ページ1に含まれる内容の要旨
INSTALLATION INSTRUCTIONS
30" (76.2 CM) FREESTANDING GAS RANGES
with standard clean oven
INSTRUCTIONS D’INSTALLATION DES CUISINIÈRES À GAZ
AUTOPORTANTES DE 30" (76,2 CM)
avec four à nettoyage standard
Table of Contents/Table des matières
RANGE SAFETY..............................................................................2 SÉCURITÉ DE LA CUISINIÈRE .................................................. 17
INSTALLATION REQUIREMENTS ................................................3 EXIGENCES D’I
ページ2に含まれる内容の要旨
RANGE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.” These words mean: You can be killed or seriously injured if you don't immediately DANG
ページ3に含まれる内容の要旨
In the State of Massachusetts, the following installation instructions apply: ■ Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the State of Massachusetts. ■ If using a ball valve, it shall be a T-handle type. ■ A flexible gas connector, when used, must not exceed 3 feet. WARNING Tip Over Hazard A child or adult can tip the range and be killed. Install anti-tip bracket to floor or wall per installation instruct
ページ4に含まれる内容の要旨
Location Requirements IMPORTANT: Observe all governing codes and ordinances. Do Mobile Home - Additional Installation Requirements not obstruct flow of combustion and ventilation air. The installation of this range must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 ■ It is the installer’s responsibility to comply with installation (formerly the Federal Standard for Mobile Home Construction clearances specified on the model/serial rating plate. T
ページ5に含まれる内容の要旨
Cabinet Dimensions Electrical Requirements Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" WARNING (91.4 cm) countertop height. If the cabinet depth is greater than 24" (61.0 cm), oven frame must extend beyond cabinet fronts by ½" (1.3 cm) minimum. IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional
ページ6に含まれる内容の要旨
Gas Supply Requirements Flexible metal appliance connector: WARNING ■ If local codes permit, a new CSA design-certified, 4 to 5 ft (122 to 152.4 cm) long, ½" (1.3 cm) or ¾" (1.9 cm) I.D., flexible metal appliance connector may be used for connecting range to the gas supply line. ■ A ½" (1.3 cm) male pipe thread is needed for connection Explosion Hazard to the female pipe threads of the inlet to the appliance Use a new CSA International approved gas supply line. pressure regulator. ■ Do no
ページ7に含まれる内容の要旨
Line pressure testing above ½ psi gauge (14" WCP) Burner Input Requirements The range and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of Input ratings shown on the model/serial rating plate are for that system at test pressures in excess of ½ psi (3.5 kPa). elevations up to 2,000 ft (609.6 m). Line pressure testing at ½ psi gauge (14" WCP) or lower For elevations above 2,000 ft (609.6 m), ratings are reduced at a The range
ページ8に含まれる内容の要旨
3. Determine and mark centerline of the cutout space. The mounting can be installed on either the left side or right side Make Gas Connection of the cutout. Position mounting bracket against the wall in the cutout so that the V-notch of the bracket is 12⁵³⁄₆₄" (32.6 cm) from centerline as shown. WARNING B Centerline A Explosion Hazard Use a new CSA International approved gas supply line. Install a shut-off valve. Securely tighten all gas connections. If connected to LP, have a qualified pers
ページ9に含まれる内容の要旨
3. Use a combination wrench and pliers to attach the flexible 4. Test all connections by brushing on an approved connector to the adapters. Check that connector is not noncorrosive leak-detection solution. Bubbles will show a kinked. leak. Correct any leak found. 5. Remove cooktop burner caps and grates from parts package. Align notches in burner caps with pins in burner A base. Burner caps should be level when properly positioned. B If burner caps are not properly positioned, surface burne
ページ10に含まれる内容の要旨
IMPORTANT: If there is a snapping or popping sound when lifting the range, the range may not be fully engaged in the bracket. Check Operation of Cooktop Burners Check to see if there are obstructions keeping the range from sliding to the wall or keeping the range foot from sliding into the 1. If control panel and knobs were removed earlier, reinstall bracket. Verify that the bracket is held securely in place by the knobs. mounting screws. 2. Push in and turn each surface unit control knob t
ページ11に含まれる内容の要旨
3. Locate the air shutter near the rear wall of oven and loosen Check Operation of Oven/Broil Burner the shutter screw. 1. Open broiler door. A 2. Press in and turn the oven control knob to 350°F. B A. Shutter screw B. Air shutter 4. Adjust the air shutter. 5. Turn the oven back on and check for proper flame. If the flame is still not properly adjusted, turn the oven off, wait for the oven burner to cool down and repeat Step 4 until flame is properly adjusted. ■ The oven pilot should now b
