ページ1に含まれる内容の要旨
COLOSSUS
AMPLIFIER
SERIES
ページ2に含まれる内容の要旨
COLOSSUS HIGH PERFORMANCE AMPLIFIER SERIES The Hifonics Colossus has been designed to a very high level of performance, with features unavailable in any other product. The Colossus has variable crossovers built in, with added touches such as Subsonic Filter, Parametric Bass Equalization, Phase Shift, Balanced Line Input and a Remote Level Control Module that allows bass control from reach of the drivers seat. To insure years of listening pleasure, all amplifiers have a built in diagnostic mode
ページ3に含まれる内容の要旨
WIRE GAUGE GENERAL INSTALLATION PROCEDURE System Design The success of any car stereo system relies on several factors, such as the system design, execution of the installation, and system setup. Please remember that any system is only as good as its weakest link. Please remember that higher power systems are not necessarily useful purely for high sound pressure levels, but also to establish a headroom capability, to reproduce musical peaks cleanly without distortion. Lower power amplifiers w
ページ4に含まれる内容の要旨
AMPLIFIER FEATURE DESCRIPTIONS The Hifonics Colossus is capable of 4, 2 & 1 Ohms stereo per channel, or A POWER LED indicates the powered up and turned on condition. 4 & 2 Ohms mono bridged operation. All HiFonics amplifiers feature a comprehensive diagnostic system, with speaker lead short circuit, thermal over load and amplifier DC faults The input sensitivities for rated output powers are variable from 0.2 volt to indicated by the PROTECT LED’s. The Colossus features a new clipping 9 vo
ページ5に含まれる内容の要旨
BALANCED HFR-G1 BALANCED HFR-G1 SUB SUB INPUT OUTPUT INPUT LEVEL PHASE BOOST BANDWIDTH FREQ REMOTE SONIC LPF DIAGNOSTICS INPUT OUTPUT INPUT LEVEL PHASE BOOST BANDWIDTH FREQ REMOTE SONIC LPF DIAGNOSTICS RED - SHORT CIRCUIT RED - SHORT CIRCUIT AMBER - THERMAL AMBER - THERMAL L L RED - CLIP L L RED - CLIP AMBER - NEAR CLIP AMBER - NEAR CLIP GREEN - PRE-CLIP GREEN - PRE-CLIP 9V 0.2V 0 180 0 10dB 30 100Hz 15 35Hz 35 250Hz 9V 0.2V 0 180 0 10dB 30 100Hz 15 35Hz 35 25
ページ6に含まれる内容の要旨
SETTING UP SYSTEMS AFTER INSTALLATION FOR BEST PERFORMANCE General: At this point you are ready to get more specific on the settings for your amplifier. Please follow the settings in the order they are presented to reduce the risk of damage to your audio equipment. Phase: The variable Phase adjustment allows you to change the relative time that the waveform meets your ear. With standard subwoofer installations where the subwoofer is behind you, the Phase should generally be at 0. When subwoofe
ページ7に含まれる内容の要旨
TROUBLESHOOTING A SYSTEM The key to finding the problem in a misbehaving sound system is to isolate parts of that system in a logical fashion to track down the fault. Description of the Diagnostic system built into all HIFONICS amplifiers The diagnostic system will shut down the amplifier, until reset by turning the head unit off, and back on. This state of affairs will be indicated by the front panel PROTECT LED lighting up under the following conditions: 1 - A sort circuit on the loudspeaker
ページ8に含まれる内容の要旨
HIFONICS COLOSSUS DUAL-MONO AMPLIFIER FEATURES 6
ページ9に含まれる内容の要旨
COLOSSUS Maxxsonics Limited Warranty As the manufacturer of Maxxsonics, MB Quart, Autotek, Crunch and Hifonics car audio products, Maxxsonics USA Inc. Warrants to the original consumer purchaser the amplifier to be free from defects in material and workmanship for one (1) Year from date of purchase. All other parts and accessories of the system are warrantied to be free from defects in material and workmanship for one (1) year from date of purchase. Maxxsonics will repair or replace at it’s o
ページ10に含まれる内容の要旨
OEM Integration Accessories MX-1 Premium High To Low Level Converter MX-3 Bass Controller * Converts High Level OEM speaker wires to Ultra Clean RCA Low Level Outputs * High Level Inputs: Accepts all types of High level Inputs * Parametric Bass EQ: Provides a wide array of subwoofer output signal including floating ground and high voltages up to 30 volts. shaping controls to enhance bass response and sound quality including * Audio Signal Sense / Hardwire Turn-On: Audio sense detec
ページ11に含まれる内容の要旨
Accessories 5V ON SLAVE 3V 7V OFF MASTER 35Hz 250Hz 1V 9V 15Hz 35Hz MODE LOW PASS RED - CLIP OUTPUT TEST TONE SUBSONIC GREEN - 9V 65Hz FILTER LEVEL FILTER 24 dB/OCT 24 dB/OCT MAXX-LINK MLX-100 9V 0.2V 0 180 0dB +10 dB 30Hz 100Hz INPUT PHASE BOOST BANDWIDTH FREQUENCY LEVEL PARAMETRIC BASS EQ -6dB BYPASS RED - CLIP GREEN - 9V -20dB 0dB NORMAL LEVEL 9
ページ12に含まれる内容の要旨
