ページ1に含まれる内容の要旨
CAMILEO S20
User’s Guide
English/Español
GMAA00216011
03/10
ページ2に含まれる内容の要旨
2 Regulatory Information FCC Information Product Name: Camcorder Model number: CAMILEO S20 FCC notice “Declaration of Conformity Information” This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
ページ3に含まれる内容の要旨
3 FCC Conditions This equipment has been tested and found to comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. Contact Address: TOSHIBA America Information Systems, Inc. 9740 Irvine Boulevard Irvine, California 92618-1697 Telephone: (949) 583-3000 Safety Instructions 1 Do not drop,
ページ4に含まれる内容の要旨
4 About the battery pack ❖ Use only batteries recommended by TOSHIBA as replacements. The battery pack is lithium ion batteries, which can explode if not replaced, used, handled or disposed of properly. Dispose of the battery as required by local ordinances or regulations. ❖ Charge the battery pack only in an ambient temperature between 5 and 35 degrees Celsius. Otherwise, the electrolyte solution might leak, battery pack performance might deteriorate and the battery life might be shortened
ページ5に含まれる内容の要旨
5 Additional Information © Copyright 2010 TOSHIBA CORPORATION. All rights reserved. TOSHIBA reserves the right to make technical changes. TOSHIBA assumes no liability for damages incurred directly or indirectly from errors, omissions or discrepancies between this product and the documentation. Trademarks Adobe and Photoshop are either registered trademarks or trademarks of Adobe Systems Incorporated in the United States and/or other countries. ArcSoft, MediaImpression, and MediaConverter a
ページ6に含まれる内容の要旨
Contents Chapter 1: Getting to Know Your Camcorder.............................9 Overview ..................................................................9 Check the Components .....................................10 System Requirements.......................................10 Front view .........................................................11 Rear view ..........................................................11 Side views.........................................................12 Undersid
ページ7に含まれる内容の要旨
Contents 7 Using the pre-record function.................................24 Picture Recording ...................................................25 Taking close up pictures/movies.............................25 Using the digital light or light functions ..................25 Using digital zoom ..................................................26 Record menu options .............................................26 Movie record mode menu.................................26 Picture record mode menu ..
ページ8に含まれる内容の要旨
Contents 8 Format ..............................................................46 Default settings.................................................47 Chapter 6: Viewing Pictures and Movies on TV .................................................... 48 Connecting to a high-definition 16:9 (wide) TV.......48 Connecting to a non-high-definition 4:3 TV ...........49 Chapter 7: Viewing Pictures and Movies on a Computer..................................... 50 Installing bundled software.............
ページ9に含まれる内容の要旨
Chapter 1 Getting to Know Your Camcorder Overview Your Toshiba camcorder comes equipped with a 5 Mega Pixel sensor that can record H.264 format movies. This format allows for extended video recording with less memory. Other features of your CAMILEO S20 camcorder are: ❖ High quality images up to 16 mega-pixels ❖ Color LCD screen for easy viewing of video and pictures ❖ Video recording at an HD resolution of 1920 x1080 ™ ❖ HDTV connectivity via an HDMI cable ❖ Easy playback of recorded high-
ページ10に含まれる内容の要旨
Getting to Know Your Camcorder 10 Overview ❖ Memory card slot allowing users to increase storage capacity. NOTE A portion of the built-in memory is used for Firmware to operate the camcorder. Check the Components Unpack the box and make sure all listed items below are included: Lithium-ion Camcorder USB Cable AV Cable HDMI Cable AC-Adaptor Rechargeable Battery CD-ROM Quick Start Guide Cleaning Cloth Strap (Software & Pouch Tripod User’s Manual) *preinstalled in camcorder device (Sam
ページ11に含まれる内容の要旨
