ページ1に含まれる内容の要旨
H- CDM8039
CD/MP3/WMA – RECEIVER CD/MP3/WMA -
Instruction manual
ページ2に含まれる内容の要旨
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents ................................................................................................................................................................ 2 Important safeguards....................................................
ページ3に含まれる内容の要旨
Important safeguards Read carefully through this manual to familiarize yourself with this high-quality sound system. Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may cause serious damage to the unit. Do not attempt to disassemble the unit. Laser beams from the optical pickup are dangerous to the eyes. Make sure that pins or o
ページ4に含まれる内容の要旨
Accessories Mounting parts Receiver 1 pc Front panel 1 pc Front panel case 1 pc Customer information 1 pc Warranty card 1 pc Instruction manual 1 pc 4
ページ5に含まれる内容の要旨
Installation/Connections Use only the supplied mounting hardware for a safe and secure installation. Be sure to remove the front panel before installing the unit. Mounting angle adjustment Adjust the mounting angle to less than 20°. Installation in the dashboard Note: Keep the release key in a safe place as you may need it in the future to remove the unit from the car. 5
ページ6に含まれる内容の要旨
1. Unit 2. Release case 3. Dash board 4. Hex nut 5. Lock washer 6. Plain washer 7. Car body 8. Rear support strap 9. Tapping screw 10. Hex bolt 6
ページ7に含まれる内容の要旨
Electrical connections 7
ページ8に含まれる内容の要旨
ISO connector Location Function Connector A Connector B 1 Rear Right(+)---Violet 2 Rear Right(-)---Violet/Black stripe 3 Front Right(+)---Grey 4 Battery 12V (+)/yellow Front Right(-)---Grey/Black Stripe 5 Power Antenna/blue Front Left(+)---White 6 Front Left((-)---White/Black Stripe 7 ACC+/red Rear Left(+)---Green 8 Ground/black Rear Left(-)---Green/Black Stripe 8
ページ9に含まれる内容の要旨
Panel controls Front panel 1. POWER button 2. SEL button 3. VOL knob 4. Preset stations (1,2,3,4,5,6) 5. AF button 6. TA button 7. PTY button 8. DISP button 9. MODE button 10. BND button 11. PREVIOUS/NEXT button 12. A/PS button 13. SCN button 14. MUTE/DUAL ILLUMINATION button 15. LCD display 16. OPEN button 17. CD slot 18. EJECT button 19. PAUSE button 20. INT button 21. RPT button 22. RDM button 23. 24. + 10/ -10 TRACK SEARCH DOWN/UP button 9
ページ10に含まれる内容の要旨
25. USB jack 26. SD/MMC slot 27. RESET button 28. Status indicator light Note: Pressing the RESET button will erase the clock setting and stored stations. Panel status indicator lights up when you slide the panel down; flashes when you remove the panel. 10
ページ11に含まれる内容の要旨
General operations Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press OPEN button on the panel to open the panel and press the RESET button with thin hard object to restore the unit to the original factory settings. Power ON/OFF Press any button to turn the unit on. Press and hold POWER button to turn off the unit. Note: After the unit is off, the volume level and radio current settings will be memorized, and when you turn the
ページ12に含まれる内容の要旨
Mute Press this button to mute the sound at once. Press again to return to the previous volume level. Dual illumination When press the MUTE button for more than 2 seconds, it is activated as selecting Green or Red buttons illumination. Volume control/select Rotating this knob, you can adjust VOL/BASS/TREB/BAL/FAD. To select the functions, press the VOL knob shortly until the desired functions are shown on the display. Increase or decrease the volume by turn the VOL knob right or left. These butt
ページ13に含まれる内容の要旨
