ページ1に含まれる内容の要旨
Operating and Installation
Instructions
Ventilation System
DA 250-4
To prevent accidents
UV
and machine damage,
read these instructions
before
installation or use. M.-Nr. 06 850 870
ページ2に含まれる内容の要旨
Contents IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Functional description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Guide to the hood . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Turning on the fan . . . . . . . . . .
ページ3に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is designed to vent This appliance is intended for cooking smoke and odors only. residential use only. Use the Be certain your appliance is appliance only for its intended properly installed and grounded by purpose. The manufacturer cannot a qualified technician. be held responsible for damages To guarantee the electrical safety of this caused by improper us
ページ4に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS This equipment is not designed for Use maritime use or for use in mobile Do not allow children to play with installations such as recreational or operate the appliance or its vehicles or aircraft. However, under controls. Supervise its use by the certain conditions it may be possible for elderly or infirm. an installation in these applications. Please contact the nearest Miele dealer Do not flambé or grill with an open or the Miele Technical Service flame beneath th
ページ5に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS , WARNING - TO REDUCE , WARNING TO REDUCE THE RISK OF INJURY THE RISK OF A COOKTOP TO PERSONS, IN THE EVENT OF A GREASE FIRE: COOKTOP GREASE FIRE, OBSERVE Never leave surface units THE FOLLOWING: unattended at high settings. SMOTHER FLAMES with a close Boilovers cause smoking and greasy fitting lid, cookie sheet, or metal spillovers may ignite. Heat oils slowly tray then turn off the burner. on low or medium settings. BE CAREFUL TO PREVENT BURNS. Always turn the hoo
ページ6に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS Installation Never connect an exhaust hood to an active chimney, dryer vent, vent , WARNING flue, or room ventilating ductwork. Seek To reduce the risk of fire only professional advice before connecting use metal ductwork. an exhaust hood vent to an existing, Any fittings, sealant, or materials inactive chimney or vent flue. used to install the ductwork must Ducted fans must always be be made of approved non-flammable vented outdoors. materials. Make sure that the a
ページ7に含まれる内容の要旨
Functional description The ventilation hood works by air extraction. The air is drawn in and cleaned by the grease filter and directed outside. The hood comes equipped with a non-return flap. This flap automatically closes when the hood is turned off so that no exchange of outside air and room air can occur. When the hood is turned on, the air pressure of the exhaust fan automatically opens the flap blowing the inside air and cooking odors outside. 7
ページ8に含まれる内容の要旨
Guide to the hood 8
ページ9に含まれる内容の要旨
Guide to the hood a Cover frame k Grease filter button The indicator next to the grease filter b Chimney button lights when the grease filter needs to be cleaned. c Canopy This button is also used: – to reset the grease filter timer after d Grease filter cleaning the grease filter (see "Cleaning and Care"). e Control panel – to show how long the grease filter f Overhead lighting has been in use (see "Operation / Grease filter timer"). g Light button – to change the number of hours counted by the
ページ10に含まれる内容の要旨
Operation Turning on the fan Automatically switching back the intensive power level The intensive level "4" can be programmed to automatically switch back to level "3" after 10 minutes. ^ Press the On/Off button. ^ Turn the fan and the lights off. The hood turns on on level 2 and the indicator lights. Selecting the power level ^ Press and hold the "Delay Shut down" button for 10 secs. The first indicator lights. ^ Press the following buttons one after ^ Use the "–/+" controls to select the anoth
ページ11に含まれる内容の要旨
Operation Fan performance The maximum air flow capacity is 625 cfm. Factors such as narrow duct diameter and bends will affect this If the power level indicators "1" and "4" value. flash, the automatic switch back is not Level 1 operates at 40% capacity activated. Level 2 operates at 60% capacity ^ To activate the automatic switch back Level 3 operates at 80% capacity press the "+" button. Level 4 operates at 100% capacity The power level indicators "1" and "4" light continuously. ^ To deactivat
ページ12に含まれる内容の要旨
