ページ1に含まれる内容の要旨
MICRO COMPONENT SYSTEM
—Consists of CA-UXG1 and SP-UXG1
UX-G1
TIMER
TIMER SET ON/OFF STANDBY/ON
REPEAT/
RDS SEARCH RANDOM SLEEP
STANDBY/ON
REMAIN/
RDS MODE PROGRAM FM MODE
VOLUME
TAPE TUNER/ CD
BAND
CD
BEAT CUT
MICRO COMPONENT SYSTEM
DISPLAY/
CLOCK SET
SOUND/
VOLUME
MUTING BASS
REMOTE CONTROL
CD SYNCHRO RECORDING
OPEN
INSTRUCTIONS
LVT1356-001B
[B]
UX-G1[B]_rev_01cover_f.p65 1 05.1.28, 11:28 AM
ページ2に含まれる内容の要旨
Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appro- priate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. If nonetheless the mains plug is cut off ensure to remove the fuse 1. CLASS
ページ3に含まれる内容の要旨
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮ Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and inter
ページ4に含まれる内容の要旨
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual •When unplugging the unit from the wall outlet, always pull This manual is organized as follows: on the plug, not the AC power cord. • This manual mainly explains operations using the DO NOT handle the AC power cord w
ページ5に含まれる内容の要旨
Contents Location of the Buttons and Controls ............................. 3 Main unit ................................................................................... 3 Remote Control ......................................................................... 5 Getting Started .................................................................. 6 Unpacking ................................................................................. 6 Putting the Batteries into the Remote Control ..........
ページ6に含まれる内容の要旨
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Main Unit Top view 1 OPEN 5 6 TIMER ON/OFF BAND MULTI SOUND 2 CONTROL /BASS TAPE TUNER CD 7 PHONES CD CONTROL 3 4 8 Front view 9 STANDBY/ON VOLUME p e MICRO COMPONENT SYSTEM UX-G1 q r w CD SYNCHRO RECORDING OPEN t Inside the front cover y 3 UX-G1[B]_rev_03name_f.p65 3 05.1.28, 11:28 AM
ページ7に含まれる内容の要旨
Continued Display window on the front panel 12 3 4 56 7 8 ON OFF SLEEP ST MONO SOUND BASS SYNC MHz kHz MP3 1ALL PRGM RAND TOTAL REMAIN 9pw q e r t y See pages in parentheses for details. Main unit Display window 1 Disc cover (14) 1 (timer) indicator 2 PHONES jack (9) 2 ON/OFF (timer on-time/off-time) indicators 3 TIMER ON/OFF button (21) 3 SLEEP indicator 4 SOUND/BASS button (9) 4 FM mode indicators 5 0 OPEN (disc cover open) (14, 15) • ST (stereo), MONO 6 Source buttons 5 SOUND indicator • TAP
ページ8に含まれる内容の要旨
Remote Control See pages in parentheses for details. 1 TIMER SET button (20, 21) 2 REPEAT/RDS SEARCH button (12, 16) 3 RANDOM button (16) 4 REMAIN/RDS MODE button (12, 16) 5 BEAT CUT button (10, 18) 6 DISPLAY/CLOCK SET button (8) TIMER TIMER SET ON/OFF STANDBY/ON 7 MUTING button (9) 9 1 8 SOUND/BASS button (9) REPEAT/ p 9 STANDBY/ON button (8, 21) RDS SEARCH RANDOM SLEEP 2 q p TIMER ON/OFF button (21) 3 w REMAIN/ q SLEEP button (21) RDS MODE PROGRAM FM MODE w PROGRAM button (8, 11, 15, 20) 4 e T
ページ9に含まれる内容の要旨
Getting Started Continued Connections Unpacking After unpacking, check to be sure that you have all the To connect speakers following items. You can connect the speakers using the speaker cords. The number in parentheses indicates the quantity of each piece supplied. • FM antenna (1) 1 2,3 • AM (MW) loop antenna (1) • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately. SPEAKER Putting the Batteries into the Remote Control IMPEDANCE 4-16 Ω Red Insert the
ページ10に含まれる内容の要旨
FM 75 COAXIAL AM LOOP FM 75 COAXIAL AM LOOP To connect AM (MW) and FM antennas To connect an outdoor FM antenna Before connecting the antenna, disconnect the supplied FM antenna. FM antenna Outdoor FM antenna (not supplied) Ω Coaxial cable (not supplied) 1 2 Ω A 75 Ω antenna with coaxial type connector AM (MW) loop antenna (IEC or DIN 45325) should be used. (supplied) 1 Attach the FM antenna to the FM COAXIAL NOW you are ready to plug in the unit. 75 Ω terminal. Fasten it up in the position
ページ11に含まれる内容の要旨
Basic and Common Operations Continued To show the clock when the unit is turned on Setting the Clock On the remote control ONLY: Before operating the unit any further, first set the unit’s clock. DISPLAY/ When you plug in the power cord, “0:00” starts flashing on Press DISPLAY/CLOCK SET. CLOCK SET the display. • Each time you press the button, the display You can set the clock when the unit is either turned on or in changes the clock indication and the normal standby mode. indication alternatel
ページ12に含まれる内容の要旨
