ページ17に含まれる内容の要旨
While in Dual Watch Mode, you can use the.. or T to change to a new selected channel while monitoring the priority channel. To cancel dual watch, momentarily press priority button or the PTT. Scan Your UH-O54 has a scanning feature that .allows you to search for active channels automatically. Memory Scanning Memory Scanning scans only the channels stored in the scan memory. 1. To begin scanning, momentarily press the scan button. 2. The SCAN icon flashes as the UH- 054 looks for a M:~c~a 8 55 tr
ページ18に含まれる内容の要旨
. Start memory - scanning (as de- MEM PRI = scribed on the pre- SCAN 88 - vious section) then momentarily press the priority button. - or - . While dual watch- ing, press the scan button. Deleting and Storing Channels in the Scan Memory You may have certain channels that you do not want to hear every time you scan. These are channels that are busy in a major portion of time, and the scanning stops at that channel(s) often enough to interrupt the scan cycle. You can remove those channels from the
ページ19に含まれる内容の要旨
2. Then press and hold the mem button. MEM You will hear a single-confirmation tone and MEM icon appears on the display. Drop Out delay While scanning, the UH-O54 stops at a busy channel and receives a transmission. When the received signal is over, the unit will wait for three seconds for the return of the signal, otherwise the radio resumes scanning. Lighted Display The LCD back light automatically switch-on every time a key is pressed. Key Lock To prevent accidental entries, you can lock the
ページ20に含まれる内容の要旨
Battery Level Detection 1. At Power On, the level indicator is always the current battery level when 03i) ( not in Squelch or Volume Adjust Mode. 03..) ( ~; 2. The battery level indicator indicates the current battery voltage level. C~D3J (Min) (Max) Level 0 1 2 3 4 5 - -~ - . - B mmmID - - OFF --+B mID - - - - B B mID - - - -+-- ON - - - - - Blinks--<".:> 3. If level 1 is detected when [PTT] SW is pressed, transmit mode will fail, PTT Error Tone will sound and TX icon will blink. On the other h
ページ1に含まれる内容の要旨
unid~n
UH-O54A/
UH-O54L
Ultra Light Weight
Two Way Radio
MEM L6~
DU" ..'"
.CAN
f2J 8
UH.O54
power volume chan....
oo
0 1nl
~
() 0 aqU«ch \l
Curmlen -=::>
. ... ... ......
... .. .. ... . ... .....
.. . . .. ... ... ... .. . ..... . ......
.. . ... .. .. ... .. .... . .. . ...... ...
. ... ....
.. .. . . .. ... ...... .. .. ....... ... ... .
. .. . ... .. .. . ....
.. .. . ....... .... .. . .. . .. ... .. ' ... .. . .. .. .. .
. .. ..... ...... .. . .. ....... .. .. ..
.... . .
a
P1111'1~11..:,oi
ページ2に含まれる内容の要旨
Warning! 1& The UHO54A is waterproofonlywhen both the antenna and the battery are properly attached. 1& The UHO54Lis a standard NON water proof wearable radio only. 1& Donotoperatethetransmitterof anyradio equipment unless all the Radio Frequency (RF) connectors are secure and any open connectors are properly terminated. 1& Do not operate the transmitter of any radio equipment near electrical blasting caps or in an explosive atmosphere. 1& Do not let children operate any transmitter-equipped rad
ページ3に含まれる内容の要旨
Controls and Indicators 1 C> C> C> 5 6 12 2 13 3 7 8 14 4 9 15 10 16 11 ~ 17 14 Channel Down Antenna button ... 2 15 Microphone Belt Clip 3 16 Squelch button PTT (Push to Talk) Key 4 17 Battery HlilO/LOCK Key A MEM Indicator 5 LCD Display B Transmit Indicator 6 Scan button 7 C RF Power Level Power button Indicator D Channel Number 8 Duplex button Display 9 E Battery Level Priority button Indicator Duplex Indicator 10 Memory button F Scan Indicator 11 Speaker G 12 Volume button H Priority Indicat
ページ4に含まれる内容の要旨
CONTENTS Introduction 2 Features 2 Technical Support and Service. . . 2 Included with YourUH-054 . . . . . . . 4 GettingStarted 5 Mounting the Drop-in Charger. . . . 5 Attaching the Antenna. . . . . . . . 5 Attaching the Battery Pack. . . . . . 6 Charging the Battery Pack. . . . . . 6 Operation , 8 Settingthe Squelch. . . . . . . . . 8 Selecting a Channel. . . . . . . . 10 Transmitting 10 Using Repeater Channels. . . . . 11 To Operate UH-054 in Duplex Mode 12 DuaIWatch 13 Scan 14 DropOutdelay. .