Operation Delayed Shut Down Turning off the fan If odors or smoke remain in the kitchen after cooking has been completed, the Delayed Shut Down feature can be selected to allow the hood to continue running for either 5 or 15 minutes. After ^ Press the On/Off button to turn the that period of time the fan turns off fan off. automatically. The indicator goes out. Automatic Safety Shut Off The fan will turn off automatically 10 hours after the last button was ^ Press the Delayed Shut Down button ac
ページ13に含まれる内容の要旨
Operation Turning the lighting on/off Dimming the lighting The overhead lighting can be turned on The brightness of the lighting can be and off independently of the fan. adjusted. ^ While the lighting is turned on, press and hold the light button. The lighting will dim until the button is released. ^ Press the light button briefly to turn ^ If the button is pressed again, the on the lighting. lighting will brighten until the button is The light button indicator illuminates. released. ^ Press the
ページ14に含まれる内容の要旨
Operation Grease filter timer Checking the grease filter timer A timer monitors the hours of fan To check the percentage of time operation. The indicator for the grease already used: filter will light after 30 hours of operation or the preselected time. The grease filter must then be cleaned. See "Cleaning and care / Grease Filter". After the grease filter has been cleaned ^ Press the On/Off button to turn the and put back in place, the grease filter fan on. timer must be reset. ^ Press the grea
ページ15に含まれる内容の要旨
Operation Reprogramming the grease filter timer The grease filter timer is preset to 30 hours. This time can be lengthened The lit "–/+" indicator shows the or shortened to 20, 30, 40 or 50 hours. programmed time: – A time of 20 hours should be 1st indicator from the left = 20 hours programmed in kitchens with 2nd indicator from the left = 30 hours frequent pan or deep frying. 3rd indicator from the left = 40 hours – A time of 20 hours should also be 4th indicator from the left = 50 hours progra
ページ16に含まれる内容の要旨
Cleaning and care Stainless steel Before cleaning or servicing the Stainless steel surfaces can be cleaned hood, disconnect it from the power using a non-abrasive stainless steel supply by either removing the fuse, cleaner. unplugging it from the outlet or manually "tripping" the circuit To help prevent resoiling, a conditioner breaker. for stainless steel can also be used. Apply sparingly with even pressure. Cleaning the casing Stainless steel colored controls ,Never use on the hood: These cont
ページ17に含まれる内容の要旨
Cleaning and care Grease filter Removing the grease filter The reusable metal grease filter removes solid particles from the vented kitchen air (grease, dust, etc). The grease filter should be cleaned every 3 - 4 weeks or whenever the ^ To remove the grease filter pull the grease filter indicator lights. locking clip forward. Lower the filter 45° unhook it at the rear and take it Keep the grease filter clean to out. Support the grease filter so that it prevent a fire hazard. does not fall onto t
ページ18に含まれる内容の要旨
Cleaning and care Cleaning the grease filter ^ By hand: use a scrub brush with a solution of warm water and mild detergent. Do not use the pure detergent, aggressive all purpose cleaners, oven sprays, abrasive cleaning agents or limescale removers. They could destroy the filter. ^ If the filter is incorrectly installed, ^ In a dishwasher: place the filter insert a small screwdriver into the slit vertically in the lower basket, making along its edge to disengage it from sure that the spray arm is
ページ19に含まれる内容の要旨
Cleaning and care Changing the light bulb Before changing the light bulbs, disconnect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. When in use halogen bulbs become extremely hot, and can burn your hands. Do not attempt to change the bulbs until they have had sufficient ^ To change the halogen bulb first pull time to cool. off the lamp cover, a. ^ Pull the bulb, b, out of its socket and Do not touch the bulb surface. replac
ページ20に含まれる内容の要旨
After Sales Service Repairs MieleCare In the event of a fault which you cannot (only USA) easily fix yourself, please contact the MieleCare, our Extended Service Miele Technical Service Department at Contract program, gives you the the phone number on the back of this assurance of knowing that your booklet. appliance investment is covered by ^ When contacting the Technical 5 years of worry free ownership. Service Department, please quote MieleCare is the only Extended Service the model and seria
