ページ1に含まれる内容の要旨
V-DV800BT
CD/MP3 receiver with Bluetooth CD/MP3- c Bluetooth
Instruction manual
ページ2に含まれる内容の要旨
V-DV800BT Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents...................................................................................................................................................................................................... 2 Important safeguards ....
ページ3に含まれる内容の要旨
V-DV800BT Important safeguards Using the device at temperature below -10º may cause the breakage of the device. Before using please heat up the passenger compartment to the recommended temperature! Read carefully through this manual to familiarize yourself with this high-quality sound system. Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amper
ページ4に含まれる内容の要旨
V-DV800BT Accessories Receiver Remote control Steering remote control ISO connector Instruction manual Consumer information Warranty card 2 x Removal/Release keys 1 x 5 mm Nut 1 x Spring washer 1 x 12mm Screw 1 x Mounting/Support strap 1 x Plain washer USB extension cable 4
ページ5に含まれる内容の要旨
V-DV800BT Installation/connection Din front-mount (method 1) After inserting the holder into the dashboard, select the appropriate tab and bend them inwards to secure the holder in place. Insert fingers into the groove in the front of frame and remove it. Insert the levers supplied with the unit to the grooves at both sides. The unit can be installed or removed from the dashboard. 1. Dashboard 2. Spring washer 3. Screw (4 x 12 mm) 4. Screw 5. Strap 6. Plain washer Removing the unit frame Ins
ページ6に含まれる内容の要旨
V-DV800BT Din rear-mount (method 2) Installation using the screw holes at both sides of the unit. 1. Select a position where the screw holes of the main unit are fitted for aligned, and tighten the screws at 2 positions at each side. Use either truss screws (5 x 5 mm), depending on the shape of the screw holes in the bracket. 2. Screw. 3. Factory radio mounting bracket. 4. Dashboard or Console. 5. Hook (Remove this parts). Note: The mounting box, outer trim ring and the half-sleeve are not used
ページ7に含まれる内容の要旨
V-DV800BT Detach the unit Removing the panel Attaching the panel 1. Turn the power off 1. Attach the panel at the right side first, with point B on the main 2. Press the D.C.P. release button unit touching point A on the D.C.P. (As shown on the diagram). 3. Remove the D.C.P. 2. Then press the left side of D.C.P. onto the main unit until a “click” sound is heard. Note: DO NOT insert the D.C.P from the left side. Doing so may damage it. The D.C.P can easily be damaged by shocks. After removing it,
ページ8に含まれる内容の要旨
V-DV800BT Electrical connections 8
ページ9に含まれる内容の要旨
V-DV800BT Using the ISO Connector 1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated. 2. For connections without the ISO connectors, check the wiring in the vehicle carefully before connecting, incorrect connection may cause serious damage to this unit. Cut the connector, connect the colored leads of the power cord to the car battery as shown in the color code table below for speaker and power cable connections. Pin Wire color Function/Label A4 Yell
ページ10に含まれる内容の要旨
V-DV800BT Panel controls Front panel 1. POWER/MUTE button 2. VOLUME knob/AUDIO/ENTER button 3. TA button 4. BAND/ERASE/CLEAR button 5. PAU/1 number button 6. STOP/2 number button 7. RPT/3 number button 8. RDM/4 number button 9. FOLDER UP/5 number button 10. FOLDER DOWN/6 number button 11. PREVIOUS button 12. NEXT button 13. PTY/X-BAS button 14. AF/SUB-W button 15. USB slot 16. EJECT button 17. MENU/DISP button 18. AS/PS/OSD button 19. DISC slot 20. AV in (AUX in) 21. OPEN button 22. MODE/TRANSFE
ページ11に含まれる内容の要旨
V-DV800BT Remote controller (RC) 1. POWER/MUTE button 2. EJECT button 3. AUDIO button 4. MODE (TRANSFER) button 5. VOLUME + button 6. VOLUME - button 7. 2-ZONE ON/OFF button 8. FAST FORWARD /TUNE UP button 9. FAST REWIND /TUNE DN button 10. Cursor LEFT button 11. Cursor RIGHT button 12. Cursor UP button 13. Cursor DOWN button 14. NEXT/SEEK UP button 15. PREVIOUS/SEEK DN button 16. OK button 17. PLAY/PAUSE button 18. STOP button 19. 1 number button 20. 2 number button 21. 3 number button 22. 4 nu
ページ12に含まれる内容の要旨
