ページ1に含まれる内容の要旨
®
EH2500 Series
Dust-Tight Enclosure
Maintenance/
Service Manual
C1473SM-B (9/04)
Pelco • 3500 Pelco Way • Clovis, CA 93612-5699 USA • www.pelco.com
In North America and Canada: Tel (800) 289-9100 • FAX (800) 289-9150
International Customers: Tel +1(559) 292-1981 • FAX +1(559) 348-1120
ページ2に含まれる内容の要旨
CONTENTS Section Page IMPORTANT SAFEGUARDS AND WARNINGS ................................................................3 DESCRIPTION ...................................................................................................................4 MODELS ....................................................................................................................4 MAINTENANCE ................................................................................................................
ページ3に含まれる内容の要旨
IMPORTANT SAFEGUARDS AND WARNINGS Prior to installation and use of this product, the following WARNINGS should be observed. 1. Installation and servicing should only be done by qualified service personnel and con- form to all local codes. 2. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X ,6 or 6P enclo- sure, it is designed for indoor use only and it must not be installed where exposed to rain and moisture. 3. Only use replacement parts recommended by Pelco. 4. After repl
ページ4に含まれる内容の要旨
DESCRIPTION The EH2500 Series enclosures are sealed, dust-tight and waterproof camera enclosures designed to protect a CCTV camera and lens from adverse environmental conditions. The enclosures feature a sled for camera mounting and a “T” handle on the rear plate to assist in removing the back plate during installation and servicing. All models will accept CCD cameras with fixed focal length or motorized zoom lenses. MODELS EH2508 6.25” L x 2.75” W x 2.75” H (15.88 x 6.99 x 6.99 cm) EH2508-1/-2/
ページ5に含まれる内容の要旨
EXPLODED ASSEMBLY DIAGRAMS 17 18 19 26 4X 25 24 2X 23 20 2X 22 * 21 2X 4 5 2X 12 *6X 6 10 2X 1 9 * 3 * 11 2X 2 2X 15 7 16 8 * 13 2X* *Available only with models that have heaters Figure 1. EH2500 Series Exploded Assembly Diagram Pelco Manual C1473SM-B (9/04) 5
ページ6に含まれる内容の要旨
Table A. EH2500 Series Exploded Assembly Parts List Item Qty Description Part Number 11 Camera sled, EH2508 EH2584300COMP 1 Camera sled, EH2512 EH25124300COMP 1 Camera sled, EH2515 EH25154300COMP 21 T-handle EH2584202COMP 31 Terminal bracket EH2584901COMP 41 Rear plate EH2584902COMP 52 Liquid-tight fitting HF00-1300-3500 61 Thermostat EH5510049A 71 Self-sealing fastener, 10-24 x .750" EHP10001 81 Thermostat TH01-8570-0100 91 Terminal block, 4-position TRB323HDS-04 10 2 Screw, 6-32 x 5/8", butto
ページ7に含まれる内容の要旨
INPUT TERMINAL 4 (AC LOW) POWER { ENCLOSURE TERMINAL 3 (AC HIGH) INPUT TERMINAL 2 POWER 9 { CAMERA TERMINAL 1 12 4 PIN 1 7 PIN 2 PIN 3 11 PIN 1 RED WIRE (NEUTRAL) HEATING PIN 2 BLACK WIRE ELEMENT POWER PIN 3 WHITE WIRE 13 6 5 1 PIN 2 PIN 1 4 3 PIN 1 CAMERA POWER{ PIN 2 Figure 2. EH2500 Series Wiring Diagram Table B. EH2500 Series Wiring Diagram Parts List Item Qty Description Part Number 11 Connector, 3-pin plug CON1-480303-0 21 Connector, 3-pin cap CON1-480305-0 31 Connector, 2-pin plug (cam
ページ8に含まれる内容の要旨
PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or If a warranty repair is required, the Dealer must contact Pelco at (800) 289-9100 or workmanship for a period of one year after the date of shipment. (559) 292-1981 to obtain a Repair Authorization number (RA), and provide the following information: Exceptions to this warranty are as noted below: 1. Model and serial number 2. Date of shipment, P.O. number
