ページ1に含まれる内容の要旨
AUDIO/VIDEO CONTROL RECEIVER
RX-6020VBK / RX-6022VSL
AUDIO/VIDEO CONTROL RECEIVER
FM/AM TUNING FM/AM PRESET FM MODE
STANDBY
MASTER VOLUME
PTY–PTY SEARCH–PTY
MEMORY
STANDBY/ON
SURROUND ON/OFF
INPUT ANALOG INPUT DIGITAL ADJUST SETTING
FM MODE DVD MULTI DVD VCR TV SOUND
INPUT ATT
CONTROL
SURROUND MODE DOWN UP
SPEAKERS ON/OFF
CD TAPE/CDR FM AM
SOURCE NAME
PHONES
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial
No. which are located either on the rear,
bottom or side of the ca
ページ2に含まれる内容の要旨
Warnings, Cautions and Others/ Mises en garde, précautions et indications diverses For Canada/pour le Canada CAUTION RISK OF ELECTRIC SHOCK CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE DO NOT OPEN BLADE OF PLUG TO WIDE SLOT, FULLY INSERT ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK. INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA DO NOT REMOVE COVER (OR BACK) BORNE CORRESPONDANTE DE LA PRISE ET POUSSER
ページ3に含まれる内容の要旨
Table of Contents Table of Contents Parts Identification...................................... 2 Getting Started........................................... 3 Before Installation ...................................................................... 3 Checking the Supplied Accessories ........................................... 3 Putting Batteries in the Remote Control .................................... 3 Connecting the FM and AM Antennas ....................................... 4 Connecting the
ページ4に含まれる内容の要旨
Parts Identification Front Panel 3 1 2 45 6 7 89 p RX-6020V AUDIO/VIDEO CONTROL RECEIVER FM/AM TUNING FM/AM PRESET FM MODE TUNED STEREO AUTO MUTING STANDBY ANALOG SPK SLEEP LC R DIGITAL AUTO PRO LOGIC ΙΙ DSP H.PHONE INPUT ATT VOLUME MEMORY LINEAR PCM S.WFR LFE MASTER VOLUME DIGITAL LS S RS STANDBY/ON CH- SURROUND ON/OFF INPUT ANALOG INPUT DIGITAL ADJUST SETTING DVD MULTI DVD VCR TV SOUND INPUT ATT CONTROL DOWN UP SURROUND MODE SPEAKERS ON/OFF CD TAPE/CDR FM AM SOURCE NAME PHONES q w e r t y u
ページ5に含まれる内容の要旨
Parts Identification / Getting Started Getting Started Before Installation Putting Batteries in the Remote Control Before using the remote control, put two supplied batteries first. General Precautions • When using the remote control, aim the remote control directly at • DO NOT insert any metal object to the unit. the remote sensor on the unit. • DO NOT disassemble the unit or remove screws, covers, or cabinet. 1 On the back of the remote control, remove the • DO NOT expose the unit to rain or m
ページ6に含まれる内容の要旨
Getting Started Connecting the FM and AM Antennas AM Loop Antenna (supplied) Outdoor FM antenna (not supplied) If FM reception is poor, connect outdoor FM antenna. or Standard type Supplied FM outdoor FM antenna ANTENNA antenna (not supplied) FM 75 COAXIAL FM antenna (supplied) Extend the supplied FM antenna horizontally. Snap the tabs on the loop into the slots of the base AM to assemble the AM loop LOOP antenna. AM EXT If AM reception is poor, connect outdoor single vinyl-covered wire (not
ページ7に含まれる内容の要旨
Getting Started Speaker layout diagram Connecting the Speakers “NO” for the subwoofer, “LARGE” for the front speakers, After connecting the front, center, rear speakers and/or a subwoofer, and “SMALL” for the center and rear speakers are initial set the speaker setting information properly to obtain the best settings. To get best possible sound, change the subwoofer possible surround effect. For details, see pages 12 to 14. and speaker settings to fit your listening conditions (See pages 12 and
ページ8に含まれる内容の要旨
Getting Started Video component connections Connecting Audio/Video Components Use the cables with RCA pin plugs (not supplied). Turn off all components before connecting. Connect the white plug to the audio left jack, the red plug to the audio right jack, and the yellow plug to the video jack. Analog connections Audio component connections Use the cables with RCA pin plugs (not supplied). Connect the white plug to the audio left jack, and the red plug to the TV audio right jack. CD TV CAUTION: O
ページ9に含まれる内容の要旨
Getting Started IMPORTANT: DVD player • When connecting the DVD player or digital TV to the digital terminal, DVD player you also need to connect it to the video jack on the rear. Without A B connecting it to the video jack, you cannot view any playback picture. DVD • After connecting the components to the DIGITAL IN terminals, make sure the following if necessary: – Set the digital input terminal setting correctly. For details, see “Setting the Digital Input (DIGITAL IN) Terminals” on page 11.
