ページ1に含まれる内容の要旨
DD-831[UJ].book Page i Thursday, March 8, 2007 9:35 AM
NETWORK MEDIA SYSTEM
DD-8
Consists of CA-DD8, SP-PWDD8,
SP-DD8F and SP-DD8S
DD-3
Consists of CA-DD3, SP-PWDD3,
SP-DD3F and SP-DD8S
DIGITAL MEDIA SYSTEM
DD-1
Consists of CA-DD1, SP-PWDD1,
SP-DD1F and SP-DD1S
(Only for DD-8 and DD-3)
INSTRUCTIONS
LVT1546-015A
[UJ]
ページ2に含まれる内容の要旨
DD-831[UJ].book Page 1 Thursday, March 8, 2007 9:35 AM Warnings, cautions and others CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2. Do not expose this appliance to rain or moisture. CAUTION • Do not block the ventilation openings or holes. (If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.) • Do not place any naked flame sources, such as lighted candles, on the appa
ページ3に含まれる内容の要旨
DD-831[UJ]-gpage.fm Page 2 Thursday, March 8, 2007 9:51 AM CAUTION — F button! (CA-DD8/CA-DD3/CA-DD1) Disconnect the mains plug to shut the power off completely (the STANDBY lamp goes off). When installing the apparatus, ensure that the plug is easily accessible. The F button in any position does not disconnect the mains line. • When the system is on standby, the STANDBY lamp lights red. • When the system is turned on, the STANDBY lamp goes off. The power can be remote controlled. CAUTION
ページ4に含まれる内容の要旨
DD-831[UJ].book Page 1 Thursday, March 8, 2007 9:35 AM Table of contents Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. Resuming playback.......................................28 Introduction Pausing playback..........................................28 Advancing the picture frame by frame ..........28 Part description ............................
ページ5に含まれる内容の要旨
DD-831[UJ].book Page 2 Thursday, March 8, 2007 9:35 AM Playing back sources from other devices Playing back sources from other devices..........................................42 Selecting other devices as the source ..........42 Selecting the signal gain...............................42 QP LINK........................................................43 Operating other devices using the remote control Operating other devices using the remote control..............................44 Operatin
ページ6に含まれる内容の要旨
DD-831[UJ].book Page 3 Thursday, March 8, 2007 9:35 AM Part description The numbers refer to the pages in which the parts are explained. Front view STANDBY lamp Refer to “Display window” shown below. Remote control sensor These terminals are available when the front cover is open. *1 The [PHONES] terminal is for connecting a pair of headphones equipped with a stereo plug (not supplied). When the headphones are connected, the speakers do not produce any sound. (“HEADPHONE” appears in t
ページ7に含まれる内容の要旨
DD-831[UJ].book Page 4 Thursday, March 8, 2007 9:35 AM Using the remote control The numbers refer to the pages in which the parts There are some differences between DD-8/DD-3 are explained. and DD-1 in the locations of the remote control buttons as shown below. DD-8/DD-3 DD-1 *1 Refer to the separate Refer to page 19. volume of the opera- tion manual for the network function. *2 No button Refer to page 19. Inserting the batteries into the remote control R6P (SUM-3)/AA (15F) type dry-cell
ページ8に含まれる内容の要旨
DD-831[UJ].book Page 5 Thursday, March 8, 2007 9:35 AM Preparation Do not turn on the power until you complete the connection. Connecting the antennas AM loop antenna (supplied) FM antenna (supplied) Setting up the AM loop antenna FM antenna Main unit (rear view) Stretch out the FM antenna horizontally. If reception is poor Main unit (rear view) If insulation covers the tips of the antenna cable, twist and pull off the insulation. 75 Ω coaxial connector Connecting the AM loop anten
ページ9に含まれる内容の要旨
DD-831[UJ].book Page 6 Thursday, March 8, 2007 9:35 AM Connecting the speakers Assembling the speaker stands (DD-8) The speakers for DD-8 must be assembled to the speaker stands before the speakers can be connected to the subwoofer. Follow the diagrams below. Left and right speakers Center surround speaker ■ CAUTION • The left and right speakers for DD-8 are consid- erably heavy. Care must be taken in carrying and handling them. Injury to personnel or damage to devices may result if the l
ページ10に含まれる内容の要旨
DD-831[UJ].book Page 7 Thursday, March 8, 2007 9:35 AM Preparation (continued) Do not turn on the power until you complete the connection. Connecting the speakers to the subwoofer (DD-8) Gray Blue Rear view Before connecting the speaker cables, twist and pull off the insula- tion at the end of each speaker cable. Subwoofer (SP-PWDD8) Black Black Black lines Center surround speaker cable (supplied) Gray Black Black Blue Right Left Rear view Center surround speaker (SP-DD8S) Right speaker
ページ11に含まれる内容の要旨
