ページ1に含まれる内容の要旨
Communicator V.90 Communicator V.90
Internal 56Kbps Faxmodem
with VoiceMail and Caller ID
User Manual
Copyright © 2000 Jaton Corporation, USA
version3.00
ページ2に含まれる内容の要旨
Part 15-Radio Interference This equipment has been test and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC rules. These limits are design to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy if is not installed and used in accordance with the instructions. It is may causes harmful interference to radio communications. However, there is no guaran
ページ3に含まれる内容の要旨
OEM supplier. The telephone company may ask that you disconnect this equipment from the network until the problem has been correct or until you are sure that the equipment is not page of the transmission, the date and time it sent and an identification of the huskiness or other The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, Before installing this equipment, users shou
ページ4に含まれる内容の要旨
iv Load Numbers of all the devices does not exceed 100. loop may consist of any combination of devices subject only to the requirement that the total of the
ページ5に含まれる内容の要旨
The information in this document is subject to change in order to improve reliability, design, or function without subsequent notice and does not represent a commitment on the part of this company. The information in this manual is believe to be accurate. However, we assume no responsibilities for any inaccuracies that may be contain in this manual. In no event will we be liable for direct, indirect, special, incidental, or consequential damages arising out of the use. The No part of this refer
ページ6に含まれる内容の要旨
................................ ................................ 8 F ................................ ................................ ................................ .. 8 S ................................ ................................ .......................... 9 S ................................ ................................ ............ 10 M O ................................ ................................ ............ 10 C L IST : ................................ ................
ページ7に含まれる内容の要旨
T C ONDITIONS . ................................ ................................ ......... 66 S : ................................ ................................ ............. 66 E NTIRE O BLIGATION . ................................ ................................ ............... 67 ................................ ... 67 vii REDUCING WARRANTY CLAIM REJECTIONS. ERVICES AGREEMENT ERMS AND
ページ8に含まれる内容の要旨
Congratulations on you purchase The Communicator V.90 to manage your desktop multimedia demands and communication needs. The Communicator V.90 transforms your computer into a fax machine, a data terminal, an Internet connection, a voice mail system, and a speakerphone. The 56kbps Fax/Data/Voice modem supports industry-standard feature for data, fax, and voice applications, plus advanced features such as 56kbps Internet download with V.90 ITU-T,full duplex speakerphone, and caller ID. This hard
ページ9に含まれる内容の要旨
• Integrated data communication, Fax, Voice software • Plug and Play or Jumper Select Configuration Modulation: V.90, V.34, V.32bis, V.32 V.23, V.22bis, V.22, V.21 and Bell 212A & 103 Data Rates: 57.3K, 56K, 54.7K, 53.3K, 52K, 50.7K, 49.3K, 48K, 33.6K, 31.2K, 28.8K, 26.4K, 24K, 21.6K, 19.2K, 16.8K, 14.4K, 12K, 9600, 7200, 4800, 2400, 1200 and 300 bps Integrity: V.42 LAPM, MNP 2-4, and MNP 10 error correction V.42 bis or MNP Class 5 Commands: Modulation: ITU-T V.17, V.29, V.27 ter, and V.21 chan
ページ10に含まれる内容の要旨
Connectors: 2 RJ11 jacks for telephone and PSTN line Speaker Interface: Minimum load 8 Ohm, Maximum load 100 Ohm 20-90% (non-condensing) Temperature: 0° to 70° C (32° to 158° F) 20-90% (non-condensing) Transmit Level: -10 dBm ±1 dB dial-up; Programmable. • x86 Compatible PC with one free 16-bit ISA Expansion Slot • • • Microphone, speakers or headset (for audio application) The Communicator V.90 provide the complete modem functions for the following modes: Group 3 fax, data, voice, V.42/MNP 2
ページ11に含まれる内容の要旨