Getting to Know Your Camcorder 11 Overview Front view SD™ Card cover Macro switch Lens Microphone LCD screen Light (Sample Illustration) Front view Rear view Movie Mode LED indicator Picture Mode LED indicator Record button Tele button (Up button) OK button Wide button (Down button) Right button Left button Playback button TV port HDMI™ port Mini USB 2.0 port (Sample Illustration) Rear view
ページ12に含まれる内容の要旨
Getting to Know Your Camcorder 12 Overview Side views Pre-Record/YouTube™ Speaker Direct button Mode button Power button Battery cover (Sample Illustration) Side views Underside view Strap hook Tripod socket (Sample Illustration) Underside view
ページ13に含まれる内容の要旨
Chapter 2 Getting Started Loading the battery Before using the camcorder, you will need to remove the protective film from the battery. To do so, remove the battery, then remove the film, and replace the battery as shown below. (Sample Illustration) Reinserting the battery 13
ページ14に含まれる内容の要旨
Getting Started 14 Loading the battery Charge your battery You must use the supplied AC adaptor or the USB cable to charge your camcorder before use. Turn off the camcorder. A blinking light will indicate active charging and a solid light will indicate that charging is complete. In AC charging mode, the light will turn off automatically after 5 minutes. (Sample Illustration) Charging the battery Handling of the battery pack ❖ Never attempt to dispose of a battery pack by burning or by throw
ページ15に含まれる内容の要旨
Getting Started 15 Loading the battery ❖ Never drive a nail or any other sharp object into the battery pack, hit battery pack with a hammer or other object or step on it. Doing so could cause a fire or explosion possibly resulting in serious injury. ❖ Never charge the battery pack by a method other than as instructed. Doing so could cause a fire or explosion possibly resulting in serious injury. ❖ Never connect the battery pack to a plug socket or a car cigarette plug socket. The battery p
ページ16に含まれる内容の要旨
Getting Started 16 Loading the battery Battery safety ❖ Never allow caustic electrolyte fluid leaked from the battery pack to contact your eyes, body or clothing. Use appropriate protective gloves when handling a damaged battery. If caustic electrolyte fluid from the battery pack should contact your eyes, immediately wash your eyes with large amounts of running water and obtain prompt medical attention, to help prevent permanent eye damage. If electrolyte fluid should contact any part of y
ページ17に含まれる内容の要旨
Getting Started 17 Loading the battery Disposal of used battery packs ❖ Always dispose of used battery packs in compliance with all applicable laws and regulations. Put insulating tape, such as cellophane tape, on the electrode during transportation to avoid a possible short circuit, fire or electric shock. Failure to do so could possibly result in serious injury. Inserting the battery pack ❖ When installing a battery pack or before moving the product, always make sure the battery pack is i
ページ18に含まれる内容の要旨
Getting Started 18 Inserting and removing an SD™ Card (optional) ❖ The battery pack is lithium ion batteries, which can explode if not replaced, used, handled or disposed of properly. Dispose of the battery as required by local ordinances or regulations. Use only batteries recommended by TOSHIBA as replacements. ❖ Charge the battery pack only in an ambient temperature between 5 and 35 degrees Celsius. Otherwise, the electrolyte solution might leak, battery pack performance might deteriorate
ページ19に含まれる内容の要旨
Getting Started 19 Turning the camcorder on and getting started Turning the camcorder on and getting started To turn on the camcorder, either: 1 Flip the LCD screen outward to turn on the camcorder automatically. 2 Or press the Power button for approximately one second to turn it on. To record movies: Press the Mode button to switch to Movie Record mode. The Movie Mode LED Indicator ( ) lights up. Press the Record button to begin recording. To take a picture: Press the Mode button to
ページ20に含まれる内容の要旨
Chapter 3 Record Mode Button functions Mode Button: 1 Switch between Movie mode and Picture mode. 2 When recording movies, press to capture a still image. Record Button: 1 In Movie Record Mode, press to record movies. To stop recording, press the button again. 2 In Picture Record Mode, press to take a still picture. Playback Button: 1 Switch between Record and Playback modes. 2 Press after recording for a quick review 3 In the Record menu, press to exit. 20