ページ12に含まれる内容の要旨
GAS CONVERSIONS Gas conversions from Natural gas to LP gas or from LP gas to Natural gas must be done by a qualified installer. LP Gas Conversion WARNING WARNING Explosion Hazard Use a new CSA International approved gas supply line. Tip Over Hazard Install a shut-off valve. A child or adult can tip the range and be killed. Securely tighten all gas connections. Install anti-tip bracket to floor or wall per installation If connected to LP, have a qualified person make sure instructions. gas pre
ページ13に含まれる内容の要旨
4. Remove the cap from the gas pressure regulator using a 4. Install LP gas orifice spuds using a 7 mm combination flat-blade screwdriver. wrench. NOTE: Make sure sealing washer remains in the same position. A A A. Cap 5. To convert to LP gas, unscrew the plastic adjustment screw by hand, turn it over, and screw it in again. B Inlet pressure Inlet pressure to Natural gas to LP gas A. Spud A B. Holder B NOTE: Depending on model, the range cooktop may be equipped with 4 standard burners or 3
ページ14に含まれる内容の要旨
To Convert Oven Burner Natural Gas Conversion 1. Open the oven door and remove oven racks, oven tray and flame spreader and set aside. WARNING 2. Lift oven burner. The orifice spud is behind the oven burner air shutter. Tip Over Hazard A B A child or adult can tip the range and be killed. A. Oven burner Install anti-tip bracket to floor or wall per installation B. Air shutter instructions. 3. Locate LP gas orifice spud stamped “56” in the package Slide range back so rear range foot is engage
ページ15に含まれる内容の要旨
4. Remove the cap from the gas pressure regulator using a flat- 4. Install the Natural gas orifice spuds using a 7 mm blade screwdriver. combination wrench. NOTE: Make sure sealing washer remains in the same position. A A A. Cap 5. To convert to Natural gas, unscrew the plastic adjustment B screw by hand, turn it over, and screw it in again. Inlet pressure Inlet pressure to LP gas to Natural gas A. Spud B. Holder A B NOTE: Depending on model, the range cooktop may be C equipped with 4 stan
ページ16に含まれる内容の要旨
6. Place LP gas oven burner spud in plastic parts bag along To Convert Oven Burner with LP gas cooktop burner spuds for future use and keep with the bag containing literature. 1. Open the oven door and remove oven racks, oven tray, and 7. Reinstall oven burner. flame spreader and set aside. 8. Reinstall oven racks, oven tray and flame spreader. 2. Lift oven burner. The orifice spud is behind the oven burner air shutter. Complete Conversion 1. Refer to the “Make Gas Connection” section for pr
ページ17に含まれる内容の要旨
SÉCURITÉ DE LA CUISINIÈRE Votre sécurité et celle des autres est très importante. Nous donnons de nombreux messages de sécurité importants dans ce manuel et sur votre appareil ménager. Assurez-vous de toujours lire tous les messages de sécurité et de vous y conformer. Voici le symbole d’alerte de sécurité. Ce symbole d’alerte de sécurité vous signale les dangers potentiels de décès et de blessures graves à vous et à d’autres. Tous les messages de sécurité suivront le symbole d’alerte de sécur
ページ18に含まれる内容の要旨
Dans l’État du Massachusetts, les instructions d’installation suivantes sont applicables : ■ Les travaux d’installation et réparation doivent être exécutés par un plombier ou tuyauteur qualifié ou licencié, ou par le personnel qualifié d’une entreprise licenciée par l’État du Massachusetts. ■ Si une vanne à boisseau sphérique est utilisée, elle doit comporter une manette “T”. ■ Si un conduit de raccordement flexible est utilisé, sa longueur ne doit pas dépasser 3 pi. AVERTISSEMENT Risque de
ページ19に含まれる内容の要旨
Pièces nécessaires Résidence mobile – Spécifications additionnelles à respecter lors de l'installation Vérifier les codes locaux et consulter le fournisseur de gaz. Vérifier l'alimentation en gaz et l'alimentation électrique L'installation de cette cuisinière doit être conforme aux existantes. Voir les sections “Spécifications électriques” et dispositions de la norme Manufactured Home Construction and “Spécifications de l'alimentation en gaz”. Safety Standard, Title 24 CFR, Part 3280 (ancien
ページ20に含まれる内容の要旨
Spécifications électriques D B C AVERTISSEMENT A E H G Risque de choc électrique Brancher sur une prise à 3 alvéoles reliée à la terre. Ne pas enlever la broche de liaison à la terre. J I Ne pas utiliser un adaptateur. Ne pas utiliser un câble de rallonge. F K Le non-respect de ces instructions peut causer M un décès, un incendie ou un choc électrique. L N L IMPORTANT : La cuisinière doit être électriquement reliée à la terre conformément aux prescriptions des codes et règlements locaux; en l
