Audiovox 50-0300A-014 SERIESの取扱説明書

ページ1に含まれる内容の要旨

FOR
50 - 0300A - 014 SERIES 1181282
50 - 0300A - 002 SERIES 1181284
FORD EXPLORER / MERCURY MOUNTAINEER w/ SUNROOF
OVERHEAD CONSOLE for use with FLIPDOWN VIDEO




























ool
-
7. Test Light







-
Printed in the U.S.A
0039A INSTALLATION INSTRUCTION # 44
No

ページ2に含まれる内容の要旨

1 - 1 6 2 4 2 SCREW, # 8 X 1 1/2" PWH 3 1 4 2 1 5 3 1 6 7 1 4 8 1 9 1 - Nov. 8, 1999 Printed in the U.S.A. 2 0039A IN

ページ3に含まれる内容の要旨

1. Using the rear edge o Caution: Before cutting indicated. Make sure that the 7" cut is centere d left to right in vehicle. See Figure 1. 2. 3. 4. ground. See Figure 3. 5. 6. 3 FIGURE 3 Install O.E. dome light in original manner. Using a test light, tes

ページ4に含まれる内容の要旨

7. Remove and retain (2) two O.E. screws from bracket. 8. rear of ket with center rivet on roof panel. 10. Secure rear of bracket using (2) two O.E. screws, 4 FIGURE 5 around sunroof opening. 11. Slide edge molding back into original po

ページ5に含まれる内容の要旨

12. Inst - - pillar to the floor. Route the power lead to an ) to the VCP location. See two 6 - 32 x 3/4" screws (item 1 pg. 2) through the clips on front of mounting bracket. 1 1/ - 32 5 FIGURE 7 screws previously installed. See Figure 7. alignment is straight then tighten (2) two 6 2" screw (item 3 pg. 2). M

ページ6に含まれる内容の要旨

Note : Make sure wires do not get pinched between video system and console. four 6 - Caution : Do not overtighten screws. Caution: Do not overtighten 20. 21. 22. 23. 6 FIGURE 9 Install cover pl