ページ1に含まれる内容の要旨
WLS 8060 MAX
Wireless Loudspeaker System
Bedienungsanleitung
User Instructions
ページ2に含まれる内容の要旨
Table of Contents Page 0. FCC Statement. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 2. Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 2.1. Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 2.2. Potential Risks. . . . . . . . . . . . . . . . . . . . . .
ページ3に含まれる内容の要旨
WLS 8060 ”MAX” 1 AC adapter 1. Introduction 1 CB 6060 carrying case The WLS 8060 ”MAX” is a high quality powered loudspeaker for 2 receiving antennas a wide range of applications. It allows you to set up a mobile or fixed sound system quickly and easily. This professional design is Please check that the package contains all components of the easy to use even if you are not familiar with the intricacies of system you ordered. If anything is missing, please contact your sound reinforcement. A clea
ページ4に含まれる内容の要旨
15 15 7 9 1 10 11 6 12 5 14 7 13 3 4 8 2 Abb. 1: Bedienelemente WLS 8060 12
ページ5に含まれる内容の要旨
WLS 8060 ”MAX” 1. RECHARGE BATTERY 11. SQUELCH DC input jack for charging the integrated battery or operating This recessed rotary control sets the threshold of the squelch the WLS 8060 on AC power using the supplied AC adapter. circuit integrated in the receiver for suppressing unwanted noise. (For details refer to section 6.1.5. Receiver.) 2. Charging LED This yellow LED will light constantly while the battery is being WIRELESS MIC charged and will start flashing as soon as the battery is full
ページ6に含まれる内容の要旨
2. Tighten the fixing nut on each antenna CW. the total discharge threshold. If this happens, recharge the battery 3. Point both antennas upward so that the two antennas will immediately. form a ”V”. If you cover the WLS 8060 with the optional RP 6060 rain 5.5. Powering Up (AC Operation) cover point the antennas straight down. The WLS 8060 has been designed for an AC voltage of 230 V/50 Hz. Custom versions with an adapter for other AC 5.4. Powering Up (Battery Operation) voltages are available
ページ7に含まれる内容の要旨
WLS 8060 ”MAX” CHANNEL LED 3a 3d 3m GAIN - LED + 3f PWR GAIN + - 3h Fig. 2: Opening the handheld transmitter Fig. 3: Bodypack transmitter 6.1.2. Selecting the Carrier Frequency dead within about 90 minutes. Replace the batteries with new ones as soon as possible. 1. Handheld Transmitter: Unscrew the battery compart- If the status LED fails to illuminate the batteries are dead. Insert ment cover and the color code ring CCW. new batteries. Bodypack transmitter: Referring to fig. 3, open the bat- 6
ページ8に含まれる内容の要旨
2. The red status LED on the transmitter lighting brightly means 1. Make sure never to point the microphone element directly at the transmitter is overloaded. Turn the GAIN control on the the loudspeaker. transmitter CCW to the point that the status LEDs will only flash 2. Hold the handheld transmitter by the shaft. Be sure not to occasionally. cover the microphone element with your hand. 3. Should the loudspeaker start whistling or howling all the same MIC Switch turn the VOLUME control (9) or
ページ9に含まれる内容の要旨
WLS 8060 ”MAX” 8. Specifications WLS 8060 Amplifier power (rms/peak) 40 W/60 W Drivers 1 x 8“ and 1 annular driver Speaker type 2-way bass reflex Crossover frequency 4 kHz, 12/18 dB/octave Sensitivity at 1W/1m 96 dB Max. sound pressure level 125 dB Audio frequency response 65 Hz to 20 kHz (-6dB) Projection angle (H x V) 80° x 80° Mixer inputs Wired microhpone: 1 kΩ balanced Wireless microphone: internal, 10 kΩ 2 x LINE: 10 kΩ unbalanced Phantom power 12 V Outputs 2 x LINE, +12 dB into 600 Ω for
ページ10に含まれる内容の要旨
Notizen Notes * 18
ページ11に含まれる内容の要旨
WLS 8060 ”MAX” Notizen Notes * 19
ページ12に含まれる内容の要旨
Mikrofone · Kopfhörer · Drahtlosmikrofone · Drahtloskopfhörer · Kopfsprechgarnituren · Akustische Komponenten Microphones · Headphones · Wireless Microphones · Wireless Headphones · Headsets · Electroacoustical Components Technische Änderungen vorbehalten. Specifications subject to change without notice. AKG Acoustics GmbH AKG ACOUSTICS, U.S. Lemböckgasse 21–25, P.O.B. 158, A-1230 Vienna/AUSTRIA 1449 Donelson Pike, Nashville, TN 37217, U.S.A. Tel: (43 1) 86 654-0*, Fax: (43 1) 86 654-516 Tel: (6
