ページ1に含まれる内容の要旨
PLD57MU
OWNER'S MANUAL
Mobile Video System
Motorized Slide Down And Detachable Panel
3.6 Inch Wide TFT Color Monitor
Car DVD/VCD/CD/MP3 Player
AM/FM Digital Pll Tuning Radio
MPEG4 Player
USB Connect
Remote Control
www.pyleaudio.com
ページ2に含まれる内容の要旨
CONTENTS Safety Information...................................................................................... 2 Disc Notes ................................................................................................. 3 Installation ................................................................................................. 4 Change Angle ............................................................................................. 7 Electric Connection ...............................
ページ3に含まれる内容の要旨
SAFETY INFORMATION CAUTION: THIS DVD PLAYER IS A CLASS I LASER PRODUCT. HOWEVER THIS DVD PLAYER USES A VISIBLE/INVISIBLE LASER BEAM WHICH COULD CAUSE . HAZARDOUS RADIATION EXPOSURE IF DIRECTED. BE SURE TO OPERATE THE DVD PLAYER CORRECTLY AS INSTRUCTED. USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF. REFER SERVICING TO QUALIFIED PERSONNEL. WARNING: TO REDUCE THE
ページ4に含まれる内容の要旨
DISC NOTES Disc formats supported by this unusable) depending on your handle it and conditions in the usage environment. player Note these scratches are not an DVD VIDEO indication of any problem with the player. 12 cm disc Label side (Single-sided disc only) up Video CD 12 cm disc CD Do not touch the 12 cm disc underside MP3 of the disc M MP P 3 CD-RW 12 cm disc Do not bend Discs which cannot be played with this player DVD-ROM DVD-R/DVD-RAM Wipe the disc from CDV center toward the outside CD-G
ページ5に含まれる内容の要旨
INSTALLATION NOTES: Choose the mounting location where the unit will not interfere with the normal driving function of the driver. Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. Consult with your nearest dealer if installation requires the drilling of holes or oth
ページ6に含まれる内容の要旨
INSTALLATION DASH BOARD HEX NUT METAL MOUNTING STRAP SPRING WASHER CONSOLE PLAIN WASHER SLIDE BRACKET TAPPING SCREW HOUSING HEX BOLT KEY PLATE PLASTIC COVER KEY PLATE If you want to take CHASSIS out of the SLIDE BRACKET HOUSING, first remove the PLASTIC COVER of the both sides away, then insert the two KEY PLATE into left and right side of chassis as above illustration. 5
ページ7に含まれる内容の要旨
INSTALLATION How To Remove And Install The Front Panel When detaching or attaching the control panel, be careful not to damage the connectors on the back of the control panel and on the panel holder. Detaching The Control Panel Before detaching the control panel, be sure to turn off the power. 1.Press the release button and the left hand side of the front panel will release. (FIG. 1) 2.Pull-off the front panel (FIG. 2) and keep the front panel into the case (FIG. 3) Install The Front Panel First
ページ8に含まれる内容の要旨
CHAGNE ANGLE CHANGING THE CONTROL PANEL ANGLE When you want to change the viewing angle of the operating unit to play, you can press the (angle)button repeatedly to select the desired angle as follows: Angle 1 Angle 2 Angle 4 Angle 3 Caution: Do not insert your finger behind the control panel. 7
ページ9に含まれる内容の要旨
ELECTRIC CONNECTION WIRING CONNECTION MAIN UNIT (B+)12V WHITE REAR CAMERA SWITCH GREEN (B-)PARKING BRAKE YELLOW REAR CAMERA INPUT AUX(optional) VIDEO IN YELLOW ANTENNA CONNECTOR RCH IN RED LCHINWHITE RCA CABLE GREY SUBWOOFER VIDEO OUT 2 YELLOW IGNITION RED COAXIAL OUT BROWN SWITCH(B+) REAR RCA OUTPUT CABLE (optional) RCH RED CHOKE MEMORY YELLOW BOX BACK-UP(B+) LCH WHITE FRONT RCA OUTPUT CABLE FRONT RCA RED R BLACK VIDEO OUT 1 YELLOW GROUND(B-) FRONT RCA WHITE L (FOR RCA LINE OUT VERSION ONLY) FU
ページ10に含まれる内容の要旨
REMOTE CONTROL 15 16 3 17 7 5 19 20 2 13 1 21 6 23 ENTER 14 9 22 18 12 24 11 10 25 4 8 1. CLK Press it to change the display to clock display. 2. MODE Press it to change between RADIO ,DISC and AUX IN mode. 3. STOP Press it to stop playback. 4. SETUP Display the SETUP menu. 5. MO/ST(AUDIO) In radio mode, press it to select STEREO or MONO mode (In disc mode, press it to changing of the AUDIO soundtrack on multi- audio soundtrack DVD disc. Changing of the sound mode of the VCD/CD disc) 6. SUBTITLE
ページ11に含まれる内容の要旨
REMOTE CONTROL Preparing the Remote Control Inserting the Batteries 1.First push to inside as the direction indicated by the arrow (See 1 )And then Remove the battery holder as the direction indicated by the arrow (See 2 ). 2.Replace the battery Set a new battery property with (+)side up as illustrated (See ). 3 3.Insert the battery holder. Push in the holder to the original position(See 4 ). Using the Remote Control Face the remote control towards the player front face IR mark (remote control s
