ページ1に含まれる内容の要旨
Accessory Application Publications No.
BII 31179-34943
INSTALLATION
ACURA MUSIC LINK 2006 MDX
Issue Date
®
(FOR iPod )
INSTRUCTIONS
APRIL 2007
PARTS LIST Music Link Adapter Kit (sold separately)
P/N 08A28-1H2-100
Attachment Kit (Sold Separately)
P/N 08A28-1H1-800 Music Link adapter unit
4 Cushion tapes
Bus cable
Holder cushion
Music Link harness
Grommet
CD-ROM
8 Wire ties
2 Long wire ties
Quick Reference guide
Y-Harness Adapter (sold separately)
P/N 08A31-0F1-000
Y-harness adapter
08B28-S3V-2000
ページ2に含まれる内容の要旨
3. Open the lid. Remove the beverage holder (pull up TOOLS AND SUPPLIES REQUIRED to release the two clips). #2 Phillips screwdriver Flat-tip screwdriver Diagonal cutters LID Scissors Ratchet REVERAGE HOLDER 10 mm Socket 10 mm Combination wrench Drill motor CLIPS 3 mm Drill bit 19 mm Hole saw (3/4") Felt-tip pen Pushpin Eye protection Gloves Isopropyl alcohol Electrical tape 2001080T Illustration of the Music Link System Installed on the Vehicle ADAPTER 4. Gently remove the shift indicator trim r
ページ3に含まれる内容の要旨
6. Move the shift lever to the N position, then 9. While wearing gloves, reach under the center remove the coin box. panel and release each of the three bottom clips. Carefully pull the center panel out toward you to release the ten clips. Unplug the vehicle COIN BOX connectors, and remove the center panel. CLIPS (2) CENTER PANEL LOWER TRIM CENTER PANEL CLIP MAT 2001022T 4603010M CLIPS (2) 7. Remove the mat and center panel lower trim (four CLIPS (10) clips). VEHICLE 8. Open the accessory socket
ページ4に含まれる内容の要旨
10. Remove the two self-tapping screws and four bolts 12. Remove the weatherstrip. Remove the right front that secure the radio brackets. Pull the audio unit kick panel (one screw clip and one clip). out toward you, unplug the six vehicle connectors and the antenna lead and remove the audio unit. WEATHERSTRIP VEHICLE CONNECTORS (6) SCREW SELF-TAPPING CLIP SCREWS BOLTS (4) RIGHT FRONT ANTENNA CLIP 5729020B AUDIO KICK PANEL LEAD UNIT 2001030T 11. Remove the right front side step trim (four clips).
ページ5に含まれる内容の要旨
14. Using a felt-tip pen, mark the Music Link harness 18. Route the Music Link harness DIN connector into as shown. the 19 mm hole in the direction shown, and install the grommet to the 19 mm hole. CUSHION CUSHION TAPE TAPE GLOVE (Cut into 4 pieces.) MUSIC LINK BOX HARNESS DIN CONNECTOR FELT-TIP MUSIC LINK PEN HARNESS MARK 900 mm 50 mm 50 mm GROMMET 19 mm MUSIC LINK HOLE HARNESS 5702091B MUSIC LINK 15. Route the Music Link harness through the HARNESS grommet. 5527031B GROMMET 16. Cut one cushi
ページ6に含まれる内容の要旨
20. Insert the Music Link adapter unit into the unit 22. Secure the Music Link adapter unit onto the cushion. instrument panel with two long wire ties. INSTRUMENT UNIT PANEL CUSHION MUSIC SIDE VIEW LINK ADAPTER FRONT MUSIC LINK UNIT ADAPTER INSTRUMENT UNIT PANEL AUDIO UNIT OPENING Align ends. 5426010B MUSIC LINK LONG WIRE ADAPTER TIES UNIT 5527052B 21. Route the Music Link harness and bus cable through the audio unit opening, and connect the Music Link harness DIN connector (White) and 23. Secur
ページ7に含まれる内容の要旨
24. Secure the bus cable: Bundle up the vehicle harness and secure it, the bus cable, and Y-harness adapter with two wire ties Without the XM Radio: Align the bus cable 14-pin as shown. connector with the vehicle 20-pin connector, BUS CABLE (Bundle up bundle up the excess bus cable, and secure it to excess.) the vehicle harness with the two wire ties. BUS CABLE WIRE AUDIO UNIT (Bindle up TIES OPENING excess.) VEHICLE HARNESS WIRE WIRE TIES TIES Y-HARNESS VEHICLE ADAPTER HARNESS Y-HARNESS V
ページ8に含まれる内容の要旨
adapter 14-pin connectors. 25. Reinstall the glove box. Secure the Y-harness adapter to the vehicle 26. Connect the vehicle connectors and bus cable harness with a wire tie. 14-pin connector (or Y-harness adapter 14-pin connector) to the audio unit, and reinstall the BUS CABLE VEHICLE (Bundle up excess.) HARNESS BUS CABLE 14-PIN VEHICLE CONNECTOR or CONNECTORS Y-HARNESS ADAPTER 14-PIN CONNECTOR WIRE SELF-TAPPING TIE SCREW WIRE TIE VEHICLE HARNESS Y-HARNESS ADAPTER WIRE 5607131B TIE BOLT (4) AN
