ページ1に含まれる内容の要旨
USER INSTRUCTION MANUAL
Before using this system, please be sure to read,
understand, and follow the instruction of this manual.
TM
H O Audio
2
Oceanic DV Series
iRiver 300 Series MP3 Players
Manufactured by: Diver Entertainment Systems Inc. www.desworldwide.com
Copyright Notice:
This owner’s manual is copyrighted, all rights reserved. It may not, in whole or in part, be copied, photocopied, reproduced,
translated, or formed into any electronic format without prior consent in writing from Di
ページ2に含まれる内容の要旨
INTRODUCTION: The H O Audio DV system enables you to listen to digital audio while S.C.U.B.A. diving or snorkeling. The system is designed to 2 provide high fidelity audio to a depth of 200 feet (66 m). It utilizes the latest MP3 player technology capable of playing both MP3 and WMA files. HOUSING: The housing features a simple and secure rotary locking mechanism to keep the unit waterproof during operation. The H O Audio DV housing allows for complete functional control of the iRiver 300
ページ3に含まれる内容の要旨
IMPORTANT WARNING: Pay special attention to these labels: WARNING: Could cause injury to the user. CAUTION: Could cause damage to the product and/or injury to the user. READ THIS MANUAL CAREFULLY. IF YOU HAVE ANY QUESTIONS PLEASE CONTACT YOUR NEAREST DEALER OR CUSTOMER SUPPORT PRIOR TO USE. IMPROPER USE OF THIS SYSTEM MAY CAUSE THE USER TO MAKE MISTAKES OR DECISIONS THAT MAY LEAD TO SERIOUS INJURY OR DEATH. IMPORTANT WARNING AND DISCLOSURE ANY INDIVIDUAL INTENDING TO UTILIZE THIS PRODUCT DU
ページ4に含まれる内容の要旨
LEAK TEST: Before utilizing the system for the first time, it is highly recommended to perform a 'Leak Test’. Follow the instructions below, but DO NOT INSTALL THE MP3 PLAYER inside the housing for the leak test. 1. Visually inspect the main housing seal by opening the unit. Verify the seal is seated as intended and the O-ring is clean of any artifacts, then close and lock the housing using the OPEN-CLOSE Dial. 2. Make a first dive to your intended depth, taking the housing and speakers only
ページ5に含まれる内容の要旨
O-RING PREPARATION: 1. Gently Remove the O-ring with the Remover. Be careful not to stretch the O-ring CAUTION: Never use a sharp or metal object to remove O-rings as they damage the O-ring or the O-ring groove contact surface. Use only the O-ring Remover Tool included in the packaging. 2. Check the O-ring for hair, sand, lint, or other debris and wipe clean as necessary. Be careful not to stretch the O-ring. If the O-ring is cut or cracked it must be removed and replaced with a new O-ring. 3
ページ6に含まれる内容の要旨
GENERAL STORAGE PROCEDURES: For long-term storage, remove O-ring and store out of direct sunlight. If the O-ring will not be used for a long period of time, remove from it the housing and store in a plastic bag out of direct sunlight. If the O- ring is stored in a dry environment for a long period of time, it will develop cracks and become unusable. CAUTION: The life of an O-ring is typically one (1) year. Contact your supplier for spare O-Rings or a maintenance kit. Always remember to reins
ページ7に含まれる内容の要旨
E S O L C HOUSING OPERATIONS: Button 3: Mode Button 1: MP3 ON/OFF/Play/Stop Button 2:Memory/EQ Lever 1: Navigation Open the Housing STEP 1: Pull out the Tab STEP 2: Rotate the Dial counterclockwise CAUTION: If the housing has been subjected to pressure and FORWARD BACKWARD become ‘tighter’ and more Volume difficult to open than usual, in this DOWN case, rotate the dial a little more - strongly than usual. Volume + UP TAB Closing the Housing Button 5: Menu STEP 1: -Rotate the Dial Clockwis
ページ8に含まれる内容の要旨
CAUTION: This device provides powerful amplification of the audio signal beyond the normal output of standard stereo devices. This system is specifically engineered for underwater use to enhance fidelity at depth. This power Button 4: amplifier is powerful and must be used carefully. After using Amplifier Power ON/OFF the product, lower the volume to zero before turning the device on again. The MP3 player Volume level MUST be at ZERO before turning the Amplifier Power ON WARNING: T
ページ9に含まれる内容の要旨
INSTALLING & REPLACING AMPLIFIER BATTERY: STEP 1: WIPE EXTERIOR AND MAKE SURE IT IS DRY STEP 2: TURN OFF THE AMPLIFIER STEP 3: OPEN HOUSING CAUTION: Completely dry the inside of any moisture STEP 4: REMOVE AND UNPLUG THE MP3 PLAYER
