ページ1に含まれる内容の要旨
Gateway E-842R SAS RAID
USERGUIDE
®
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Contents Chapter 1: Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Expansion enclosure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 The enclosure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ4に含まれる内容の要旨
Contents Disk I/O module LEDs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .37 Starting the drives . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .37 Disk drive LEDs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .37 Starting StorView . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ5に含まれる内容の要旨
www.gateway.com AC power (350 W power supply module) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 58 Power consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 59 Power supply module safety and EMC compliance . . . . . . . . . . . . . . . . . . . . . . . . . . . 59 Environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 59
ページ6に含まれる内容の要旨
Contents vi
ページ7に含まれる内容の要旨
CHAPTER 1 Introduction • Overview � The enclosure � The plug-in modules 1
ページ8に含まれる内容の要旨
CHAPTER 1: Introduction Overview Important Mixing of SAS and SATA drives in the same enclosure is only supported in columns, for example, column 1 is all SAS and column 2 is all SATA. Also, mixing of drives of different capacities in the same column is not supported. The Gateway E-842R SAS Enclosure Platform is a 2U (rack space) disk drive enclosure, housing twelve low profile (1-inch high), 3.5-inch form factor hard drives, which can be either: • 3 GB direct dock SAS disk drives, � 3 GB dir
ページ9に含まれる内容の要旨
www.gateway.com � Two plug-in power supply modules, 100-240 V AC, 350 W. � One plug-in cooling fan module. � Two plug-in controller modules, each incorporating a RAID controller and a StorView Management Module. Important If only one controller module is installed, a blank module must be installed in the unused slot. Enclosure chassis The chassis consists of a sheet metal enclosure assembly containing a backplane printed circuit board (PCB) and module runner system. � The chassis front panel
ページ10に含まれる内容の要旨
CHAPTER 1: Introduction Operator’s panel The enclosure’s front panel has an integrated operator’s (Ops) panel with four LEDs. The Ops panel provides you with a high level indication of the operation of the enclosure. See “Ops panel LEDs” on page 8 for details of the LED status conditions. Caution The Ops panel is an integral part of the enclosure assembly and cannot be replaced separately. To replace the Ops panel, you must replace the entire enclosure. Enclosure replacement should only be pe
ページ11に含まれる内容の要旨
www.gateway.com Audible alarms The Gateway E-842R enclosure includes an audible alarm which indicates when a fault state is present. The following conditions activate the audible alarm: � Fan fault � Voltage out of range � Over temperature � Thermal overrun � System fault � Logical Fault � Power supply module fault When the audible alarm sounds, you can mute it by pressing the Alarm Mute button on the front panel. For more information, see “Audible alarm mute” on page 16. The plug-in modules
ページ12に含まれる内容の要旨
CHAPTER 1: Introduction Two LEDs mounted on the rear panel of the power supply module indicate the status of the module: Power On & OK Module Fault Status (Green) (Orange) Off Off No AC power (either power supply module) Off On No AC power (this power supply module only) Power supply module fault (over temperature, over voltage, over current, or power supply module fan fail) On Off AC present, power supply module on and OK On On Power supply module fan fault Multiple power supply modules In ord
ページ13に含まれる内容の要旨
www.gateway.com The module has an orange Cooling Module Fault LED. LED status is described in the following table: Module Fault (Orange) Status Off Enclosure Off - Indicated by power supply module and controller module OK lights Off Enclosure On - Fan OK On Cooling module fan failure 7
ページ14に含まれる内容の要旨
CHAPTER 1: Introduction Controller module Caution Operation of the enclosure with any modules missing disrupts the airflow and the drives do not receive sufficient cooling. All openings must be filled before operating the enclosure. When only one controller module is installed, a blank module must be installed in the vacant controller module slot at the rear of the enclosure to maintain airflow and ensure correct operation. Important Do not mix Disk I/O modules and RAID Controller modules in
ページ15に含まれる内容の要旨
www.gateway.com � An RJ45 10/100BaseT Ethernet port lets you connect the controller to a network to enable out-of-band management and monitoring using the embedded StorView GUI software. Important Only shielded, Cat 5 (or better) cables should be used for connection to the Ehternet port for EMC performance. � There is also an RS232 socket which provides an alternative user interface to the RJ45 connector. Caution Although the RS232 port is similar in appearance to a USB port, it requires a s
ページ16に含まれる内容の要旨
CHAPTER 1: Introduction Controller OK Green When lit, this LED indicates that RAID controller activity is normal. Controller fault Orange When lit, this LED indicates that a RAID controller fault has occurred. Ethernet status Green When lit, this LED indicates that the Ethernet port has a valid connection. Orange When lit, this LED indicates that the Ethernet port has activity. SAS activity Green When lit, these LEDs show I/O activity on the specific port lane indicated. Battery module Each
ページ17に含まれる内容の要旨
www.gateway.com Disk I/O module The expansion enclosure houses one or two Disk I/O modules. They provide the drive expansion for the RAID enclosure. When expanding the system, you may add up to four expansion enclosures. This will give you a total of five enclosures including the RAID enclosure. A fully loaded system will provide a total of 60 disk drives. Important Do not mix Disk I/O modules and RAID Controller modules in the same enclosure. Disk I/O modules are only installed in the expan
ページ18に含まれる内容の要旨
CHAPTER 1: Introduction Drive carrier module The drive carrier module comprises a hard disk mounted in a carrier. Each drive bay houses a single, low profile, 1.0-inch high, 3.5-inch form-factor disk drive in its carrier. The carrier has mounting locations for SAS or SATA drives. The front cap also supports an ergonomic handle which provides the following functions: � Inserting the carriers into the drive bays � Removing the carriers from drive bays � Positive “spring loading” of the drive/bac
ページ19に含まれる内容の要旨
www.gateway.com Dummy carrier modules Dummy carrier modules are provided for fitting in all unused drive bays. They are designed as integral drive module front caps and must be installed in all unused drive bays to maintain a balanced airflow. Blank modules Caution Operation of the enclosure with any modules missing disrupts the airflow and the drives do not receive sufficient cooling. All openings must be filled before operating the enclosure. When only one controller module is installed, a
ページ20に含まれる内容の要旨
CHAPTER 1: Introduction 14
