Network Technologies NTI Primux Primus-16X64の取扱説明書

ページ1に含まれる内容の要旨

®
PRIMUX Series


PRIMUX-16X64
PRIMUX-8X32
KVM Matrix Switch via CATx
Quick Start Guide












PRIMUX-16X64

(Front and Rear View)








HA-UNV PS/2 and USB Host
PRIMUX-UZR
Adapter (sold separately)
User Station (sold separately)
1

ページ2に含まれる内容の要旨

What's in the Box Terminating Plug NTI PRIMUX-16X64 or 8X32 Cat5 KVM Matrix Switch AC Line Cord Country Specific Manual CD Quick Start Guide What's also needed (sold separately) • NTI Host Adapter(s) HA-UNV PS2/USB Host Adapter (Includes a CT7038 USB-PS2 Adapter)/ HA-SUN-MTX SUN Host Adapter / HA-RS-M Serial Host Adapter (see chart

ページ3に含まれる内容の要旨

Hardware Setup 1. Disconnect power from each CPU to be connected. (If your CPU fully supports hot-plugging, powering-down will not be necessary). 2. Plug the appropriate Host Adapter into the devices and video ports on the back of each CPU. 6 miniDIN male connectors 6 pin miniDIN female connectors PS/2 keyboard (purple) USB-PS/2 Adapter (mouse) (Front View) Note: When hotplugging the mouse and keyboard cables into a PS/2 CPU, be sur

ページ4に含まれる内容の要旨

Cable to CPU 3. Connect a CAT5 cable from the "OUT" port on each Host Adapter to a "CAT5" port on the PRIMUX KVM Matrix Switch. 4. Connect the Terminating Plug (supplied with Host Adapter) to the "IN" port on each Host Adapter. WARNING: Never connect the PRIMUX Host Adapter, User Station, or Matrix Switch to an Ethernet card, Ethernet router, hub or switch or other Ethernet RJ45 connector of an Ethernet device. Damage to devices connected to ! (Re

ページ5に含まれる内容の要旨

7. Connect a Cat5 cable between the “Cat5” port on the User Station and a “User” port on the Matrix Switch. Rear View of PRIMUX-Matrix Switch 32 31 30 29 28 27 26 25 CPU 24 23 22 21 20 19 18 17 8 7 USER 6 5 EXPANSION PORT ETHERNET RS232 16 15 14 13 12 11 10 9 CPU 8 7 6 5 4 3 2 1 4U 3SER 2 1 R NETWORK TECHNOLOGIES INC Tel:330-562-7070 NTI 1275 Danner Dr, Aurora, OH 44202 www.nti1.com Rear View of PRIMUX-UZR User Station Rear View of PRIMUX-UZR User Station Rear View of

ページ6に含まれる内容の要旨

Initial Startup Upon startup, the Command Mode On Screen Display (OSD) menu will be displayed, auto-logging you in as the administrative user “root”. By default, the user “root” has full administrative rights and access to all Host Adapters and their connected CPUs. To logout as a user, press and the login screen will appear If you logout and want to log back in as the administrator “root” either ; A) type at the user prompt and press

ページ7に含まれる内容の要旨

Make a Connection From the Command Mode menu, to make connection to any Host Adapter, press or to highlight and select the desired Host Adapter, press to connect to it. -OR- use the mouse to highlight the desired Host Adapter to connect to and left-click on it to connect. Press to exit Command Mode and use the connect