ページ10に含まれる内容の要旨
INSTALLING THE MP3 PLAYER: CAUTION: Before opening be sure to rinse the sealed system in fresh water. Before installing the MP3 player, make sure the housing interior is dry. Moisture in the housing can cause damage to the electronics. STEP 1: DRY THE EXTERIOR STEP 2: OPEN HOUSING Note: Use a soft clean cloth. NEVER use direct heat STEP 3: PLUG STEREO ADAPTER INTO MP3 PLAYER NOTE: Some MP3 players have two audio jacks. Make sure you plug the adapter into the HEADPHONE audio jack STEP 4: PL
ページ11に含まれる内容の要旨
STEP 5: CLOSE THE LID Begin to close the lid by bringing it down towards the housing. Make sure the Lever Controls are lined up with the Joysticks on the MP3 Player. CAUTION: Make sure the lid is free of any lint, hair, sand, or other items. DO NOT FORCE THE LID CLOSED. If you feel resistance, check to make sure the MP3 player is seated correctly. Rotate the OPEN/CLOSE Dial CLOCKWISE until the front and rear halves of the housing are fully closed, then push in the small locking tab on the
ページ12に含まれる内容の要旨
STEP 5: PUSH UP TO OPEN STEP 6: SLIDE OUT STEP 7: Insert a NEW & DRY 9-Volt Alkaline battery. CAUTION: Visually inspect the inside to make sure it is dry. STEP 8: SLIDE IN TO CLOSE STEP 9: PUSH DOWN STEP 10: SNAP CLOSE STEP 11: Insert and connect the MP3 Player STEP 12: Turn on the Amplifier using the external button. The LED will turn on. WARNING: THE MP3 PLAYER VOLUME MUST BE SET TO ZERO BEFORE TURNING ON THE AMPLIFIER.
ページ13に含まれる内容の要旨
REMOVING THE MP3 PLAYER: STEP 1: TURN OFF THE AMPLIFIER STEP 2: WIPE DOWN THE EXTERIOR WITH CLEAN FRESH WATER STEP 3: WIPE THE UNIT DRY STEP 4: CAREFULLY OPEN THE HOUSING STEP 5: TURN HOUSING TO SIDE AND LET MP3 PLAYER SLIDE OUT INTO YOUR PALM STEP 6: UNPLUG THE STEREO ADAPTER STEP 7: REMOVE THE MP3 PLAYER
ページ14に含まれる内容の要旨
INSTALLING THE STEREO JACK: STEP 1: LINE UP CONNECTOR WITH MP3 PLAYER STEREO JACK NOTE: Make sure you plug the connector into the stereo jack. Some of the higher end 300 Series also includes an input jack for a recording device. Make sure you know the difference. Look for the jack with the ‘headphones’ symbol. STEP 2: PLUG CONNECTOR INTO MP3 PLAYER JACK NOTE: Make sure you plug the connector all the way into the stereo jack
ページ15に含まれる内容の要旨
SPEAKER MASK STRAP SPEAKER AMPLIFIER OPERA OPERA TIONS: TION: Care must be taken when handling the speakers. Do not let the speakers hang freely from the housing. Maintain control of the speakers at all times. CAUTION: Failure to maintain control of the speakers during handling may result in damage to the speakers and compromise the integrity of the speaker set. MASK STRAP MOUNTING: REMOVABLE MASK STRAP CLIP: Feed the mask strap The clip is a removable item to make the speakers through
ページ16に含まれる内容の要旨
REMOVING/REPLACING THE SPEAKER CLIP: CAUTION: Make sure that you are holding the mask on your face when entering the water. The speakers may try to pull the mask off the face when entering the water, so pay special attention to keeping the mask on your face. STEP 1: UNSCREW To remove the clip from the speaker: 1. Make sure the unit is turned off. 2. Hold the speaker face down. 3. With a Phillips head screwdriver, gently unscrew the clip from the speaker 4. Make sure to save the screw and cl
ページ17に含まれる内容の要旨
LIMITED WARRANTY COVERAGE: Diver Entertainment Systems Inc. (DES) guarantees, to the original purchaser only, that the equipment purchased (EXCLUDING THE MP3 PLAYER) is free of defects in material and/or under normal recreational SCUBA use for a period of one year (1) from date of consumer purchase from an Authorized DES Dealer; provided that proper care and maintenance have been performed as prescribed by the owner's guide included with the equipment. Should this product prove to be defecti
ページ18に含まれる内容の要旨
RETURNING FOR SERVICE: Prior to any return, a Return Authorization (RA) number must be attained. Proof of purchase from an Authorized Dealer will be required. Contact Custom Support to attain the RA number and shipping instructions. WARRANTY CORRESPONDENCE: A copy of the original sales receipt and a copy of the owner’s portion of the warranty card must accompany all correspondence regarding the equipment covered by this warranty agreement or in direct reference to this warranty. CONTACTING