DD-831[UJ].book Page 8 Thursday, March 8, 2007 9:35 AM Assembling the speaker stands (DD-3) The speakers for DD-3 must be assembled to the speaker stands before the speakers can be connected to the subwoofer. Follow the diagrams below. Left and right speakers ■ CAUTION • The left and right speakers and center surround speaker for DD-3 can be installed on a wall. • Be sure to have the speakers installed on the wall by qualified personnel. Bottom covers (2) are supplied with DD-3 for inst
ページ12に含まれる内容の要旨
DD-831[UJ].book Page 9 Thursday, March 8, 2007 9:35 AM Preparation (continued) Do not turn on the power until you complete the connection. Connecting the speakers to the subwoofer (DD-3) Gray Blue Rear view Before connecting the speaker cables, twist and pull off the insula- tion at the end of each speaker cable. Subwoofer (SP-PWDD3) Black Black Black lines Center surround speaker cable (supplied) Black Gray Black Blue Right Left Rear view Center surround speaker (SP-DD8S) Right speaker
ページ13に含まれる内容の要旨
DD-831[UJ].book Page 10 Thursday, March 8, 2007 9:35 AM Connecting the speakers to the subwoofer (DD-1) Gray Blue Rear view Before connecting the speaker cables, twist and pull off the insula- tion at the end of each speaker cable. Subwoofer (SP-PWDD1) Black lines Black Black Rear view Rear view Center surround speaker (SP-DD1S) Right speaker Left speaker (SP-DD1F) (SP-DD1F) The left and right speakers are the same. 10 Preparation
ページ14に含まれる内容の要旨
DD-831[UJ].book Page 11 Thursday, March 8, 2007 9:35 AM Preparation (continued) Do not turn on the power until you complete the connection. Connecting the subwoofer to the Speaker layout main unit Center surround speaker Only for DD-8 and DD-3 Left speaker Right speaker Subwoofer Peel off the protective sheets Subwoofer from both sides of the sub- ■ CAUTION woofer. • An incorrect connection may damage the speak- ers. Properly connect the cables to the speaker Main unit terminals. • Do not
ページ15に含まれる内容の要旨
DD-831[UJ].book Page 12 Thursday, March 8, 2007 9:35 AM Connecting a TV with the Connecting a TV [COMPONENT VIDEO OUT] terminals TV Connecting a TV with the [VIDEO] terminal TV Main unit Main unit (rear view) (rear view) To component terminals To a video terminal Component video cable (not supplied) Connecting a TV with the [HDMI] Composite video cable (supplied) terminal (not available for DD-1) DD-8 and DD-3 can output uncompressed digital Connecting a TV with the [S-VIDEO]
ページ16に含まれる内容の要旨
DD-831[UJ].book Page 13 Thursday, March 8, 2007 9:35 AM Preparation (continued) Do not turn on the power until you complete the connection. NOTE • DD-8 and DD-3 support up to HDMI version 1.0. The HDMI video signal type can be checked with the “HDMI” indicator in the display window. (Refer to “Selecting the video signal type” shown on the right.) • If the picture is distorted while an HDMI TV is connected, turn off the main unit and turn it on again. • A TV compatible with HDCP (High-B
ページ17に含まれる内容の要旨
DD-831[UJ].book Page 14 Thursday, March 8, 2007 9:35 AM 3 Press 2 or 3 to select the video NOTE signal type suitable for the TV. • The picture may be distorted when you press [ENTER], but this is not a malfunction of the sys- • When the TV is connected to the [VIDEO] tem. terminal or the [S-VIDEO] terminal, the • To check the compatibility of your TV, contact video signal type can be selected as your local JVC customer service center. instructed below. • All JVC-manufactured progressive
ページ18に含まれる内容の要旨
DD-831[UJ].book Page 15 Thursday, March 8, 2007 9:35 AM Preparation (continued) Do not turn on the power until you complete the connection. ■Selecting the analog output level of the Connecting a portable digital [LINE OUT] terminal audio player You can lower the analog output level to prevent the system from producing unnecessarily loud sound. Controlling the level may also be helpful for Listening to analog sound from a recording sound from the system to other devices. portable digita
ページ19に含まれる内容の要旨
DD-831[UJ].book Page 16 Thursday, March 8, 2007 9:35 AM Connecting other digital Connecting other analog audio devices audio devices AV amplifier with a Input Output built-in decoder Audio device To an optical digital input terminal Optical digital cable (not supplied) Audio cable (not supplied) Main unit (rear view) Input Output Main unit Input (rear view) Optical digital cable Connecting the power cable (not supplied) ■Main unit Main unit (rear view) AC outlet To an optical digita
ページ20に含まれる内容の要旨
DD-831[UJ].book Page 17 Thursday, March 8, 2007 9:35 AM Basic operations NETWORK 3 Turning on the main unit (For DD-8/DD-3) DIMMER Press [F AUDIO]. (For DD-1) • Press [F AUDIO] again to turn off the main unit. • With the power off, pressing any of the following Remote control buttons also turns on the main unit. mode selector - [DVD/CD 3], [USB 3], [NETWORK 3] (only for DD-8/DD-3), [LINE], [FM/AM] or [OPEN/ CLOSE 0] on the remote control - 3, 0 or [SOURCE] on the main unit The func