V-DV800BT 27. 9/IX-BASS number button 28. 0/BAND number button 29. +10 button 30. DVD MENU/PBC button 31. SET UP button 32. REPEAT button 33. ZOOM button 34. DVD OSD button 35. GOTO button 36. SUBTITLE button 37. TITLE button 38. DVD AUDIO button 39. ANGLE button 40. DISPLAY/MENU button 12
ページ13に含まれる内容の要旨
V-DV800BT Battery information of RC 1. Press the catch and at the same time pull out the battery tray. 2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing upward. Insert the battery tray into the RC. Warning: Store the battery where children cannot reach. If a child accidentally swallows the battery, consult a doctor immediately. Do not recharge, short, disassemble or heat the battery or dispose it in a fire. Do not expose or bring into contact the battery
ページ14に含まれる内容の要旨
V-DV800BT Steering wheel remote control (SRC) Important safeguards Install this SRC as required by this manual. Failure to do so may cause an accident. Do not install this SRC near the doors where rainwater is likely to be spilled on the unit. Incursion of water into the SRC may cause smoke or fire. Do not install this SRC in such a place as may obstruct the drive’s view. Since interior layout differs depending on the type of vehicle, the ideal installation location for the SRC also differs.
ページ15に含まれる内容の要旨
V-DV800BT Operation buttons 1. MUTE button 2. BAND button 3. NEXT/PREVIOUS buttons 4. A (AUDIO) button 5. EJ (EJECT) button 6. DISP button 7. VOLUME+/VOLUME- buttons 8. PLAY/PAUSE button 9. MODE button Battery changing In order to ensure proper functioning of the steering wheel remote control, please make sure only use Lithium CR2025 Battery. If the receiver being controlled no longer responds to any key press even under favorable circumstances please replace the battery of the remote control.
ページ16に含まれる内容の要旨
V-DV800BT WARNING: Avoid installing this SRC in such a location where the operation of safety devices such as airbags is prevented by this SRC. Avoid installing this SRC in such a location where the operation of the steering wheel and the gearshift lever may be prevented. Otherwise, it may result a traffic accident. Fix this SRC securely to the steering wheel with the belt attached to the SRC. If this SRC is loose, it disturbs driving stability, which may result in a traffic accident. Do not
ページ17に含まれる内容の要旨
V-DV800BT Basic operations Loading a CD Insert a CD into the disc slot, the CD will be automatically loaded and playback will begin. Ejecting a CD Press EJECT button to eject a CD. If the ejected CD is not being removed, after 10 seconds it will be reloaded automatically. Power ON/OFF Press POWER button or any other button on the front panel (except OPEN/EJECT) to turn the unit on. Press and hold POWER button to turn the unit off. Mute Press POWER button on the unit or MUTE button to mute the au
ページ18に含まれる内容の要旨
V-DV800BT iX-bass Press and hold PTY/X-BASS button to turn on the X-Bass function, and "ix-Bass ON" will appear on the display for 3 seconds. Press and hold X-Bass button again to turn this function off. Please refer to the related description in "Audio Menu of X-Bass" for details operation of X-Bass control. The X-Bass Boost Level control will only appear in the Audio Menu only if the X-Bass function is currently activated. Mode Press MODE button to select a different mode of operation as indic
ページ19に含まれる内容の要旨
V-DV800BT Reset To Reset the Main Unit System After releasing the front panel, use a pencil or any non-metallic object to press and hold RESET button for 5 seconds to reset the main unit; the unit will return to the factory default settings. To Reset the DVD Setting Press SET UP button on the RC or press and hold AS/PS button to bring up the Setup Menu; select “Misc” then select “Use default settings”, the DVD Setting will resume to factory default value. 19
ページ20に含まれる内容の要旨
V-DV800BT System menu operation You can adjust the system setting in this unit by entering into the system menu, please read the below details operation for each system menu items: Access into System Menu Function List Press and hold DISP/MENU button for more than 3 seconds to enter the system menu items. Navigate through the menu items by repeatedly pressing DISP/MENU button to move to the next or previous option. Once the needed option appears on the display, Rotate the VOLUME knob or press VO