Adjusting the Volume Selecting the Sound Modes You can adjust the volume level only while the unit is turned You can select one of the 4 sound modes. on. The volume level can be adjusted between “VOL MIN,” •This function also affects the sound from headphones. “VOL 1” – “VOL 39,” and “VOL MAX.” •This function only affects the playback sound, and does not •The volume level has no effect on recording. affect your recording. SOUND/ To increase the volume, press VOLUME +. To select the sound modes,
ページ13に含まれる内容の要旨
Listening to FM and AM (MW) Broadcasts Continued To change the FM reception mode Tuning in to a Station On the remote control ONLY: FM MODE When an FM stereo broadcast is hard to receive TUNER/ 1 Press TUNER/BAND to select either BAND or noisy, press FM MODE so that “MONO” “FM” or “AM.” appears and the MONO indicator lights up on the The unit automatically turns on and tunes in to display. Reception will improve. the previously received station—either FM or To restore the stereo effect, press F
ページ14に含まれる内容の要旨
Presetting Stations Tuning in to a Preset Station You can preset 30 FM and 10 AM (MW) stations manually. On the remote control ONLY: In some cases, test frequencies have been already stored TUNER/ 1 Press TUNER/BAND to select either BAND for the tuner since the factory examined the tuner preset “FM” or “AM.” function before shipment. This is not a malfunction. You The unit automatically turns on and tunes in to can preset the stations you want into memory by following the previously received sta
ページ15に含まれる内容の要旨
Receiving FM Stations with RDS Continued RDS (Radio Data System) allows FM stations to send an Searching for Programs by PTY Codes additional signal along with their regular program signals. (PTY Search) For example, the stations send their station names, as well as information about what type of program they broadcast, such One of the advantages of RDS is that you can locate a as sports or music, etc. particular kind of program by specifying the PTY codes. When tuned in to an FM station which
ページ16に含まれる内容の要旨
Description of the PTY codes: NEWS: News. WEATHER: Weather reports and forecasts. AFFAIRS: Topical program expanding or enlarging FINANCE: Stock Market reports, commerce, trading upon the news—debate, or analysis. etc. INFO: Program the purpose of which is to impart CHILDREN: Programs targeted at a young audience. advice in the widest sense. SOCIAL: Programs about sociology, history, SPORT: Program concerned with any aspect of geography, psychology and society. sports. RELIGION: Religious progra
ページ17に含まれる内容の要旨
Playing Back Discs Continued This unit has been designed to play back the following Playing Back the Entire Disc—Normal Play discs—CD, CD-R, and CD-RW. When playing a CD-R or CD-RW 1 Press 0 OPEN on the unit. User-edited CD-Rs (CD-Recordable) and CD-RWs (CD- The disc cover opens. ReWritable) can be played only if they are already •You can insert a disc while listening to another source. “finalized.” • Usually you can play back your original CD-Rs or CD- 2 Place a disc correctly with its label s
ページ18に含まれる内容の要旨
To stop playing, press 7. Programming the Track Playing Order—Program Play You can arrange the order in which tracks play before you start playing. You can program up to 60 tracks. To remove the disc, press 0 OPEN on the unit. On the remote control ONLY: 1 Place a disc. • If the current source is not the CD player, press CD. • If the disc cannot be read correctly (because it is scratched, for example) or an unreadable CD-R or CD-RW is inserted 2 Press PROGRAM. Playback will not start. PROGRAM Th
ページ19に含まれる内容の要旨
When playing back MP3 disc: Playing at Random—Random Play ALL GR. You can play the tracks at random. 1 Canceled On the remote control ONLY: ALL: In Normal Play, repeats all the tracks. RANDOM Press RANDOM before or during playing. In Program Play, repeats all the tracks in the The RAND and indicators light up on the display. program. GR.: In Normal Play, repeats all the tracks in a group. In Program Play and Random Play, this function is not available. To stop playing, press 7. 1: Repeats one
ページ20に含まれる内容の要旨
Playing Back Tapes For Tape operations, use buttons inside the front cover on the 4 Close the cassette holder gently. unit. Playing Back a Tape You can play back type I tapes only. On the unit ONLY: 1 Open the front cover. 5 Press TAPE. TAPE The unit automatically turns on and the source changes to the tape deck. •You can select to the tape by pressing TAPE on the remote control. 6 Press # (play). The tape starts playing. • When the end of the tape is reached, playing 2 Press &/) (stop/cassette
