ページ1に含まれる内容の要旨
HDMI Extender over Fiber Optic
User’s Guide
Models
FO-HDMI-SET
© 2008 Avenview Inc. All rights reserved.
The contents of this document are provided in connection with Avenview Inc. (“Avenview”) products. Avenview makes no representations
or warranties with respect to the accuracy or completeness of the contents of this publication and reserves the right to make changes to
specifications and product descriptions at any time without notice. No license
ページ2に含まれる内容の要旨
Table of Contents Section 1: Getting Started ...................................................................................................................... 3 1.1 Important Safeguards ............................................................................................................ 3 1.2 Safety Instructions ................................................................................................................. 3 1.3 Regulatory Notices Federal Communications Commi
ページ3に含まれる内容の要旨
Section 1: Getting Started 1.1 Important Safeguards Please read all of these instructions carefully before you use the device. Save this manual for future reference. What the warranty does not cover Any product, on which the serial number has been defaced, modified or removed. Damage, deterioration or malfunction resulting from: Accident, misuse, neglect, fire, water, lightning, or other acts of nature, unauthorized product modification, or failure to follow instructions suppl
ページ4に含まれる内容の要旨
1.4 Introduction Avenview FO-HDMI-SET consists of a Transmitter and Receiver that lets you extend HDMI signal from DVD Player, Blu-ray Player Set-top box, console systems or other video equipments over fiber optical signal without any signal degradation. - High Speed and long distance transmission by Optical fiber (LC type Multi-Mode 4-ch fiber. - Extends up to 100 meters (330 feet) - Compatible with HDMI 1.3 Standard - Backward compatibility with DVI Standard 1.0 - Supports HDCP com
ページ5に含まれる内容の要旨
1.7 Installation To setup Avenview FO-HDMI-SET follow these steps for connecting to a device: 1. Power off display source such as DVD Player, Set-top box 2. Connect the enclosed copper HDMI cable into each display source and display 3. Connect copper HDMI cable which is attached to display source into FO-HDMI-SET Transmitter 4. Connect Transmitter to the HDMI cable (course) and Receiver to HDMVI Cable (display) 5. Connect the Optical cable (4ch-LC standard connector) between Transmitte
ページ6に含まれる内容の要旨
Section 2: Specifications Item Description Video Bandwidth 165MHz (Single Link) Video Input 1 Single Link HDMI Input Connector 1 HDMI Type A Receptacle 1 Single Link HDMI Video Output 5V 1.2A DC Power Power Consumption 0.55Watt Output Connector 1HDMI Type A Receptacle Maximum Supported Up to 1080p Resolution UXGA 1600 x 1200 @ 60Hz Maximum Cable 100 meters (330 feet) Length Optical 850nm VCSEL Optical Source PIN Photo Diode O/E Converter Fiber Type Multi-Mode Fiber Environm
ページ7に含まれる内容の要旨
Disclaimer While every precaution has been taken in the preparation of this document, Avenview Inc. assumes no liability with respect to the operation or use of Avenview hardware, software or other products and documentation described herein, for any act or omission of Avenview concerning such products or this documentation, for any interruption of service, loss or interruption of business, loss of anticipatory profits, or for punitive, incidental or consequentia