ページ5に含まれる内容の要旨
Introduction The UH-054 is a portable two-way UHF transceiver. It is compact, lightweight, and rugged and fits easily in your hand. This hand held UHF CB Radio will give you the consistent, outstanding performance in virtually all conditions and situations. The UH-054 radio is available in two versions: 1. A Wearable and Waterproof UH-054A * AquaMax Radio. Or 2. A Wearable UH-054L LandMax Radio (non-waterproof) To ensure that you get the most from the UH- 054 features, please read this operating
ページ6に含まれる内容の要旨
If you require service that is within the terms of your warranty, you should present a copy of your receipt to your dealer to authenticate your claim. If you find it inconvenient to obtain service assistance from a dealer, please pack your radio in a suitable container that will provide adequate protection. Enclose a note describing the problem and a copy of your receipt, and send the radio transportation prepaid to: Uniden Australia pty Limited Customer Service Division 345 Princes Highway Rock
ページ7に含まれる内容の要旨
Included with Your UH-O54 UH-O54 AC Adapter Charger ~ Antenna Battery Wrist Strap Operating Guide Product Registration Card Mounting Screws If any of these items are missing from the box, contact your Uniden Dealer. 4
ページ8に含まれる内容の要旨
Getting Started Mounting the Drop-in Charger 1. Mount the drop-in charger to either a counter or wall. ~ 2. Plug one end of the AC adapter into the wall outlet, and the other end into the Drop- in Charger. ~ Attaching the Antenna Attach the antenna to the UH-O54. Be sure the antenna is firmly seated. 0 ~ 5
ページ9に含まれる内容の要旨
Attaching the Battery Pack 1. Slide the battery pack onto the bottom of the radio. . u- --0 156 = ~~ . 1 ~ t ~ 2. Use a coin to turn the screw that connects the battery pack to the UH-054. Be sure the battery pack fits tightly against the UH- 054's body. ~ Charging the Battery Pack Your UHF CB radio is powered by a specially- designed nickel-cadmium battery pack. 1& Before operating the UH-054, charge the battery pack for 15 hours in the drop-in charger. 6
ページ10に含まれる内容の要旨
1. Place the UH-O54 in the drop-in charger. 2. The red LED lights and stays on. 0 .... ~ The battery pack will not be overcharged by the charger even if the battery pack is not removed from the charger. ~ Do not transmit when the UH-O54is in the drop-in charger! ~ You can monitor incoming calls while the UH-O54 is in the drop-in charger. ~ You can charge the battery pack alone or connected to the UH-O54. 7
ページ11に含まれる内容の要旨
Qperation 1& When you press any key (except PTT), a short tone sounds. 1& See the front of the operating guide for button and key positions. Setting the Squelch 1. To turn the unit on, ... press and hold the MEM n 1= powerbutton for 1 P IJ 1= second. 2. Use the volumeand chan buttons to adjust the volume to a comfortable level. 3. Press the volume button. Press'" on the chan button to adjust the volume up. buttonto adjustthe MEM I 11 volume down. P V '- - Press ,. on the chan C ~ Press volume to
ページ12に含まれる内容の要旨
Press and hold" on the chan button to adjust the "squelch gate" so high that no signals get through. . StrongSignals- .. .. Medium Signals -- .. Weak Signals~ . Ho~se~==::===::==:1 5. Press and hold" on the chan button to adjust the "squelch gate" so everything gets through - noise, weak signals, and strong signals. Strong Signals Medium Signals SL c' ) Weak Signals -~o~se~ = = = ==:: ===:: === = =: ....... 6. To set the . StrongSignals- . "squelch gate" to the . Medium Signals -- desired level,
ページ13に含まれる内容の要旨
Selecting a Channel 1. When you turn on ... the UH-054, the last MEM n 1= channel will appear PU 1= on the LCD display. (e.g. CH01) 2. To select a higher channel, press"" on the channel button. 3. To select a lower channel, press'" on MEMn the channel button. PU To quickly change channels, press and hold .... or'" . This will change the channel rapidly. Transmitting The UH-054 uses the 40 UHF CB Channels. For your reference, a listing of all the available channels is printed at the end of this m
ページ14に含まれる内容の要旨
3. When the channel is clear, press the PTT switch to transmit. TX appears on the LCD when you transmit. Hold the radio with the microphone approximately two inches in front of your mouth with the antenna at approximately a 45-degree angle away from your head. Speak in a clear, normal conversational voice. 4. When you are finished speaking, release the PTT switch and listen for an answer. Using a Repeater £hannel UHF CB Repeaters are used to retransmit or relay your signal. Repeaters will extend
ページ15に含まれる内容の要旨
The signal coming from your radio is received by the Repeater station and then retransmitted at the same time on another channel. This operation is called "duplexing". Your UH-054 is designed with the capability to access and use repeater stations. Channels 01 through 08 have the option to operate in Duplex Mode. When any of these channels are set to operate in duplex mode during transmission, the UH-054 automatically sends the signal at a frequency 30 channels above the original. After transmit
ページ16に含まれる内容の要旨
Dual Watch Dual Watch mode monitors a priority channel and the currently selected channel for a signal. The UH-O54 checks the priority channel for activity every 1.5 seconds. Selecting a Priority Channel The UH-O54 is pre- programmed with CHO1 as the priority channel. However, you can change the priority channel to be any other channel. Note: When you select a new priority channel, the old priority channel automatically becomes a regular channel. 1. The radio should be in Stand-by mode. nu: 2. S