ページ12に含まれる内容の要旨
BASIC OPERATION 15 14 11 6 13 1 3 18 5 10 SEL 4 12 8 16 2 9 17 7 1.REL BUTTON Press the REL button to detach the removable front panel. 2.PWR On/Off BUTTON Press this button to switch the device On, WELCOME appears in the display. Press it again to switch the device Off, SEE YOU appears in the display. 3-4.VOL+/VOL- & SEL BUTTON Press SEL() 4 button briefly to across the sound/picture mode selection menu by repeatedly pressing the SEL button you can select the individual menu items such as volum
ページ13に含まれる内容の要旨
BASIC OPERATION 6. EQ BUTTON Swing the SEL knob in the direction of the EQ to turn to equalization function and to select desired audio mode. There are four kinds of mode as below: JAZZ CLAS POP ROCK 7. APS/DISP BUTTON In Radio Mode: a) Memory function: swing the SEL knob in the direction of APS/DISP for approximately 2 seconds to active automatic station storage. The radio searches within the current frequency band, e.g. FM1, for the strongest station are then allocated to the corresponding sto
ページ14に含まれる内容の要旨
BASIC OPERATION To wind through the tracks keep the SEL button pressed in the or direction for about 2 seconds. FF X2 appears in the display. Operating the SEL button again, the speed of rapid forward/reverse changes according to the disc as follow: DVD/VCD/CD/MP3: Normal Playback 2x 4x 8x 16x b) In Radio Mode: Move the SEL button in the direction of or in order to set a radio station manually. Keep the SEL taste pressed down in the or direction in order to start the search for a radio station a
ページ15に含まれる内容の要旨
BASIC OPERATION TOP/RPT/INT/RDM FUNCTION (Only for the RC.) A.To memorize the current frequency, press any one of the six preset buttons[1-6] on the remote controller hold for more than 2 seconds. B.To recall the preset memory, press one of the preset buttons [1-6]. C.Press 1/TOP button to select the first track/chapter to play. a. In the state of VCD/CD/MP3 disc playing, press the button to select the first track/chapter to play.(depend on the disc used for VCD) b. In the state of DVD disc play
ページ16に含まれる内容の要旨
Headphones port BASIC OPERATION MP3/WMA/JPEG DISC PLAY 1.When inserting an MP3/WMA/JPEG disc. Ex: When Mp3 file is detected. 4 56 1 .Current track(file)(highlighted bar) .Current track (file) number/total 2 3 00:56 04:07 number of tracks(files) in the current Repeat one 2 003/112 folder. 3 .Elapsed playing time of the current track(not available for JPEG disc) Mp3 K P 4 .total playing time.( not available for 1 Mp3 woman 1 JPEG disc) .Selected playback mode 5 Mp3 new ton .Operation mode icon. (P
ページ17に含まれる内容の要旨
BASIC OPERATION TFT MONITOR OPERATION Press SEL() 4 button briefly to across the sound/picture mode selection menu by repeatedly pressing the SEL button you can select the individual menu items such as volume, bass, treble, balance, fader, color, bright, contrast and tint . Then rotate the VOL + / - to adjust the selected mode. (The corresponding value will show on the display.) When mode has not been adjusted for several seconds, display returns to normal radio or CD display. Volume Bass Treble
ページ18に含まれる内容の要旨
BASIC OPERATION USB Operation On-Screen Display Function A.Plug the USB connect line to the USB Press the OSD button during playback to display the contents of the current socket (see number 17) of the unit disc on the screen. properly,(See fig.1) when the USB A.Example for DVD: appliance connect to the USB port of a.Press OSD for the first time: the connect line, the system star playing track of the USB appliance TITLE ELAPSED automatically. TT 01/01 CH 01/38 0:02:06 B. IN USB playing , you can
ページ19に含まれる内容の要旨
BASIC OPERATION e.Press OSD for the fifth time: Notes: - The language number is different The message on the screen will be according to the disc. cleared for SVCD and VCD. - Some discs only contain one subtitle C.Example for MP3: language. Each time OSD is pressed, the - When no different subtitle language message displayed on screen changes are recorded, will be displayed as follows: at screen left top corner. SINGLE ELAPSED SINGLE REMAIN Multi-angle Function Multi-audio Language Function (for
ページ20に含まれる内容の要旨
SETUP GENERAL SETUP --- GENERAL PAGE --- DOLBY DOLBY -----General setup page---- -----General setup page---- TV Display LB TV Display Normal/PS ON Normal/LB Angle Mark Angle Mark OSD Lang ENG OSD Lang Wide SPDIF/RAW Spdif Output Spdif Output ON Captions Captions Screen Saver ON Screen Saver Last Memory Last Memory ON Go To General Setup Page Set TV Display Mode TV Screen 1. Press SETUP button on the remote Video Wide(16:9) Material Normal Pan Scan Letter-box control . 4:3 2.The SETUP menu is dis
