ページ1に含まれる内容の要旨
PTID-3600/ PTID-3600T
In-Dash 3.6” Monitor
Touch Sensor
DVD/CD/MP3/MP4
MW/FM Radio
Built-in TV tuner
Owner’s Manual
Take the time to read through this owner’s manual.
Familiarity with installation and operation procedures will help you obtain the best
Performance from your new DVD-receiver.
ページ2に含まれる内容の要旨
Table of Contents Table of Contents.......................................................................................................................1 Important Safeguards.................................................................................................................2 Accessories .......................................................................................................................3 Installation/Un-Installation .....................................
ページ3に含まれる内容の要旨
Important Safeguards Using the device at temperature below -10 ℃ may cause the breakage of the device. BEFORE USING PLEASE HEAT UP THE PASSENGER COMPARTMENT TO THE RECOMMENDED TEMPERATURE! Read carefully through this manual to familiarize yourself with this high-quality sound system. Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher a
ページ4に含まれる内容の要旨
Accessories Package contains the following accessories for installation and operation of the unit. (1) Washer, Spring 1 each Washer, M5 Nut (2) Mounting Strap 1 (3) Screw 1 (4) Bolt 4 (5) Mounting Collar 1 (6) Release Key 2 (7) Rubber Cushion 1 AV in Cable Panel Carrying Case
ページ5に含まれる内容の要旨
Installation/Un-Installation First complete the electrical connections, and then check them for correctness. Installation This unit can be installed in any dashboard having an opening as shown on the picture. The dashboard should be 4.75 – 5.56 mm thick in order to be able to support the unit. 1. Insert mounting collar into the dashboard, and bend the mounting tabs out with a screwdriver. Make sure that lock lever （ ※ ）is flush with the mounting collar (not projecting outward).
ページ6に含まれる内容の要旨
Wiring Connections Make sure you have good chassis ground. A good ground connection will eliminate most electrical noise problems. A good chassis ground requires a tight connection to the vehicle’s metal chassis. The area around the ground connection should be clean, bare metal without rust, paint, plastic, dust, or dirt for a good electrical connection. **TV antenna is for PTID-3600T only. Caution: Do not interchange the connection of the wiring!!! For some car models
ページ7に含まれる内容の要旨
Detachable Control Panel Detaching the control panel Turn the Power off. Press OPEN button release the panel. Pull the panel out. Attaching the control panel Insert the left side of the control panel into the main unit. Press the control panel right side until the “click” sound is heard. Caution: DO NOT insert the control panel from the right side. It can damage the control panel. The control panel can easily be damaged by shocks. After removing it, place it in a pro
ページ8に含まれる内容の要旨
Panel Controls Front panel 1. AUX IN 2. POWER/ MUTE 3. IR sensor 4. AS/PS 5. SEL 6. VOL + 7. PLAY/PAUSE 8. MENU 9. TFT display 10. OPEN 11. MODE 12. PREVIOUS 13. VOL 14. OK 15. NEXT 16. BAND 17. USB 18. Memory Card slot 21. RESET 19. EJECT button 22. Flashing LED 20. Disc slot Page - 7
ページ9に含まれる内容の要旨
IR Remote Control 1. MODE 2. POWER 3. BND/RDM 4. ENTER 5. Cursor / / / 6. STEREO/MONO 7. LOC/ PROG 8. P.SCN/RPT 9. SEEK-/ 10. LOUD 11. OSD 12. STOP/ PBC 13. Digit 0-9 14. 15. MUTE 16. MENU 17. SUB-T 18. SETUP 19. ANGLE 20. INT 21. VOL+ 22. A-B/ZOOM 23. SEL 24. SEEK+/ 25. VOL- 26. AUDIO/ GOTO REPLACING THE BATTERY Remote Control comes with a CR-2025 Lithium Battery included. 1. Remove the Batter
ページ10に含まれる内容の要旨
Do not re-charge, short, disassemble or heat the battery or dispose it in fire. Do not expose or bring into contact the battery with other metallic materials. Doing this may cause the battery to give off heat, crack or start a fire. When throwing away or saving the battery, wrap it in tape and insulate; otherwise, the battery may give off heat, crack or start a fire General Operations Reset the Unit In case the unit is malfunctioned or need to reset to factory default setting, pre
ページ11に含まれる内容の要旨
Audio Setting Press SEL button on the Remote Control to select the audio setting (or on front panel, long press SEL button in radio mode, short press SEL button in other mode to select the audio setting) BASS =>TREBLE => BALANCE => FADER => EQ. Press / buttons on remote to select the audio setting item (or press the VOL knob on front panel to select the setting item). Press ENTER button or button on remote control or OK button on front panel to enter the selected item. Press / butt
