ページ1に含まれる内容の要旨
SE200 series
OWNER’S GUIDE
WWW.SHARKCLEAN.COM
ページ2に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS For Household Use Only ® WHEN USING YOUR SHARK STEAM 1. Use the system only for its intended use. MOP, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, 2. DO NOT use outdoors. INCLUDING THE FOLLOWING: 3. DO NOT leave the appliance unattended when plugged in. WARNING: TO REDUCE THE Always unplug the power cord RISK OF FIRE, ELECTRIC SHOCK OR from the electrical outlet when not in use and before servicing. INJURY READ ALL INSTRUCTIONS BEFORE USING
ページ3に含まれる内容の要旨
11. DO NOT unplug by pulling on 23. Keep your work area well lit. power cord. To unplug, grasp the 24 Store steam mop indoors in a cool, plug not the power cord. Do not dry place. use extension cords or outlets with inadequate current carrying 25. T o avoid circuit overload, do not operate another appliance on the capacity. same socket (circuit) as the steam 12. DO NOT put any objects into cleaner. openings. Do not use with any 26. If an extension cord is absolutely openin
ページ4に含まれる内容の要旨
Quick Start a fig. 2 b fig. 1 fig. 3 ASSEMBLE FILL 1 Fit together the backsaver 3 Before plugging in the mop, handle (a) and lower pole (b). remove the cap to fill the water Insert the assembled pole into tank. Use the filling flask and the top of the mop as shown. funnel to fill the tank with water (fig. 1) to the “MAX” line. Replace the water tank cap. fi( g. 3) 2 Place the micro-fiber cleaning pad underneath the mop head, with quick fastener strips facing up. Simply press the
ページ5に含まれる内容の要旨
Quick Start fig. 5 fig. 4 STEAM CLEANING BACKSAVER ® 4 Plug in the steam mop and the 5 Use the Shar kSteam Mop STEAM light will blink blue in the with backsaver handle to standby mode. Press the STEAM access tight areas. Press button to activate the steam. The the release button on the LED indicator light will turn solid handle to bend and lock the blue. ( fig. 4) steam mop in the backsaver position. Press the release button on the handle and pull up to straighten the handle.
ページ6に含まれる内容の要旨
This manual covers models: SE200 11 SE200Z 11 TECHNICAL SPECIFICATIONS Voltage: 120V., 60Hz. Power: 1550 Watts Water Capacity: 310 ml (10.5 fl. oz.) TOLL FREE: 1-800-798-7398
ページ7に含まれる内容の要旨
Contents Getting started .......................................................................... 2 Thank you for purchasing Using your steam mop ........................................................... 4 ® the Shark Care and storage of your steam mop .............................. 7 Steam Mop. Troubleshooting ........................................................................9 Warranty and registration .................................................... 12 www.sharkclean
ページ8に含まれる内容の要旨
Getting Started When assembling your steam mop there may be a little water in or around the water tank. This is because we test all our steam mops 100% before you buy ® them, so you get a quality Sh ar Sk team Mop. fig. 3 A B C G E D fig. 1 F fig. 2 A Backsaver handle ASSEMBLY B Lower Pole 1 Remove all the parts from the package. Verify all the listed parts C Steam Mop are included. D 2 All-Purpose Cleaning Pads 2 Insert the lower pole into the E Filling Flask Backsaver handle a
ページ9に含まれる内容の要旨
Your micro-fiber cleaning pads Calcium and mineral deposits can should be replaced every 2-3 build up and impact the performance months to maximize cleaning of your steam mop over time. To performance. extend the life of your product we recommend that you use distilled ® water or Shark’s Water Filtration Bottle. Visit www.sharkclean.com to order. fig. 4 fig. 5 fig. 6 fig. 3 ATTACHING THE MICRO-FIBER PAD FILLING THE WATER TANK 1 P lace the micro-fiber cleaning pad IMPORTANT: Unp
ページ10に含まれる内容の要旨