During MASK DPI mode, the unit will mask only the AF which has different PI, this is the default mode; during MASK ALL mode, the unit will mask the AF which has different PI and no RDS signal with high field strength. RETUNE S/L - SHORT/LONG “RETUNE” refers to the time period the unit allows for radio scan when reception is interrupted. “S” represents a time period of 30 seconds and “L” represents a time period of 90 seconds. AUDIO DSP CONTROLS Choose equalizer mode: POP M => ROCK M => CLASS M=>
ページ14に含まれる内容の要旨
SUBWOOFER MODE Choose the Subwoofer On or OFF. ESP (Electronic Shock Protection) MODE Note: 10 sec./40 sec. for CD, 120 sec. for MP3 automatically works. MULTI CD SELECTION Choose CD MULTI ON or OFF. CD MULTI ON: Read multi section CD. CD MULTI OFF: Read first section only. BEEP MODE 14
ページ15に含まれる内容の要旨
BEEP ON: BEEP sound can be heard from speaker when the buttons are pressed. SEEK MODE SEEK 1: When SEEK 1 mode is activated, AUTO SEEK SCAN is stopped when station is detected even user still push SEEK button. SEEK 2: Auto SEEK SCAN is not stopped even station is detected if user pushes SEEK button. When releases SEEK button, then stop when station is detected. STEREO/MONO When FM stations are weak and are disturbed, listening can be improved by selecting MONO. LOCAL/DX “Local” position in areas
ページ16に含まれる内容の要旨
Digital tuner operations Note: RDS (Radio Data System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either. MODE Press MODE button to turn on tuner mode. BAND (BND) Press BND button. Each band is toggled cyclically by pressing this key FM1--FM2--FM3--FM(OIRT)--MW1(AM1)-- MW2(AM2). AUTOMATIC OR MANUAL TUNING (FREQ UP- NEXT button or FREQ DOWN - PREVIOUS button) When pressed shortly, these buttons are
ページ17に含まれる内容の要旨
TA (TRAFFIC ALARM) FUNCTION Briefly press the TA button to turn on or turn off the TA function. When TA is enabled (on), the tuner starts searching the traffic announcement. AF (ALTERNATIVE FREQUENCIES) FUNCTION Briefly press the AF button to turn on or turn off the AF function. The RDS program will be automatically searched and received. The unit will search another frequency with this RDS program. PTY (PROGRAM TYPE) FUNCTION When PTY is selected the radio starts to search corresponding PTY i
ページ18に含まれる内容の要旨
CD/SD/MMC/USB operations Discs for playback This unit can play disc types: CD/CD-R/-RW. Compatible with formats: CDDA/MP3/WMA. Loading and ejecting a disc 1. Turn the power on. 2. Press the OPEN button on the panel. 3. Insert the disc with the printed side facing upward into the slot. 4. Press EJECT button on the inner side to eject the disc. Multi-media card MMC/SD card slot Support MP3/WMA ID3 format music only. Carefully insert the SD/MMC card into the card slot on the front panel. Unit start
ページ19に含まれる内容の要旨
4. Tag (id3tag ver2.0) - Title/ Artist/ Album: 32 byte support. 5. Multi card reader not support. 6. USB 2.0 support. Note: USB format supports 2.0. Capacity: up to 2 GB. SD cards brands: Cannon, Fuji film, Palm, Motorola, Microsoft, IBM, HP, Compaq, Sharp, Samsung, etc. Capacity: up to 2 GB. MMC cards brands: Ericsson, Nokia, Motorola, HP, Palm, Sanyo, Microsystems, etc. Capacity: up to 2 GB. Note: Because of the great variety of products with SD and MMC card slots and their sometimes quite man
ページ20に含まれる内容の要旨
INTRO (Preview all Tracks) When this button is pressed, “INT ON” indication is displayed and the first several seconds of each track of the disc is played. Press again to stop intro and listen to track. REPEAT When RPT button is pressed, “RPT ON” indication is displayed and playback of the selected track will be continually repeated until the track repeat mode is cancelled by pressing RPT button again. RANDOM When RDM button is pressed, “RDM ON” indication is displayed and each track of the disc
