front of screen (Standard); 2. Ceiling in front of screen (Ceiling); 3. Floor at rear of screen (Rear); or 4. Ceiling at rear of screen (Rear Ceiling). Your room layout or personal preference will dictate which installation location you select. Take into consideration the size and position of your screen, the location of a suitable po
ページ16に含まれる内容の要旨
Obtaining a preferred projected image size The distance from the projector lens to the screen, the zoom setting, and the video format each fac- tors in the projected image size. Separate tables of dimensions for both 16:9 and 4:3 screen ratios below have been provided to assist you in determining the ideal location for your projector. 1. Determine the aspect ratio of your screen, (16:9 or 4:3)? 2. Select the Screen Size you desire from the 16:9 ratio screen dimension table or 4:3 ratio screen
ページ17に含まれる内容の要旨
English Installation for a 4:3 ratio screen Ceiling Installation Floor Installation Ceiling Type Image Height Type Height Offset Projection Distance Screen Center of the lens Center of the lens Projection Distance Screen Height Offset Image Height Floor 4:3 (standard) ratio screen dimension table: Screen Size Projection Height Offset Image Distance Height (inch) / Type Height Width Min. Max. Tele Wide (inch) / (inch) / (inch) / (inch) / (inch) / (inch) / (inch) / (cm) (cm) (cm) (cm) (cm) (
ページ18に含まれる内容の要旨
Connecting various equipment You can connect the projector to any type of video equipment, such as a VCR, DVD player, digital tuner, cable or satellite box, video game console or digital camera. You can also connect it to a desk- top or laptop PC or Apple Macintosh system. The projector can connect multiple video equipment at the same time by using different cables. Make sure you select right signal input to display. When connecting any signal source to the projector, be sure to: 1. Turn off
ページ19に含まれる内容の要旨
English Connecting S-video or video devices From audio output To audio input terminals terminals S-Video cable Video cable Connecting a computer Connect the projector to a computer with a VGA-BNC cable. Laptop or desktop computer From audio output To audio input terminals terminals VGA-BNC cable If the selected video image is not displayed after the projector is turned on and the correct video source has been selected, please check that the video source is turned on and operating correctly.
ページ20に含まれる内容の要旨
Using the projector and remote control Preparations 1. Turn all of the connected equipment on. 3. Plug the supplied power cord into the AC inlet on 2. Remove the lens cap. the rear of the projector and turn the main AC power switch on. 4. Plug the power cord into a wall socket and turn the wall switch on. Turning the power on Follow the steps below. 1. Make sure the Power light is orange after power has been applied and the main AC power switch is turned on. 2. Press and hold the ON/STANDB