ページ10に含まれる内容の要旨
Basic Operations Front Panel Remote Control STANDBY lamp Display A/V CONTROL STANDBY/ON RECEIVER TEST CENTER AUDIO STANDBY/ 1 2 3 EFFECT REAR L TV RX-6020V AUDIO/VIDEO CONTROL RECEIVER 4 5 6 ON MENU REAR R VCR FM/AM TUNING FM/AM PRESET FM MODE 7/P 8 9 AUDIO ANALOG SPK TUNED STEREO AUTO MUTING SLEEP ENTER SUBWOOFER DVD STANDBY DIGITAL AUTO LC R PRO LOGIC ΙΙ DSP H.PHONE INPUT ATT VOLUME MEMORY LINEAR PCM S.WFR LFE MASTER VOLUME 10 0 10 DIGITAL LS S RS RETURN 100 STANDBY/ON CH- SLEEP SOUND SLEE
ページ11に含まれる内容の要旨
Basic Operations Changing the source name Adjusting the Volume Remote When you connect the CD recorder to the NOT TAPE/CDR jacks on the rear panel, change the On the front panel: MASTER VOLUME source name shown on the display. To increase the volume, turn MASTER VOLUME clockwise. 1 Press TAPE/CDR (SOURCE NAME). TAPE/CDR To decrease the volume, turn it • Make sure “TAPE” appears on the display. counterclockwise. SOURCE NAME 2 Press and hold SOURCE NAME (TAPE/CDR) From the remote control: until “A
ページ12に含まれる内容の要旨
Basic Operations Turning Off the Sounds Basic adjustment auto memory Remote ONLY Temporarily—Muting This receiver memorizes sound settings for each source when: • Turning off the power, You can mute the sound temporarily. • Changing the source, and • Assigning the source name. MUTING Press MUTING on the remote control to mute When you change the source, the memorized settings for the newly the sound through all speakers or headphones selected source are automatically recalled. connected. Followi
ページ13に含まれる内容の要旨
Basic Operations / Basic Settings Basic Settings Front Panel Remote Control Display A/V CONTROL STANDBY/ON RECEIVER TEST CENTER AUDIO 1 2 3 EFFECT REAR L TV 4 5 6 RX-6020V AUDIO/VIDEO CONTROL RECEIVER MENU REAR R VCR 7/P 8 9 FM/AM TUNING FM/AM PRESET FM MODE ENTER SUBWOOFER DVD STANDBY ANALOG SPK TUNED STEREO AUTO MUTING SLEEP 10 0 10 DIGITAL AUTO LC R PRO LOGIC ΙΙ DSP H.PHONE INPUT ATT VOLUME MEMORY LINEAR PCM S.WFR MASTER VOLUME RETURN 100 SLEEP DIGITAL LS S RS SOUND STANDBY/ON CH- REW FF
ページ14に含まれる内容の要旨
Basic Settings ANALOG The following are the analog/digital signal indicators on the display to From the remote control: /DIGITAL indicate what type of the signal comes into the receiver. Press ANALOG/DIGITAL. The current setting indication appears on the display. • Each time you press the button, the input mode alternates ANALOG : Lights when the analog input is selected. between the analog input (“ANALOG”) and the digital input LINEAR PCM : Lights when Linear PCM signals come in. (“DIGITAL AUTO
ページ15に含まれる内容の要旨
