ページ1に含まれる内容の要旨
DIAMOND ELITE SERIES
USERS GUIDE
COVERS MODELS
L2-E L2S-E
L2-5E L2S-5E
L2-10E L2S-10E
ページ2に含まれる内容の要旨
DIAMOND ELITE SERIES TELEPHONE DIAGRAM INCLUDED IN YOUR PACKAGE Handset Line Cord Coiled Handset Cord Base Clear Plastic Overlay User Guide CONNECTING THE DIAMOND ELITE SERIES TELEPHONE Handset Holder 1) Located on the left side of the Diamond Elite is a modular jack labeled TO HANDSET. Ringer Volume Control Insert one end of the coiled handset cord into this jack (you will hear the coil cord click when properly inserted.) 2) Insert the other end of the coiled handset cord into the modular jac
ページ3に含まれる内容の要旨
Using the Speakerphone (models L2S-E, L2S-5E and L2S-10E only) SPEAKERPHONE TIPS (models L2S-E, L2S-5E, L2S-10E only) 1) With the handset in the cradle press the line key associated with the ringing line. To activate the handset from speakerphone mode: The Elite will go off hook, answering the ringing line with the speakerphone active. 1) Lift the handset. OR 2) The red SPEAKER LED will go out. Press the SPEAKER key. The Elite will select the ringing line and answer with the speakerphone activ
ページ4に含まれる内容の要旨
PROGRAMMING THE AUTO DIAL KEYS CONVERTING FROM DESK TO WALL MOUNT Models L2S-10E, L2-10E, L2S-5E, and L2-5E include programmable auto dial keys. The Diamond Elite telephone can be converted for wall mounting applications. This The L2S-10E and L2-10E models each have ten (10) programmable auto dial keys, and conversion process is easiest when the handset and line cords are not connected. the L2S-5E and L2-5E models each have five (5) programmable auto dial keys. These keys can be programmed to au
ページ5に含まれる内容の要旨
REQUIREMENTS OF PART 68 - FCC RULES This device has been granted a registration number by the Federal Communications Commission, under Part 68 rules and regulations for direct connection to the telephone lines. In order to comply with these FCC rules, the following instructions must be carefully read and applicable portions followed completely: 1. Direct connection to the telephone lines may be made only through the standard modular cord furnished, to the utility installed jack. No connection m