It implements all data rates and modulation schemes for IT-U (formally CCITT) standards V.34, V.32bis, V.32, V.22bis, V.22, V.21, Bell 212A, and Bell 103. The INTEL / AMBIENT MD5662 implements a standard data mode AT command set. This is compatible with any communication AT command set. The modem supports error correction(V.42/MNP 2-4) and data compression (V.42 bis/MNP 5). Error correction ensures error-free data transfer. Data compression substantially increases the modem data throug
ページ12に含まれる内容の要旨
The Communicator V.90 supports IT-U V.80 recommendations. This feature ensures compatibility with host-based H.324 videoconferencing application software. The INTEL / AMBIENT MD56xx chipsets support both transparent and framed submodes of the V.80 synchronous access The Cirrus/Ambient chipset provide sleep mode to reduce power consumption when the modem inactive. In operational mode, the modem chipset is fully powered and is either communicating with the host and/or another modem or is performin
ページ13に含まれる内容の要旨
• The Communicator V.90 Faxmodem • • Quick Start Guide (printed) • Telephone: (408) 934-9369, 9-5 PST Mon.-Fri. Fax: (408) 942-6699 24 hour BBS: (408) 263-8529, 8-N-1. Internet: E-mail: 13 modemsupport @ jaton.com http://www.jaton.com available through Jaton BBS and Web site. Documentation CD-ROM first. Updated drivers and utilities are User’s Manual and README files on the Software and If you have any questions regarding this product, please refer to this Customer Support Telephone Cable wi
ページ14に含まれる内容の要旨
touching the such as handle the electronic circuit boards. The manufacturer assumes no liability for any damage, caused directly or indirectly, by improper installation of any components by unauthorized service personnel. If you do not feel comfortable performing the installation, consult with a qualified computer technician. SPEAKER EPH (Optional) MICROPHONE LINE PHONE 1 3 5 7 9 11 13 15 17 19 21 23 25 27 PORT IRQ JUMPER ON COM 1 4 5 7
ページ15に含まれる内容の要旨
Your modem can be set to either Plug and Play or manual operation. It is Operating System. Otherwise, use jumpers to manually setup the Communication Port Address and Interrupt. I/O Address IRQ (Interrupt) Jumpers 03F8h 4 5, 7, 11 02F8h 3 1, 7, 9 03E8h 4 3, 5, 11 02E8h 3 1, 3, 9 PnP PnP PnP 9 through 27 The modem chipset internally implements both the volume control and amplifier necessary to drive an external speaker. The internal amplifier is capable of driving a minimum load of 8 ohm up to a
ページ16に含まれる内容の要旨
1. peripheral devices, and unplug the power cord from the wall Tour power cord and wall outlet may differ from the ones shown. 2. Touch a metal plate on your system to ground yourself and discharge any static electricity. 3. system. 16 Remove the cover from your outlet. Switch off your system and all Hardware Installation Steps:
ページ17に含まれる内容の要旨
4. Find a free 16-bit expansion slot in your system. 5. Remove the metal plate from the slot you have chosen and put the screw aside. 6. Align the card to a 16-bit Bus with the expansion slot and gently push down into it. Secure the card to expansion slot from the metal plate. 7. 17 and connect necessary devices. Replace the cover of your system with the screw you removed
ページ18に含まれる内容の要旨
Once The Communicator V.90 card is configured with proper jumpers for the hardware and installed in the PC system, it is ready to use. The Windows®9x operating system require you to install proper modem drivers. You may either install the Standard Modem drivers or install manufacture’s modem driver. Have the driver disk and operating system disk handy before you install the driver. 1) again after the new board is installed in the system, it will proper drivers for the devices. Select “Driver
ページ19に含まれる内容の要旨
the Control Panel from My Computer. 2) If you previously installed a modem, please click on 19 to step 4). Modems icon, otherwise click on Add New Hardware and go Windows®9x “Add New Hardware” routine as below: Open
ページ20に含まれる内容の要旨
3) Click on “R e and then click on “ A Click on next. Go to Step 6). 20 dd…” button. move” button on the Modems Property screen,