Basic Settings Speaker size Speaker distance Register the sizes of all the connected speakers. Register the unit you use, then the speaker distance from your • When you change your speakers, register the information about the listening point. speakers again. • If you have set the unit before, start from step 3. • Speaker distance is not valid for the DVD MULTI playback mode. T SETTING 1 Press SETTING repeatedly until SETTING 1 Press SETTING repeatedly until “FRNT SP (Front speaker),” “CNTR “UNIT
ページ16に含まれる内容の要旨
Basic Settings Dynamic range compression Crossover frequency You can compress the dynamic range (difference between maximum Small speakers cannot reproduce the bass sounds efficiently. If you sound and minimum sound) of the reproduced sound. This is useful use a small speaker in any position, this receiver automatically when enjoying surround sound at night. reallocates the bass sound elements assigned from small speakers to • This function takes effect only when playing back a source large spea
ページ17に含まれる内容の要旨
Basic Settings / Sound Adjustments Sound Adjustments Remote Control Front Panel A/V CONTROL STANDBY/ON RECEIVER Display TEST CENTER AUDIO 1 3 2 EFFECT REAR L TV 4 5 6 MENU REAR R VCR 7/P 8 9 RX-6020V AUDIO/VIDEO CONTROL RECEIVER ENTER SUBWOOFER DVD SUBWOOFER +/– 10 0 10 FM/AM TUNING FM/AM PRESET FM MODE RETURN 100 SLEEP SOUND SPK TUNED STEREO AUTO MUTING SLEEP STANDBY ANALOG LC R DIGITAL AUTO PRO LOGIC ΙΙ DSP H.PHONE INPUT ATT VOLUME MEMORY SOUND LINEAR PCM S.WFR LFE MASTER VOLUME REW FF D
ページ18に含まれる内容の要旨
Tuner Operations Front Panel Remote Control FM/AM FM/AM PRESET TUNING A/V CONTROL STANDBY/ON RECEIVER 5/∞ 5/∞ TEST CENTER AUDIO 1 2 3 (up/down) (up/down) Display FM MODE EFFECT REAR L TV 4 5 6 10 keys REAR R MENU VCR 7/P 8 9 ENTER SUBWOOFER DVD 10 0 10 RX-6020V AUDIO/VIDEO CONTROL RECEIVER 100 RETURN SLEEP SOUND FM/AM TUNING FM/AM PRESET FM MODE REW FF SPK TUNED STEREO AUTO MUTING SLEEP STANDBY ANALOG LC R DIGITAL AUTO PRO LOGIC ΙΙ DSP H.PHONE INPUT ATT VOLUME MEMORY LINEAR PCM S.WFR LFE MA
ページ19に含まれる内容の要旨
Tuner Operations MEMORY 4 Press MEMORY again while the Selecting the FM Reception Mode selected channel number is flashing When an FM stereo broadcast is hard to receive or noisy, you can on the display. change the FM reception mode while receiving an FM broadcast. The selected channel number stops flashing. • You can store the FM reception mode for each preset station (see The station is assigned to the selected channel number. page 16). ANALOG SPK TUNED STEREO AUTO MUTING L C R VOLUME S.WFR LF
ページ20に含まれる内容の要旨
Creating Realistic Sound Fields You can use the following Surround modes to reproduce a realistic Dolby Digital* sound field: Used to reproduce multichannel sound tracks of the software Dolby Surround encoded with Dolby Digital ( ). DIGITAL • Dolby Pro Logic II • To enjoy the software encoded with Dolby Digital, connect the • Dolby Digital source component using the digital terminal on the rear of this DTS Digital Surround receiver. (See page 7.) DAP modes All Channel Stereo Dolby Digita
