ページ1に含まれる内容の要旨
Use and Care & Installation Guide
36″ Vented Hood
Installation.....................................4–6
Safety Instructions...Front Cover, 2
Damper/Duct Connector .........................5
Electrical Wiring .......................................6
Filter Panel.............................................3, 5
Operating Instructions.........2, 3
Mounting Brackets...................................5
Automatic Heat Sensor ...........................3
Controls ........................................
ページ2に含まれる内容の要旨
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. SAFETY PRECAUTIONS CAUTION – For general ventilating use only. Do not WARNING – TO REDUCE THE RISK OF FIRE, use to exhaust hazardous or explosive materials and vapors. ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: WARNING – TO REDUCE THE RISK OF INJURY TO A. Installation work and electrical wiring must be done by PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, qualified person(s) in accordance with all applicable OB
ページ3に含まれる内容の要旨
Important Safety Instructions Operating Instructions Cleaning Automatic Heat Sensor Your hood is equipped with an automatic thermostat. If your blower is not on, or if it is running at low speed, This thermostat is a device that will turn on or speed the thermostat will sense excessive cooking heat, up the blower if it senses excessive heat above the override the normal blower control and turn the blower cooking surface. on to high speed. The blower will run until the temperature drops to normal
ページ4に含まれる内容の要旨
INSTALLATION INSTRUCTIONS TOOLS YOU WILL NEED This hood can easily be installed by following these basic steps: • Mark and cut out the cabinet bottom. • Secure the hood to the cabinet. Flat blade and Phillips Pencil screwdrivers • Mount the cabinet on the wall. • Connect the ductwork and the power cable. Duct tape Saw (saber or keyhole) Electric Drill Metal Snips (in some applications) Pliers Tape measure Wire stripper Flashlight Caulking Level PLAN THE INSTALLATION Caution: Remove the house fus
ページ5に含まれる内容の要旨
INSTALLATION INSTRUCTIONS 2. Attach the damper/duct connector. 7. Install the mounting brackets. FRONT OF HOOD Hold the left hand mounting bracket in place on the side of the housing as shown. Use two (2) screws (provided) to attach the connector to the housing. The damper flap should open in the direction indicated by the arrow. 3. Remove the electrical knockout. Choose either the top or side of the housing for the electrical cable entrance. Remove the appropriate knockout. 4. Set the housing i
ページ6に含まれる内容の要旨
INSTALLATION INSTRUCTIONS 8. Secure the hood to the cabinet. 13. Install the glass visor assembly. VISOR Align the hood with the sides and front edge of the TRIM cabinet. Tighten the screws in each mounting bracket. Place plastic caps (provided) over the ends of these screws from the inside of the cabinet. Install two (2) additional screws into the cabinet bottom, through the front mounting holes along the front edge of the hood. 9. Replace the access cover. VISOR SLIDE Secure the access cover w
ページ7に含まれる内容の要旨
The Problem Solver Consumer Services We’ll Be There With the purchase of your new GE appliance, receive the assurance that if you ever need information or assistance from GE, we’ll be there. All you have to do is call—toll-free! ® GE Answer Center 800.626.2000 ® Whatever your question about any GE major appliance, GE Answer Center information service is available to help. Your call—and your question— will be answered promptly and courteously. And you can call any time. GE Answer ® Center servic
ページ8に含まれる内容の要旨
Staple sales slip or cancelled check YOUR 36″ HOOD here. Proof of original purchase date WARRANTY is needed to obtain service under warranty. LIMITED ONE-YEAR WARRANTY WHAT IS COVERED ********************************* This warranty is extended to For one year from date of original the original purchaser and any purchase, we will provide, free of succeeding owner for products charge, parts and related service purchased for home use within labor to repair or replace any part the USA. In Alaska
