ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
FCC Warning The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with radio communications. However, there is no guarantee that radio interfe
ページ3に含まれる内容の要旨
Table of Contents English Español FCC Warning .................................................... 2 Advertencias FCC ........................................ 36 Owner’s Record ................................................ 2 Registro del Propietario ................................ 36 Features ............................................................ 4 Características..............................................37 Precautions ....................................................... 4 Preca
ページ4に含まれる内容の要旨
ENGLISH Features Congratulations on your purchase of this Blaupunkt Cassette Receiver. Its Codem III-US FM/AM Tuner and Autoreverse Cassette Tape Player mechanism provide the ultimate in radio sound reproduction. Its high-power amplifier and 4-Channel preamp output provide you with tremendous system configuration flexibility. • Codem III-US Tuner Features: • Audio Features: – Multipath Management – ASU Electrical Impulse Noise Reduction – 30 Watts x 4 Channel Integrated Amplifier – Dual-Level Fa
ページ5に含まれる内容の要旨
E Detachable Face N Detaching & Attaching the Face: The face of this unit can be detached and taken with you to prevent it from being stolen. G Detaching the Face: L Press the REL (Release) Button and detach the face by gently pulling it off as illustrated. I Note: Do not pull it straight out from the chassis. Be sure not to drop the face when detaching it S from the chassis. H Attaching the Face: Apply the right hand side of the face to the chassis by sliding (part B) of the face to (part A) at
ページ6に含まれる内容の要旨
Electrical Connections and Installation @/@! To avoid the aggravation of costly mistakes and serious damage that could make you feel this way, please carefully read all of the instructions before you begin. Carefully follow all instructions. You’ll be glad you did! GENERAL RECOMMENDATIONS • If you’re not confident that you can install the unit correctly, have it installed by a qualified Blaupunkt installation technician. • Use this unit only with negative ground 12 Volt (11-16 Volt) direct
ページ7に含まれる内容の要旨
each have at least 8 ohms impedance. • DON’T connect the left and right speaker leads to each other or to the same speakers. • DON’T connect the front and rear speaker leads to each other or to the same speakers. • DON’T connect the negative speaker leads to each other. • DON’T connect the positive speaker leads to each other. • DON’T connect any active speakers (with built-in amplifiers) to the speaker leads unless their owner’s manuals specifically state that this is O.K. • Cover the ends of a
ページ8に含まれる内容の要旨
Installation Recommendations • Carefully choose the mounting location so that the unit won’t interfere with normal driving. • Avoid mounting locations where the unit would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would subject to dust, dirt or excessive vibration. • The illustration below shows a typical installation, however, you may need to adjust the installation, depending on the unit. If you have questions or need additional insta
ページ9に含まれる内容の要旨
Mounting the Unit in a Japanese Car You may have difficulty mounting this unit in some Japanese cars that have ISO mounting features (side-bracket mounting systems). In this case, consult your Blaupunkt dealer. 1 Run a blade along the slits on the back of the front trim ring, unscrew the two side screws, and separate it from the unit. Save the trim ring and related hardware in case you ever want to install the unit in another vehicle. 2 Use the vehicle’s own mounting hardware to attach the unit.
ページ10に含まれる内容の要旨
Maintenance Removing the Unit Use the Release Keys as shown below. Keep them in a safe place in case you need them in the future. Fuse Replacement When replacing the fuse, be sure to use one with the correct amperage, which will be stated on the fuse case. Never use a fuse that has a stated amperage exceeding the one supplied for this unit, as this could cause malfunction and serious damage to the unit. 10
ページ11に含まれる内容の要旨
Specifications Audio Power Specifications Power Output and Total Harmonic Distortion: 13 watts per channel minimum continuous average output into 4 ohms, 4 channels driven, from 30-15,000 Hz with no more than 1% total harmonic distortion. Other Specifications Tuner FM Tuning Range: 87.5 - 107.9 MHz Intermediate Frequency: 10.7 MHz FM Mono Sensitivity: 13 dBf Seek lo sensitivity: 51 dBf Seek sensitivity 31 dBf Selectivity: 80 dB at 400kHz Signal-to-Noise Ratio: 65 dB (stereo), 70 dB (mono) Harmon
ページ12に含まれる内容の要旨
Location of Controls 1. REL (Release) Button Balance Right 2. PWR (Power) Button Fade to Rear 3. Source (and Radio Band) Select 14. /\ Button 4. Cassette Eject Seek and Manual Tuning 5. Mute/ Audio Button/ Clock Adjust:00 Clock Hours 6. SCA (Scan) TS (Travel Store) 15. V Button 7. LD (Loudness)/ SENS (Tuning Sensitivity) Seek and Manual Tuning 8. Cassette Insertion Slot Clock Minutes 9. CLK/Display Change 16. FM/AM Presets 10/11. Tape Program Change (reverse) 17. Dolby B Noise Reduction 10. Fa
ページ13に含まれる内容の要旨
Ignition-Off Clock Recall Any button press while ignition off displays time for about 8 seconds. Ignition-On Unit lights up and clock is displayed. Release for Detachable Faceplate Push REL to detach face. Already-inserted cassette remains in unit. Current settings and source mode are stored. If power was not switched off before face removed, unit will automatically power- on when face is reattached. Power (PWR) On/Off When ignition on, press PWR or insert a disc to turn unit on. Last-used sourc
ページ14に含まれる内容の要旨
Bass -Adjust from +7 to -7 at 2 dB/step using + to increase bass, - to decrease. Treble - Adjust from +7 to -7 at 2 dB/step using + to increase treble,- to decrease. Balance - Adjust balance from 9 (all the way left) using + to -9 (all the way right) using –. Fader - Adjust fader from 9 (sound only from the front) using + to -9 (sound only from the rear) using –. Loudness (LD) Press LD to increase sound of low and high frequencies. LOUD icon appears. To cancel, press LD again. Radio Operation La
ページ15に含まれる内容の要旨
Δ seconds to store current frequency. Audio is muted during storage, preset number appears, and beep acknowledges storage. Preset Station Selection Press desired Preset Button. Travel Store This feature allows you to automatically store stations onto all 5 preset buttons and is especially useful when traveling outside your normal listening area. In any FM Bank, press SCA/TS for 2 seconds to activate FM Travel Store. (In AM Bank, press it for 2 seconds to activate AM Travel Store.) TS appears. Be
ページ16に含まれる内容の要旨
Auxiliary Input Jack Connect other audio equipment, such as a portable DAT player, through the 1.2 volt/3.5 mm pigtail connector. Access auxiliary equipment output by pressing SRC until “InP” appears. Adjust volume, bass, and treble settings through head unit. Troubleshooting Guide The following check will assist in the correction of most problems which you may encounter with your unit. Before going through the check list below, refer back to the connection and operating procedures. General
ページ17に含まれる内容の要旨
German Headquarters: Blaupunkt-Werke GmbH Postfach 77 77 77 D-31132 Hildesheim Germany Robert Bosch Corporation Sales Group — Blaupunkt Division 2800 South 25th Avenue, Broadview, Illinois 60153 1-800-950-BLAU Robert Bosch, SA., DE, C. V. Dr. Lucio 270 Cols. Doctores, Mexico 06720 Made in Malaysia Fabrique en Malasie Hecho en Malasia Fabricado en Malaysia Copyright 1997 by the Robert Bosch Corporation No portion of this work may be reproduced in any form without the written consent of the Robert
