ページ1に含まれる内容の要旨
XHDR6435
INSTALLATION/OWNER'S MANUAL
CD Receiver with Detachable Face
READY
ページ2に含まれる内容の要旨
XHDR6435 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove trim ring from unit, • Remove 2 transit screws located
ページ3に含まれる内容の要旨
XHDR6435 INSTALLATION Wiring Diagram BLACK 8-pin Female Mini-DIN BTM60 Connection (sold separately) RCA Preamp Output Connections REAR/SUB BLUE 10-pin Female Mini-DIN (selectable) HDM90 Connection (sold separately) FRONT FRONT R/SUB L-CH R-CH REMOTE IN Antenna Connector Steering Wheel Interface Input PAC SWI-PS connection (sold separately) FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio.
ページ4に含まれる内容の要旨
XHDR6435 OPERATION Control Locations - Receiver 5 1 2 3 4 6 7 8 9 10 21 20 19 18 17 16 15 13 12 11 14 Release Preset 2 / Random Tune / Track Up 1 8 15 T alk Preset 4 / Play / Pause Tune / Track Down 2 9 16 3 Mode 10 CD Eject 17 Band / ESC Audio / Menu 4 Power ( ) / Select 11 USB Port 18 Scan / HD Seek 5 Display 12 Auxiliary Input 19 6 Preset 1 / Repeat 13 20 Mute / T ag Preset 6 / Folder Up 7 Preset 3 / Intro 14 21 End Call Preset 5 / Folder Down
ページ5に含まれる内容の要旨
XHDR6435 OPERATION Control Locations - Remote 1 2 3 4 5 6 21 7 20 8 19 9 10 18 11 17 12 16 13 15 14 Mode Key 9 12 1 Power ( )/Select Mute / End Call 13 2 Volume Up 14 Key 0 / Display 3 Audio / Menu 15 T alk 4 Tune / Track Up 16 Key 8 / T ag 5 Volume Down Key 7 6 17 Scan / HD Seek / Key # Preset 4 / Play / Pause 7 18 8 Preset 3 / Intro 19 Preset 1 / Repeat 9 Preset 2 / Random Band / ESC / Key * 20 10 Preset 6 / Folder Up Tune / Track Down 21
ページ6に含まれる内容の要旨
XHDR6435 OPERATION General Operation Faceplate Removal Press RELEASE and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure. Semi-Permanent Remove trim ring and install supplied #1 x 7/32” Phillips Faceplate Installation head screw through left side of mounting frame into faceplate. Press or any other button (except eject) to turn the unit on. Power On/Off Insertin
ページ7に含まれる内容の要旨
XHDR6435 OPERATION General Operation Press and hold AUDIO/MENU for more than 3 seconds to access the Setup Menu setup menu, then press AUDIO/MENU to cycle through menu options. When desired option appears in the display, rotate the volume knob left/right to adjust or activate the desired function. Press ESC to exit the menu at any time. Setup Menu Menu Function Options Action Auto Station AUTO PGM Press SELECT to seek and save
ページ8に含まれる内容の要旨
XHDR6435 OPERATION General Operation Escape Press ESC to exit any menu adjustment mode. Audio Press AUDIO/MENU momentarily to select between Bass, Treble, Balance, Fader, EQ, Subwoofer* and Source Volume Level. BASS TREBLE BALANCE FADER EQ SUBWOOFER* SOURCE LEVEL Bass Press AUDIO/MENU until BASS appears, then rotate the volume knob left/right to adjust (-6 minimum / +6 maximum). Treble Press AUDIO/MENU until TR
ページ9に含まれる内容の要旨
XHDR6435 OPERATION AM/FM Tuner Operation Display When using the XHDR6435 without the optional HDM90, press DISP to toggle the display between the following options: (LINE 1) FREQUENCY FREQUENCY (LINE 2) BAND/PRESET CLOCK Seek Tuning Press TUNE or TUNE for more than one second nn ll to seek the next strong station. Manual Tuning Press TUNE or TUNE momentarily to move radio nn ll frequency up or down one step at a time. Press and hold to adv
ページ10に含まれる内容の要旨
XHDR6435 OPERATION HD Radio™ AM/FM Tuner Operation Connecting the HDM90 HD Radio operation requires connecting the HDM90 (sold separately) HD Radio tuner (sold separately). Refer to the HDM90 instructions for connection details. When the unit is tuned to an HD Radio station, press DISP to Display toggle the display between the following options: (LINE 1) FREQUENCY ARTIST PROGRAM TYPE FREQUENCY (LINE 2) BAND/PRESET SONG TITLE STATION NAME CLOCK HD
ページ11に含まれる内容の要旨
XHDR6435 OPERATION ® iTunes Tagging Operation (HDM90) Overview The iTunes T agging feature of the XHDR6435 requires the optional HDM90 module (sold separately). Once connected, the HDM90 allows the user to "T ag" songs that are playing on HD Radio™ stations and enables them to be purchased later through iTunes. With the touch of a button the unit will remember the title and artist song information, and then transfer that informati
