HP (Hewlett-Packard) Scanjet 5370C Seriesの取扱説明書

ページ1に含まれる内容の要旨

HP Scanjet 5370C Series Scanners - Installing and
Using the Active Transparency Adapter (XPA)
Introduction
The Use Transparency Adapter option lets you scan from the connected Active
Transparency Adapter (XPA) instead of scanning from the scanner bed. See the
following for instructions on how to install the Active XPA, as well as how to scan
general 5x5 inch transparencies and 35-mm slides.

NOTE: When Use Transparency Adapter is checked in the Tools menu, the Active
XPA icon appears in

ページ2に含まれる内容の要旨

3. Place the Active XPA over the transparency. Align it to fit in the corner cutouts on the large template. Step 3: Aligning the Active XPA 4. Check the Use Transparency Adapter option in the HP scanning software. NOTE: The Use Transparency Adapter option is under the Tools menu in HP Precisionscan Pro. 5. Scan as you normally would. Scanning 35-mm slides Install the Active XPA: 1. Place the small template in the cutout area of the large template. Step 1: Placing the small template

ページ3に含まれる内容の要旨

NOTE: Your scanner may have a template that holds more than one slide. If you have a multiple-slide template, you may need to cover or mask slots that are not in use. This will ensure the best possible image quality. 2. Place the 35-mm slide in the cutout area in the middle of the small template. Step 2: Position the slide 3. Place the Active XPA over the template. Align it to fit in the corner cutouts on the large template. Step 3: Aligning the Active XPA 4. Check the Use Transp

ページ4に含まれる内容の要旨

HP Scanjet Support Supplement Show Me Videos User Guide Copyright (C) Hewlett-Packard Co. 2000 This information is subject to change without notice and is provided "as is" with no warranty. Hewlett-Packard shall not be liable for any direct, indirect, special, incidental or consequential damages in connection with the use of this material.