ページ12に含まれる内容の要旨
PICTURE MENU MENU DESCRIPTION RED Adjust level of red color. Support 50 levels. Default level is 25. GREEN Adjust level of green color. Support 50 levels. Default level is 25 BLUE Adjust level of blue color. Support 50 levels. Default level is 25. BRIGHTNESS Adjust level of screen brightness. Support 50 levels. Default level is 25 CONTRAST Adjust level of screen contrast. Support 50 levels. Default level is 25. SHARPNESS Adjust level of screen sharpness. Support 15 levels. Default
ページ13に含まれる内容の要旨
Digital Tuner Note: Memory Card /USB service availability varies with areas. Please understand if Memory Card /USB service is not available in your area, the following service is not available, either. Band selection Press MODE button to select the RADIO mode. Press the BAND button to select the desired band: FM1=> FM2 => FM3 => MW STEREO/MONO In FM mode, press SETREO/MONO button on remote control to select stereo or mono sound reception. LOC/DX Press LOCAL button on remote
ページ14に含まれる内容の要旨
Memory CARD To play MP3/ MP4/ WMA files on a Memory CARD, insert the card into the card slot (you should press the OPEN button on the panel to flip down front panel and insert the card into card slot.) The unit will start playing MP3/ MP4/ WMA files on the Memory card memory automatically. Or press the MODE button to select Memory Card after pressing POWER Button to turn on the unit. PAUSE/ PLAY Press the PLAY/ PAUSE button to pause the playback. Press the button again to resume.
ページ15に含まれる内容の要旨
Random Press the RDM button on remote to play all song tracks in random order. Press and hold for two seconds to play all album tracks in random order. Press again to cancel. Note: This function is only for audio files. Intro Playback Press the INT button on remote to play the beginning of every track for 10 seconds in sequence. Press again to cancel INT play. Note: This function is only for audio files. Programming the Playback 1. Press PROG button on the remote open program me
ページ16に含まれる内容の要旨
Discs operations Glossary PBC (Play Back Control) Play Back Control is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image. Title The title is the important part of DVD disc. The memory volume of the disc is rather big, that makes possible to record several films on one disc. For example, if a disc
ページ17に含まれる内容の要旨
Loading a disc 1. Turn the power on. 2. Press the Open button on the front panel to flip it down. 3. Insert the disc with the printed side facing upward into the slot. The panel will be closed automatically. The DVD mode will be turned on automatically. The monitor will show the disc content. 4. Press Open button on the panel and Eject button inner the panel to eject the disc. If the disc is not removed for about 10 seconds after reject, the disc will reinserted automatically. When d
ページ18に含まれる内容の要旨
Repeat A-B function 1. During playback, press A-B button on the remote control at the starting point of the section you want to repeat (point A). 2. Press A-B button again at the ending point of the section you want to repeat (point B). Section A-B repeating starts. 3. Press A-B button again to cancel the A-B repeat function. Random playback (for CD/VCD/MP3 discs) During disc playback, press the RDM button on the RC to start random playback of the disc. Press again to cancel.
ページ19に含まれる内容の要旨
Changing the subtitle language (for DVD only) Press SUBTITLE button on the RC to select the preferred language for the disc menu. When the selected language is recorded on the disc then this language will automatically be selected. If not, the first language recorded on the disc is displayed. Changing size Press and hold for 2 seconds the A-B/ZOOM on the RC. The picture will be enlarged accordingly: X2 => X3 =>X4 => X1/2=>X1/3=>X1/4X=>Normal. Changing angle (for DVD only) If DVD
ページ20に含まれる内容の要旨
You should not write non-MP3 files or unneeded folders along with MP3 files on the disc otherwise it takes a long time until the unit starts to play MP3 files. With some CD-R or CD-RW media, data may not be properly written depending on its manufacturing quality. In this case, data may not be reproduced correctly. High quality CD-R or CD-RW disc is recommended. Up to 16 characters are displayed for the name of an Album or a Track. ID3TAG version 1.x is required. Note that the unit
