ページ1に含まれる内容の要旨
®
REMOTE CONTROL
SIGNAL SENDER
®
Use RCA DSS Remote
to control RCA Brand DSS
Receiver from any TV
(Requires TVs
to be prewired to
DSS System Signal).
TABLE OF CONTENTS
Operating Precautions ..........2
System Contents ....................4
System Set-Up
Extension Unit....................5
Base Unit ..........................6
Infrared Extender ..............7
Trouble Shooting ..................8
DSS System Signal Splitting....9
DSS Accessories..................10
Warranty....................
ページ2に含まれる内容の要旨
Operating Precautions When using your Remote Control Signal Sender as with any other electri- cal device, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 4. Do
ページ3に含まれる内容の要旨
Operating Precautions 8. Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: A. When the plug is damaged. B. If liquid has been spilled into the product. C. The product has been exposed to rain or water D.If the product does not operate normally by following the operating instructions. E. If the product has been dropped or the cabinet has been damaged. F. If the product exhibits a distinct change in performance. • No repa
ページ4に含まれる内容の要旨
System Contents Your D940 Remote Control Signal Sender consists of two units (Extension Unit and Base Unit) and an infrared extender. Extension Unit The Extension Unit senses the Infrared signals from your remote control and an LED lights to indicate that signals are being detected. The Extension Unit converts the remote con- trol signals into radio frequency transmissions for communication with the Base Unit. Base Unit The Base Unit has an antenna, power cord, and a jack for the Infrared Extend
ページ5に含まれる内容の要旨
Extension Unit Set-Up Where to Use Use in the room where you want to use your remote control (example: use in the additional ® room wired to receive DSS System signal). How to Install 1.Plug the Extension Unit into a standard electrical outlet. 2.Place the logo side of the Extension Unit facing you. It can be placed up to 18 feet from where you will be using the remote control. 5
ページ6に含まれる内容の要旨
Base Unit Set-Up Where to Use. ® Use in the room where the DSS Receiver is located. How to Set-Up 1.Plug the Base Unit power cord into standard electrical outlet. 2.Point the front of the Unit (logo side) facing the DSS Receiver. Extend the antenna for best performance. 3.Check the following distances • Base Unit is within 20 feet of DSS Receiver. • Base Unit is within 100 feet of Extension Unit. After setting up your Extension and Base Units, operate the Signal Sender by aiming your remote a
ページ7に含まれる内容の要旨
Infrared Extender Set-Up Where to Use • Use when Base Unit cannot be easily ® placed in front of the DSS Receiver. (Example: when DSS Receiver and Base Unit are located in a closed cabinet). • Use when you would prefer to conceal the Base Unit in a cabinet or behind furniture. How To Use 1.Plug the Infrared Extender into back of Base Unit. 2.Place the Infrared Diode (located on the opposite end of the extension cord) in clear view of DSS Receiver to enable signal transmission. Example of App
ページ8に含まれる内容の要旨
Troubleshooting 1. Make sure both units are plugged into a standard electrical outlet. 2. If the red light inside the Extension Unit does not light when the Remote Control is operated: • Make sure you are pointing at the front of the Extension Unit (the RCA logo is on the front). • Make sure you are within 18 feet of the front of the Extension Unit. • Make sure nothing is blocking the path between the remote and the Extension Unit. ® 3. If your DSS Receiver does not respond but the red light in
ページ9に含まれる内容の要旨
® DSS Signal Splitting OPTION 1. (Refer to above diagram) ® 1 . Hook up the DSS Receiver as directed in the DSS receiver instructions. 2. Connect DSS Receiver to your TV1 with a cable from the A/V OUTPUT on the DSS Receiver to the A/V INPUT on TV1. 3.Connect DSS Receiver to TV2 with a cable from OUT to TV to an A/B switch at TV2. OPTION 2. ® 1. Hook up the DSS Receiver as directed in the DSS Receiver instructions. 2. Use one of the following DSS System Signal Combiners to split the “Out
ページ10に含まれる内容の要旨
® DSS Accessories To purchase these accessories, contact your local dealer. If no dealer is available, call the toll free number listed on next page and order by phone (please allow 2–4 weeks for delivery). D900 Universal Remote Controls Muti-Brand TVs VCRs, Cable Boxes, Laser Disc ® Players, and the RCA DSS Receiver. Add a DSS system remote to every Signal Sender Extension Unit. D935 DSS Signal Sender Extension Unit Use with your Base Unit to control your DSS system receiver from additional
ページ11に含まれる内容の要旨
® DSS Accessories Description Model # Price Qty. Total DSS Universal Remote D900 $29.95 Extension Unit D935 $29.95 A/B Switch VH74 $9.95 Splitter Combiner D2271 $24.95 D2471 $29.95 Sales Tax We are required by law to collect the appropriate sales tax for each individual sale, county, and locality to which the merchandise is being sent. Total Merchandise Order Shipping and Handling $5.00 Total Amount Due Prices are subject to change without notice. ORDERING BY PHONE: Have your Visa, Discover
ページ12に含まれる内容の要旨
Warranty One-Year Limited Warranty Thomson Consumer Electronics warrants that for 1 year from the date of purchase this product is free from defects in material and workmanship. If the item is defective within that period, return it at your expense to the dealer from whom it was purchased together with the proof of purchase for replacement. This warranty excludes defects or damage due to misuse, abuse or neglect. The foregoing warranty is in lieu of all other warranties, express or implied, inc
