Woodstock International, Inc.d3012-3016の取扱説明書

ページ1に含まれる内容の要旨

Model D3012–D3016
Wood Clamp Hardware Kit
Instruction Sheet
Phone #: (360) 734-3482 • Online Tech Support: tech-support@shopfox.biz • Web: www.shopfox.biz
Introduction
The Shop Fox Wood Clamp Hardware Kit provides
all the necessary hardware to make your own
wood clamp. Wood clamps are very handy during
many woodworking applications. Wood jaws are
non-marring and eliminate the need for pads, and
two wood clamps can work together for a quick
and easy bench vise. The jaws of the clamp should

ページ2に含まれる内容の要旨

D3012–D3016 Wood Clamp Hardware Kit Instructions Sizing Information The dimensions below are based on standard wood hand-screw clamps for each size kit. The jaws can be created according to these dimensions or customized to your own needs. Due to the custom nature of the kit, the overall size and shape of the clamp can vary significantly. Keep in mind, however, that the clamping capability is determined by the hardware included, so you should adhere to the basic overall dimensions to avoid c

ページ3に含まれる内容の要旨

D3012–D3016 Wood Clamp Hardware Kit Instructions Construction and Assembly Once you have determined the material you will use and the size and shape of your clamp jaws, Drill Holes for you are ready to begin construction and assembly. Threaded Rods (Aligned with To construct and assemble the clamps, do these Dowel Nut Holes) steps: 1. Use the drawing and dimensions from Figure (x2) 2 or your own design to cut out the shape of the clamp jaws. Sand all edges to reduce splinters and workpie

ページ4に含まれる内容の要旨

D3012–D3016 Wood Clamp Hardware Kit Instructions 5. Insert the four dowel nuts into the holes drilled in Step 2, making sure the left-hand threaded dowel nuts go into the positions shown in Figure 6. Drill Holes for Standard Handle Pins (Right-Hand) Threaded Dowel Nuts Reverse Figure 8. Drilling holes for handle pins. (Left-Hand) Threaded 8. Insert a handle pin through each handle and Dowel Nuts threaded rod, support the head of the pin Figure 6. Inserting dowel nuts. from beneath, then us