ページ1に含まれる内容の要旨
UX_GB9.book Page 1 Thursday, May 18, 2006 4:18 PM
MICRO COMPONENT SYSTEM
UX-GB9DAB
—Consists of CA-UXGB9DAB and SP-UXGB9DAB
INSTRUCTIONS
GVT0172-001A
[B]
ページ2に含まれる内容の要旨
UX_GB9.book Page 1 Thursday, May 18, 2006 4:18 PM Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS IMPORTANT for the U.K. 1. CLASS 1 LASER PRODUCT DO NOT cut off the mains plug from this equipment. If the 2. CAUTION: Do not open the top cover. There are no user plug fitted is not suitable for the power points in your home serviceable parts inside the unit; leave all servicing to or the cable is too short to reach a power point, then obtain qualified service
ページ3に含まれる内容の要旨
UX_GB9.book Page 2 Thursday, May 18, 2006 4:18 PM Information for Users on Disposal of Old Equipment [European Union] This symbol indicates that the electrical and electronic equipment should not be disposed as general household waste at its end-of-life. Instead, the product should be handed over to the applicable collection point for the recycling of electrical and electronic equipment for proper treatment, recovery and recycling in accordance with your national legislation. By dis
ページ4に含まれる内容の要旨
UX_GB9.book Page 1 Thursday, May 18, 2006 4:18 PM Introduction Precautions How to Read This Manual • Button and control operations are explained in the table Installation below. • Install in a place which is level, dry and neither too hot nor • Some related tips and notes are explained later in the too cold—between 5°C and 35°C. sections “Learning More about This System” and • Install the System in a location with adequate ventilation to “Troubleshooting,” but not in
ページ5に含まれる内容の要旨
UX_GB9.book Page 2 Thursday, May 18, 2006 4:18 PM Contents Introduction ............................................................... 1 Connections ................................................................ 3 Before Operating the System.................................... 6 Daily Operations—Playback .................................... 7 Listening to the Radio.................................................................. 8 Playing Back a Disc .........................
ページ6に含まれる内容の要旨
UX_GB9.book Page 3 Thursday, May 18, 2006 4:18 PM Connections Supplied accessories After unpacking, check to be sure that you have all the following items: • DAB antenna (1) • Remote control (1) • FM antenna (1) • Batteries (2) • AM loop antenna (1) If any item is missing, consult your dealer immediately. Do not connect the AC power cord until all other connections have been made. Rear view 11 11 From DAB antenna See page 4. 22 22 From AM/FM antenna See page 4. 33 33 From the speakers See
ページ7に含まれる内容の要旨
UX_GB9.book Page 4 Thursday, May 18, 2006 4:18 PM To connect the AM loop antenna 1111 DAB antenna FM antenna (supplied) Extend it so that you can obtain the best reception. DAB antenna (supplied) Extend the wire so that you can receive your desired ensembles. AM loop antenna (supplied) Turn it until the best reception is obtained. For the better DAB reception Active antenna (not supplied) • If the AM loop antenna wire is covered with vinyl, remove the vinyl to expose the tip of t
ページ8に含まれる内容の要旨
UX_GB9.book Page 5 Thursday, May 18, 2006 4:18 PM 3333 Speakers To connect a portable audio device To connect the speaker cords AUX jack DOWN UP Make sure that both speakers are connected correctly and firmly. 1 Hold 2 Insert 3 Release PHONES AUX Stereo mini plug cord (not supplied) Portable audio device Red From left speaker • By using QP Link (Quick Portable Link), you can easily Black start playing back a portable audio device on this unit. See page 9 for details. From right s
ページ9に含まれる内容の要旨
UX_GB9.book Page 6 Thursday, May 18, 2006 4:18 PM Before Operating the System The indications on the display tell you a lot of things while you are operating the System. Before operating the System, be familiar with when and how the indicator illuminates on the display. 1 Disc operation indicators 12 3 4 5 6 • PRGM (Program Play): lights when Program Play mode is activated. PRGM RND TA NEWS INFO FM AM ST MONO L-BAND SLEEP 7 • RND (Random Play): lights when Random Play mod
ページ10に含まれる内容の要旨
UX_GB9.book Page 7 Thursday, May 18, 2006 4:18 PM Daily Operations—Playback In this manual, the operations using the remote control are explained mainly; however, you can use the buttons and controls on the main unit if they have the same (or similar) name and symbol. 1 SET/ANT. P. CANCEL 1 Turn on the power. QP LINK The STANDBY lamp on the main unit turns off. DIMMER 2 Without pressing STANDBY/ON ... PTY SEARCH • The System turns on by pressing one of the source 4,¢ 7 butto
ページ11に含まれる内容の要旨
