ページ1に含まれる内容の要旨
For assistance and information
call toll free I-800-BUY-AIWA
(United States and Puerto Rico)
mm
88-NF8-903-01
DIGITAL AIJDIO
971120AMI-M-9
ページ2に含まれる内容の要旨
Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for future reference. All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below. Installation 1 Water and moisture — Do not use this unit near water, such as near a bathtub, washbowl, swimming pool, or the like. “CAUTION:TO REDUCE THE RISK OF 2 Heat — Do not use this unit near sources of h
ページ3に含まれる内容の要旨
4 Extension cord — To help prevent electric shock, do not use a polarized AC power plug with an extension cord, receptacle, or other outlet unless the polarized plug can be completely inserted to prevent exposure of the blades of the plug. PRECAUTIONS ...................................................................l 5 When not in use — Unplug the AC power cord from the power outlet if the unit will not be used for several months or more. PREPARATIONS When the cord is plugged in, a small amoun
ページ4に含まれる内容の要旨
Before connecting the AC cord The rated voltage of your unit shown on the rear panel is 120 V AC. Check that the rated voltage matches your local voltage. Check your system and accessories IMPORTANT Connect the speakers, antennas, and all optional equipment first. Then connect the AC cord in the end. 7 Connect the right and left speakers to the main unit. Connect the right speaker cord to SPEAKERS R terminals, and left to SPEAKERS L terminals. INSX-A3041 CX-NA303 Compact disc stereo cassette rec
ページ5に含まれる内容の要旨
3 Connect the supplied antennas. CONNECTING AN OUTDOOR ANTENNA Connect the FM antenna to FM 75 Q terminals and the AM antenna to AM LOOP terminals. For better FM reception, use of an outdoor antenna recommended. AM antenna Connect the outdoor antenna to FM 75 Q terminals. 4 Connect the AC cord to an AC outlet. To connect other optional equipment+ page 17. When the AC cord is connected, the all characters may light up on the display. In this case, disconnect the AC cord. Then, connect it again. T
ページ6に含まれる内容の要旨
,— —. Inserting batteries ~“- Detach the battery cover on the rear of the remote control and insert two R6 (size AA) batteries. ■ CD POWER @~e In . . R6(AA) CLOCIU ~ -— h -/ DIMMER !:–— --- When to replace the batteries The maximum operational distance between the remote control and the sensor on the main unit should be approximately 5 meters (16 feet). When this distance decreases, replace the batteries with new ones. To turn the unit on Press one of the function buttons (TAPE, TUNER, VIDEO/AUX
ページ7に含まれる内容の要旨
T-BASS \ —.r. — I SHIFT l-r B T-BASS VOLUME Au This unit provides the following three different equalization curves. ROCK: Powerful sound emphasizing treble and bass POP: More presence in the vocals and midrange Turn VOLUME on the main unit, or press VOLUME on the CLASSIC: Enriched sound with heavy bass and fine treble. remote control. The volume level is displayed as a number from O to MAX (31). Press one of GRAPHIC EQUALIZER. The volume level is automatically set to 16 when the power is The se
ページ8に含まれる内容の要旨
.2 MONO PRESET TUNER 0-9,+10 1 1 BAND BAND SHIFT SHIFT ■ h MULTI 2 f-%—-‘–— JOG — \--- –..... . . ---- — The unit can store a total of 32 preset stations. When a station is 1 Press TUNER/BAND repeatedly to select the stored, a preset number is assigned to the station. Use the preset desired band. number to tune in to a preset station directly. 1 Press TUNER/BAND to select a band, and press When TUNER/BAND is pressed while the power is off, the + DOWN or > UP to select a station. power is turned
ページ9に含まれる内容の要旨
“ \ ,, # .-. p:.....,, .;, 4., =..,.,,! . PRESET”’N’UM’BE’RTUNiNG” “ Use the remote control to select the preset number directly. 1 Press BAND while pressing SHIFT to select a band. 2 2 Press numbered buttons O-9 and +1O to select a preset number. Example: To select preset number 20, press +10, +10 and O. DOWN, To select preset number 15, press +10 and 5. 1 UP N Selecting a preset number on the main unit = EJECT Press TUNEFUBAND to select a band. Then, press > PRESET repeatedly or turn MULTI JOG
ページ10に含まれる内容の要旨
To dav one disc only press DISC DIRECT PLAY 1-3. The selected disc is played once. To stop play, press 1. I To pause play, press 11. To resume play, press again. To sesrch for a particular point during playback, keep + or > pressed and release it at the desired point. To skip to the beginning of a track during playback, press 4 or * repeatedly or turn MULTI JOG. To remove discs, press 4 OPEN/CLOSE. To start play when the power is off (Direct Play Function) Press CD. The power is turned on and pl
ページ11に含まれる内容の要旨
