Stanton STR8-20の取扱説明書

ページ1に含まれる内容の要旨

FULL MANUAL







BELT DRIVE TURNTABLE









STR8-20




WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

ページ2に含まれる内容の要旨

NAME OF PARTS 1) Strobe Dots 8) Headshell 2) Slip Mat 9) Pitch Control Slider 3) Center Spindle 10) Tonearm 4) Power Switch 11) Arm Rest 5) Start/Stop Button 12) Counterweight 6) 33 Button 13) Position For Preparing Cartridge 7) 45 Button BEFORE USE *Check following parts included in the package with the main unit: *Notes: 1) Turntable platter 1) Do not connect the AC power plug before 2) Slip mat assembly has been completed. 3) 45-rpm adaptor 2) Before you turn o

ページ3に含まれる内容の要旨

ASSEMBLY 1. Remove the main unit with the packing from the box stylus tip during the adjustment. and take off the packing. (d) Release the arm clamp and lift the tonearm 2. Insert the turntable platter onto the center spindle. from the arm rest to free it. 3. Set the slip mat on the platter. (c) Rotate the counterweight until the tonearm is 4. Hold the ribbon tape which is attached to the belt approximately balanced horizontally (floats and loop the belt over the motor pulley. Be sur

ページ4に含まれる内容の要旨

OPERATION 1. Rotate the power dial clockwise to turn on the 5. Press the Start/Stop button, the turntable platter power, the speed indicator and the strobe- will start to rotate. illuminator will light up. 6. Move the tonearm over the desired groove. 2. Place a record on the slip mat, when playing a 7. When play is finished, move the tonearm to the 45rpm record with a large center hole, place the 45- arm rest, secure the tonearm with the arm clamp. rpm adaptor on the center spindle. 8.