UX_GB9.book Page 8 Thursday, May 18, 2006 4:18 PM 3 Select a preset number for the station you store. Listening to the Radio PRESET/GROUP/PTY • For DAB operations, see page 14. SET DOWN UP ANT. P. Increases the To select the band (FM or AM) preset numbers. Remote control: Main unit: Decreases the FM AM DAB preset numbers. DAB/ FM/AM FM FM AM FM S.TURBO S.TURBO QP Link QP Link Remote ONLY To tune in to a station To tune in to a preset station While FM or AM
ページ12に含まれる内容の要旨
UX_GB9.book Page 9 Thursday, May 18, 2006 4:18 PM To select track numbers on an MP3 disc, enter the To select a track number in three digits. Refer to the following examples: When selecting track 24... Increases the track numbers. 1 Press SET to skip the first digit. 2 Select “2” for the second digit pressing UP or DOWN Decreases the track numbers. button repeatedly, then press SET. 3 Select “4” for the last digit pressing UP or DOWN button repeatedly, then press SET
ページ13に含まれる内容の要旨
UX_GB9.book Page 10 Thursday, May 18, 2006 4:18 PM Daily Operations—Sound&Other Adjustments Remote ONLY To drop the volume in a moment Remote control To restore the volume, press again, or FADE MUTING adjust the volume level. SLEEP A. STANDBY CLOCK/ SET/ANT. P. TIMER Adjusting the Sound CANCEL DIMMER To emphasize the sound—Sound Turbo This function emphasizes the sound. PRESET/GROUP/PTY SOUND TURBO TURBO ON DOWN,UP DISPLAY (Initial setting) MODE AHB PRO TURBOOFF SOUND BASS/ (Can
ページ14に含まれる内容の要旨
UX_GB9.book Page 11 Thursday, May 18, 2006 4:18 PM 2 Adjust the hour, then the minute. Changing the Display Brightness PRESET/GROUP/PTY SET DOWN UP You can dim the display window. ANT. P. DIMMER DIM 1 DIM 2 DIM OFF (Initial setting) Now the built-in clock starts working. DIM 1 Dims the display and the illumination on the To check the current time during play main unit. DISPLAY Clock MODE DIM 2 Dims the display more than DIM 1 and turns off the illumination on
ページ15に含まれる内容の要旨
UX_GB9.book Page 12 Thursday, May 18, 2006 4:18 PM Radio Data System Operations Searching for a Program by PTY Codes Remote control Remote ONLY You can locate a particular kind of program from the preset channels (see page 8) by specifying the PTY codes. To search for a program using the PTY codes 1 While listening to an FM station... PTY SEARCH FM ST 7 PTY SEARCH S.TURBO PRESET/GROUP/PTY QP Link DOWN,UP DISPLAY REPEAT/ MODE TA/News/Info FM ST S.TURBO QP Link Re
ページ16に含まれる内容の要旨
UX_GB9.book Page 13 Thursday, May 18, 2006 4:18 PM Description of the PTY codes for Radio Data Switching Temporarily to a Program of System Remote ONLY Your Choice Automatically NEWS: News. AFFAIRS: Topical program expanding or enlarging The Enhanced Other Networks function allows the System upon the news—debate, or analysis. to switch temporarily to a preset FM station broadcasting a INFO: Programs the purpose of which is to impart program of your choice (TA, NEWS,
ページ17に含まれる内容の要旨
UX_GB9.book Page 14 Thursday, May 18, 2006 4:18 PM DAB Operations Caution: Remote control Electrostatic discharge from your body may cause noise from the speakers and you cannot hear the broadcast. If this happens, turn off the System (on standby), then turn it on again. SET/ANT. P. Listening to a Service 1 Select DAB. DAB Remote control: Main unit: PTY SEARCH 4,¢ 7 DAB DAB PRESET/GROUP/PTY DAB/ DISPLAY FM/AM DOWN,UP AM FM MODE REPEAT TA/News/Info • When you change the source
ページ18に含まれる内容の要旨
UX_GB9.book Page 15 Thursday, May 18, 2006 4:18 PM Remote ONLY Remote To scan for ensembles ONLY Presetting Services With the ensemble scanning function, the System scans the You can preset 30 services in memory. DAB bands to pick out available ensembles under your 1 Tune in to an ensemble, then select a service you want receiving condition. to preset. • When you change the source to DAB for the first time after plugging in the AC power code, the System automatically 2 A
ページ19に含まれる内容の要旨
UX_GB9.book Page 16 Thursday, May 18, 2006 4:18 PM Remote ONLY Changing the Display Mode Searching for a Service by PTY Codes Remote ONLY While listening to a DAB service... You can locate a particular kind of program from among all the services you can receive by specifying PTY codes. DISPLAY Service label Ensemble ID MODE 1 While listening to a DAB service... Frequency BAND PTY SEARCH Clock* S.TURBO QP Link PTY Preset channel number DLS BAND S.TURBO QP Link Service “NOSIG
ページ20に含まれる内容の要旨
UX_GB9.book Page 17 Thursday, May 18, 2006 4:18 PM Description of the PTY codes for DAB Switching Temporarily to a Service of Your NEWS: News. Remote AFFAIRS: Topical program expanding or enlarging Choice Automatically ONLY upon the news—debate, or analysis. PTY Standby Reception function allows the System to INFO: Programs the purpose of which is to impart advice in the widest sense. switch temporarily to a DAB service broadcasting a program SPORT: Programs concerned with any a
