ページ1に含まれる内容の要旨
DUAL CONCENTRIC™
OWNERÕS MANUAL
Tannoy United Kingdom T: +44 (0) 1236 420199 F: +44 (0) 1236 428230 E: enquiries@tannoy.com
Tannoy North America T: (519) 745 1158 F: (519) 745 2364 E: inquiries@tannoyna.com
Tannoy adopts a policy of continuous improvement and product specification is subject to change.
6481 0398
ページ2に含まれる内容の要旨
SUPERTWEETER™ TECHNOLOGY Tannoy has incorporated its own WIDEBAND™ technology into the design of all Eyris DC loudspeakers. Not only does this exceptional in-house technology resolve fine detail of high frequency information but it also to effectively enhances the listening experience throughout the whole frequency range. The Tannoy SuperTweeter™ high frequency system creates an increased immediacy, airiness and impact making music OWNERÕS MANUAL sound more natural and true to life. DUAL CONCENT
ページ3に含まれる内容の要旨
CABLE CHOICE WARNING: Always use the best quality of cable available within your budget. High quality audio signals passing ENSURE THAT THE SPIKES ARE LEVELLED AND THAT THE LOCK NUTS ARE TIGHTENED FIRMLY. from the amplifier to the loudspeaker are unusual in their demands on the cable. Wide dynamic range THE SPIKES SHOULD BE PUSHED THROUGH THE CARPET TO LOCATE INTO THE FLOORING and frequency bandwidth information has to coexist with the ability to transmit peak currents of at least SURFACE BY APP
ページ4に含まれる内容の要旨
CONNECTION IN SINGLE WIRE MODE BI-AMPING The terminal panels have captive link bars fitted as standard to link the positive and negative HF and Bi-Amping extends the principle of bi-wiring one stage further. In this connection option separate power LF terminals respectively. These must be removed to bi-wire the speakers - see section entitled Connection amplifiers are used for bass and treble signals in each loudspeaker. Four mono (or two stereo) amplifiers in Bi-wire mode. (See fig. 4) of the
ページ5に含まれる内容の要旨
GRILLES CENTRE CHANNEL SPEAKER It is essential that the SuperTweeter™ diaphragms are not touched, any damage will destroy performance The Eyris DCC centre channel speaker is fully magnetically shielded and designed for installation and require specialist repair by your Tannoy dealer. Any such damage will not be covered under directly above or below the TV. As the main effects speaker for the front soundstage, the critical factor warranty. in its performance is the placement. In all cases the ce
ページ6に含まれる内容の要旨
TECHNICAL SPECIFICATIONS SET-UP DIAGRAMS Eyris DC1 Eyris DC3 Eyris DCC FIG. 1 Unpacking PERFORMANCE Recommended amplifier power 20-150 20-175 20-175 Watts RMS Continuous power handling 110 125 125 Watts Peak Peak power handling - Watts 325 375 375 Sensitivity (2.83 Volts @ 1m) 88dB 89dB 89dB Nominal Impedance - Ohms 8 8 8 Low frequency alignment (-6dB) 39Hz 34Hz 36Hz Frequency response -6dB 39Hz-51kHz 34Hz - 51kHz 36Hz - 51kHz DRIVE UNITS SuperTweeter™ high frequency 25mm (1") 25mm (1") 25mm (
ページ7に含まれる内容の要旨
SET-UP DIAGRAMS SET-UP DIAGRAMS FIG. 3 DC Terminal Panel FIG. 5 DC Bi-Wire Mode HIGH FREQUENCY HIGH FREQUENCY NEGATIVE(-) TERMINAL POSITIVE(+) TERMINAL TO RIGHT SPEAKER LOW FREQUENCY LOW FREQUENCY + - + - NEGATIVE(-) TERMINAL POSITIVE(+) TERMINAL TO 'GROUND' OR L R 'EARTH' CONNECTION POWER AMPLIFIER ON AMPLIFIER (OPTIONAL) LINKS REMOVED 'EARTH' OR 'GROUND' TERMINAL FIG. 4 DC Single Wire Mode FIG. 6 DC Bi-Amp Mode TO RIGHT TO RIGHT SPEAKER SPEAKER +-+- L R HIGH FREQUENCY POWER AMPLIFIER
ページ8に含まれる内容の要旨
1.0 METRE 1.5 TO 4.5 METRES OR MORE 0.5 METRE OR MORE SET-UP DIAGRAMS SET-UP DIAGRAMS FIG. 7 Recommended Positioning - Stereo Pair FIG. 9 Position of Omni-Mount Threaded Inserts on the Rear of Eyris DC1 0.5 METRES OR MORE 1.5 TO 4.5 METRES 1 METRE OR MORE MOUNTING PLATE OF OMNIMOUNT™ BRACKET FIG. 8 Recommended Positioning - Home Cinema REAR SUB REAR 14 15