Using Your Steam Mop When you use your steam mop for the first time or if you have not used the unit in awhile, it may take a minute or two for the water to travel through the pump and into the heater to create steam. If you have waited a few minutes and you still do not see any steam, reference the troubleshooting section on page 11. fig. 1 fig. 3 fig. 2 IMPORT ANT: Your steam mop needs 1 Pull and twist the quick release cord water to make steam! Never use your holder to unwr
ページ11に含まれる内容の要旨
If your Steam Mop stops steaming, it could be out of water. Press the STEAM button so that the LED light blinks BLUE, unplug the power cord from the electrical outlet and refill the water tank at anytime. fig. 4 fig. 5 NOTE: It may take a few seconds for the mop to warm up and and start steaming after you plug it in. If you press the STEAM button and the unit does not begin to steam immediately, just wait a few seconds for the mop to heat up to a deep cleaning and sanitizing tem
ページ12に含まれる内容の要旨
Using Your Steam Mop - cont’d fig. 7 fig. 6 BACKSAVER FEATURE 1 Clean under furniture and tight areas ® using the Shark Backsaver™ locking handle. Press the handle release button and apply slight pressure ® to bend the handle. The Shark Backsaver™ joint will lock at a perfect, access maximizing angle. (fig. 6) 2 Pr ess the release button on the handle again and pull up to straighten. (fig. 7) 6 TOLL FREE: 1-800-798-7398
ページ13に含まれる内容の要旨
Care of Your Steam Mop fig. 1 fig. 3 fig. 2 ® AFTER USE AND STORAGE 4 To store the cooled Shark Steam Mop, hang on a large hook. (fig. 3) 1 When you have finished using the Steam Mop, press the STEAM button NO TE: If you want to store the Steam to stop the unit from steaming. The Mop standing upright, make sure it LED light will blink BLUE. Unplug the is leaning against a wall for added cord from the outlet and place the support and safety. Always store your ® mop into the u
ページ14に含まれる内容の要旨
Care of Your Steam Mop - cont’d. fig. 4 fig. 5 ORDERING REPLACEMENT PARTS CARE OF YOUR MICRO-FIBER CLEANING PAD To order additional parts and 1 W ash pads in warm water. Wash accessories, feel free to contact us at www.sharkclean.com or separately from other laundry. Only use liquid detergent (not powder call 1-800-798-7398. detergent). Do not use fabric softeners. Line dry or dry on a low dryer setting. (fig. 4) 2 If there are loose threads on the pad carefully cut the th
ページ15に含まれる内容の要旨
Trouble Shooting PROBLEM POSSIBLE REASONS & SOLUTIONS Your steam mop should be securely plugged into a 120V AC electrical outlet only. The Steam Mop will Is the LED light on? If not, check your fuse or breaker. not turn-on. If your unit still does not work, call 1-800-798-7398. Is there water in the water tank? If not, add water to your Steam Mop following instructions on page 3. The Steam Mop will not make steam. Is the LED light blinking BLUE? If so, press the STEAM button to activa
ページ16に含まれる内容の要旨
Notes 10 TOLL FREE: 1-800-798-7398
ページ17に含まれる内容の要旨
Notes TOLL FREE: 1-800-798-7398 www.sharkclean.com 11
ページ18に含まれる内容の要旨
ONE (1) YEAR LIMITED WARRANTY EURO-PRO Operating LLC warrants this product to be free from defects in material and workmanship for a period of one (1) year from the date of the original purchase, when utilized for normal household use, subject to the following conditions, exclusions and exceptions. If your appliance fails to operate properly while in use under normal household conditions within the warranty period, return the complete
ページ19に含まれる内容の要旨
Notes TOLL FREE: 1-800-798-7398 www.sharkclean.com 13
ページ20に含まれる内容の要旨
U.S.: EURO-PRO Operating LLC Newton, MA 02459 Canada: EURO-PRO Operating LLC 4400 Bois Franc Ville St. Laurent, Québec H4S 1A7 1-800-798-7398 www.sharkclean.com COPYRIGHT© EURO-PRO OPERATING LLC 2011 PRINTED IN CHINA SE200.E.110415 Illustrations may differ from actual product. US Patent No. D575918