3 Press numbered buttons O-9 and +10 to program ,,, , ,& ,!, a track. ,1 t ‘Lb “,> ~,,;; R’,? /,,m Example: # Use the remote control. ?$,% ‘~~~ To select the 25th track, press +10, +10 and 5. ..,2 ,.,1 ~,:,4$ To select the 10th track, press +1 O and O. RANDOM play 1 .’$$ !,.! All the tracks on the selected disc or all the discs can be played Total number of randomly. Selected track number selected tracks REPEAT play A single disc or all the discs can be played repeatedly, Press RANDOM/REPEAT whi
ページ12に含まれる内容の要旨
,. *m,,=a,$ ~~ax=.~~ *g,*>q,$~~r4.J,* wLw$,,”%, .,*,W $3$% W%W-W$ ~*.;a.,mm,d*mx,r*cm%@’*w XF%.=kee.,, *W. . INSERTING BLANK SPACES Insertion of 4-second blank spaces enables you to activate the Music Sensor function. (Applicable when the source is TUNER, VIDEO/AUX or MD.) This section explains how to record from the tuner, CD player, or 1 Press ● REC/REC MUTE during recording or while in external equipment. recording pause mode. ~ on the display flashes for 4 seconds and the tape runs without r
ページ13に含まれる内容の要旨
1,3 ■ 2 This function allows you to make exact copies of the original m tape. Set the tape to the point where recording will start. m 1 Press TAPE. Dubbing does not start from a point halfway in the tape. 2 Insert the original tape into deck 1 and the tape to be recorded on into deck 2. 1 Press TAPE. Insert the tapes with the sides to be played back or recorded 2 Insert the original tape into deck 1 and the tap(? on facing out from the unit. to be recorded on into deck 2. Press TAPE/DECK 1/2 to
ページ14に含まれる内容の要旨
6 Press ● REC/REC MUTE to start recording on the first side. The tape is rewound to the beginning of the first side, the lead segment is played through for 10 seconds, and recording f—3q7 MULTI \ starts. When the last track programmed for side A is finished, JOG .–. ._ —. ~ ~-+ ~lf%==% - n deck 2 enters the recording stop mode. After entering the recording stop mode, go to step 7. 4 Press EDIT/CHECK while pressing SHIFT on the 7 5 remote control to display the program for the second recording. 3
ページ15に含まれる内容の要旨
6 Repeat step 5 for the rest of the tracks for side! ~ ,3 ~ ill A. ,~::miij A track whose playing time is longer than the remaining time ~~; ~ ,>,,: ~,. , cannot be programmed. ., ‘:;/ 8 ::S”: Press EDIT/CHECK while pressing SHIFT on the! ,# 7 remote control to select side B and program the tracks for side B. After confirming B on the display, repeat step 5. Tape side B, (reverse side) 8 Press EDIT/CHECK while pressing SHIFT to select side A and press ● REC/REC MUTE to start recording. CD play a
ページ16に含まれる内容の要旨
11 i--r 1 II 1 9 1,2,3 2 2,3 r P--A-a 1 u, 1 The unit can be turned off automatically at a specified time. 1 Press CLOCK, then press II SET within 4 seconds. Use the remote control. Press SLEEP while pressing SHIFT. 1 When using the remote control Press CLOCK while pressing SHIFT, then press II SET !Mt!lin 4 seconds. 2 Within 4 seconds, press < or W to specify the time until the power is turned off. 2 Press + DOWN or > UP to designate the Each time the button is pressed, the time changes between
ページ17に含まれる内容の要旨
4 Select the duration for the timer-activated periold f with 4 DOWN or - UP, then press [I set. ~ .g- The duration for the timer-activated period can beset between 3 5 and 240 minutes in 5-minute steps. G 5 Prepare the source. 6 To listen to a CD, load the disc to be played first on tray 1. 2,4 To listen to a tarJe, insert the tape into deck 1 or 2. 1 I A To listen to the radio, tune in to a station. P —1,2,3,4 1 “[----- i‘ 6 Press POWER to turn the unit off after adjusting the volume and tone.
ページ18に含まれる内容の要旨
CD DIGITAL OUT (OPTICAL) 1 POWER vIDEO/AUX SURROUND SPEAKERS To play equipment connected to the VIDEO/AUX jacks proceed Refer to the operating instructions of the connected equipment as follows. for details. ● The connecting cords are not supplied. Obtain the necessary 1 Press VIDEO/AUX. connecting cords. “VIDEO” or “AUX appears on the display. ● Consult your local Aiwa dealer for optional equipment. 2 Play the connected equipment. .-....=.. ,------ ?$,:--.:,’! ,= 2. s , . . . . . . ., .,., - .-
ページ19に含まれる内容の要旨
If the unit fails to perform as described in these Operating Occasional care and maintenance of the unit and the software Instructions, check the following guide. are needed to optimize the performance of your unit. GENERAL To clean the cabinet There is no sound. Use a soft and dry cloth. ● Is the AC cord connected properly? If the surfaces are extremely dirty, use a soft cloth lightly moistened with mild detergent solution. Do not use strong ● Is there a bad connection? (+ page 3) o ● There may
ページ20に含まれる内容の要旨
SDeaker svstem SX-NA302 Cabinet type 2 way, bass reflex (magnetic shielded type) Speakers Woofer: 120 mm (4 3/4 in.) cone type Main unit CX-NA303 Tweeter: 10 (13/32 h.) mm Cf3LN?7iC typf3 FM tuner section Impedance 6 ohms Tuning range 87.5 MHz to 108 MHz Output sound pressure level 87 dBIWlm Usable sensivity (IHF) 13.2 dBf Dimensions (W x H x D) 235 x 324x 250 mm Antenna terminals 75 ohms (unbalanced) (9 3/8x 1P 7/8X 9 7/8 h.) Weight 3.2 kg (7 Ibs 11 OZ.) AM tuner section Tuning range 530 kHz to