ページ12に含まれる内容の要旨
XHDR6435 OPERATION ® iTunes Tagging Operation (HDM90) Troubleshooting Description Displayed Message There is a compatibility issue with the iPod device that is connected. Check the list of compatible iPod devices below. CHECK iPod VER If the attached iPod device is compatible, update the firmware to the latest version using iTunes. T ags are being sent to the iPod device. This process can take SENDING TAGS several minutes depending on t
ページ13に含まれる内容の要旨
XHDR6435 OPERATION CD Player Operation Insert CD With the label facing up, insert a standard size CD into the CD slot. The CD will automatically begin playback. Eject CD Press EJECT to eject the CD. The unit will change to previous mode of operation. If the disc is not removed within 10 seconds, the unit will reload the disc. The unit does not have to be turned on to eject CD. Track Select Press TRACK to skip to the beginnin
ページ14に含まれる内容の要旨
XHDR6435 OPERATION CD Player Operation - MP3/WMA Files Playing an MP3/WMA Disc When an MP3/WMA encoded disc is first inserted, “CD PLAY” will appear in the display. Depending on the number of files and folders, this may take several seconds. Displaying Information Press DISP to select between the following: (LINE 1) ARTIST FILE NAME ELAPSED TIME TRACK NUMBER (LINE 2) SONG TITLE FOLDER NAME CLOCK TOTAL TRACKS “NO ID3 TAG” will be displayed if the
ページ15に含まれる内容の要旨
XHDR6435 OPERATION CD Player Operation - MP3/WMA Files Folder/File Search Mode MP3/WMA CD mode features a file and folder search mode. This search allows navigating through folders to find a specific MP3 or WMA file for playback. Step 1 Press SELECT. "MP3 CD SEARCH" will appear, then a list of the files in the currently selected directory will be accessible. Step 2 Turn the volume knob. The list of subfolders and files in the
ページ16に含まれる内容の要旨
XHDR6435 OPERATION CD Player Operation - MP3/WMA Files Folder Access Press to select the previous folder. Press to select the next folder. Note: Folder access is only available on MP3/WMA discs recorded with more than one folder. Repeat Press RPT to enter the Repeat menu, then turn the volume knob to select one of the following options: • OFF - Plays all tracks on CD. • TRACK - Continuously repeats selected track.
ページ17に含まれる内容の要旨
XHDR6435 OPERATION CD Player Operation - MP3/WMA Files Media Compatibility The following types of discs/files are compatible: • CD-ROM (ISO), CD-R, CD-RW • CD-D A • MP3 data • WMA data The following types of discs/files are not compatible: • WMA files that are protected by DRM (Digital Rights Management). • WMA lossless format • Discs recorded with Track At Once or packet writing • MP3 PRO format • MP3 playlists • WAV format Play
ページ18に含まれる内容の要旨
XHDR6435 OPERATION CD Player Operation - MP3/WMA Files Additional MP3/WMA An internal buffer provides ESP (Electronic Skip Protection) Information to virtually eliminate skipping. When playing a disc recorded with regular audio files (CD-D A or .WAV) and MP3/WMA files, the unit will play the MP3/WMA files only. Only MP3 files with filename extension (.mp3) can be played. O n l y W M A f i l e s w i t h f i l e n a m e e x t e n s i o
ページ19に含まれる内容の要旨
XHDR6435 OPERATION USB Operation - MP3/WMA Files Connecting a USB Device Play MP3/WMA files from most mass storage devices by (sold separately) connecting them to the XHDR6435's USB port. Playing Music When a USB device is first connected, “READING” will appear in the display and playback will begin momentarily. Depending on the number of files and folders, it may take several seconds for the device to begin playing. If no valid
ページ20に含まれる内容の要旨
XHDR6435 OPERATION USB Operation - MP3/WMA Files Displaying Information When a file is accessed, the clock and elapsed time will be displayed. Press DISP momentarily to select file name (default), song title, artist, track number or clock & elapsed time. (LINE 1) ARTIST FILE NAME ELAPSED TIME TRACK NUMBER FOLDER NAME (LINE 2) SONG TITLE CLOCK TOTAL TRACKS "NO TITLE" will be displayed if no song title information is available. "NO ARTIST" will
