ページ1に含まれる内容の要旨
TABLE OF CONTENTS
INTRODUCTION 3
PRODUCT OVERVIEW 4
REMOTE RAIN GAUGE 9
REMOTE SENSOR 11
BEFORE YOU BEGIN 12
BATTERY INSTALLATION 14
REMOTE TEMPERATURE SENSOR 15
MAIN UNIT 15
LOW BATTERY WARNING 15
HOW TO USE THE TABLE STAND 16
Honeywell
GETTING STARTED 16
REMOTE AND INDOOR TEMPERATURES 17
Wireless Rain Gauge
AUTO-SCANNING 17
CHECKING REMOTE RAINFALL DATA 18
MAXIMUM AND MINIMUM TEMPERATURE 19
LOST COMMUNICATION 19
TRANSMISSION COLLISION 20
CALENDAR AND CLOCK D
ページ2に含まれる内容の要旨
INTRODUCTION PRODUCT OVERVIEW Thank you for selecting the Honeywell Wireless Rain Gauge. This device MAIN UNIT monitors and displays rainfall data along with the indoor/outdoor FEATURES temperature from up to three remote locations. • Wireless transmission of the rainfall data from the remote rain In this package you will find: gauge to the main unit up to 100 feet (30 meters) away • One main unit (receiver) • Wireless transmission of the temperature from the remote temperature sensor to
ページ3に含まれる内容の要旨
FRONT VIEW (RAIN MODE CONTROL PANEL) B. ALARM button A. WEATHER AND TIME INFORMATION IN A THREE - LINE LCD • Toggles between the rainfall modes – a current rainfall data and DISPLAY a rain alarm programming mode • Activates the high rainfall alarm setting mode A C. MODE button • Toggles between the rainfall modes – for the past hour, 24hours, and for the past 7 days D. UP ( ▲) button • Toggles between the rainfall modes – for the past hour, 24 hours, and for the past 7 days • Inc
ページ4に含まれる内容の要旨
K. ALARM button REAR VIEW (TIME AND TEMPERATURE CONTROLS PANEL) Toggles between the alarm modes –weekday alarm (W), single alarm N (S) and ice warning alarm (Pre-AL) P L. MEMORY button • Toggles between current, minimum and maximum readings of J the indoor and remote temperatures H • Clears the memory I M. CHANNEL button • Recalls a different channel of the remote temperature • Enables remote temperature channels auto scanning feature M K N. SNOOZE/LIGHT button • Enables bac
ページ5に含まれる内容の要旨
REMOTE RAIN GAUGE REMOTE RAIN GAUGE FEATURES • Precipitation measurement D • Remote rainfall data transmission to the main unit via 433 MHz G signal • 100 feet (30 meters) transmission range without interference H • Built-in installation level • Mounting hardware E • Non-corrosive protective screen B A F I C D. Funnel-shaped top with battery compartment Contains battery compartment and rainfall counting electronics A. Rain gauge bucket E. Battery compartment
ページ6に含まれる内容の要旨
I. Protective screen Holds two AA-size batteries Protects the rain gauge funnel from debris C. RESET Resets all readings REMOTE SENSOR D. CHANNEL SWITCH FEATURES Selects the desired channel E. WALL-MOUNT RECESSED OPENING • Remote temperature transmission to the main unit via 433 MHz signal Keeps the remote temperature sensor on the wall F. °C/ °F SELECTOR • 100 feet (30 meters) transmission range without interference Selects the temperature display in Celsius or Fahrenheit • LCD di
ページ7に含まれる内容の要旨
the temperature sensor) and the main unit within the effective during the winter time or move it indoors. transmission range of 100 feet (30 meters). BATTERY INSTALLATION REMOTE RAIN GAUGE • The remote rain gauge must be placed outdoors on the open area, away from the walls, fences and trees and level. • Unlock the funnel-shaped top on the rain gauge by turning both knobs on the sides in an anti-clockwise direction. • It is important that excess precipitation can freely flow from the rem
ページ8に含まれる内容の要旨
REMOTE TEMPERATURE SENSOR HOW TO USE THE TABLE STAND NOTE: Install the batteries; select the channel and temperature in C° The main unit has a removable table stand that supports it on the flat or F° before mounting the remote temperature sensor. surface. Attach table stand to the bottom of the main unit in the slots provided. • Remove the screws from the battery compartment with a small Phillips screwdriver. The main unit can also be mounted on the wall using the recessed screw hole. The
ページ9に含まれる内容の要旨
REMOTE AND INDOOR TEMPERATURES The remote temperature information is located on the middle line of the main unit’s display. The indoor temperature with the icon IN is located CHECKING REMOTE RAINFALL DATA next to the remote temperature. The remote rainfall information line is located on the top line of the main The wave icon above the remote channel number indicates the reception unit’s display. status from the remote temperature sensor. The rain icon is located to the left of the
ページ10に含まれる内容の要旨
MAXIMUM AND MINIMUM TEMPERATURE • Remove the batteries from the main unit and reinstall them in the The maximum and minimum record of the indoor and remote same manner. temperatures will be automatically stored in the memory of the main unit. • The remote temperature appeared on the main unit’s display will To display the minimum, maximum or the current reading press show that transmission is being received successfully. MEMORY button on the back panel. If the main unit display line for
ページ11に含まれる内容の要旨
MANUAL SETTINGS • Enter the rainfall amount you want to set the rain alarm for using CLOCK the front panel UP ( ) or DOWN ( ). • Press and hold MODE button for 3 seconds: the language letters • Press the ALARM button again to confirm and the high rain will flash. alarm will be set. NOTE: Press and hold the MODE button on the front panel to display the • Press UP ( ▲) or DOWN ( ▲) to change flashing letters. rainfall reading in inches or mm. • After the first value is set, press MOD
ページ12に含まれる内容の要旨
• Press the ALARM button again to confirm and the weekday alarm time will be set. PRECAUTIONS • Set Single day alarm if desired in the same manner. SETTING THE ICE WARNING ALARM This product is engineered to give you years of satisfactory service if If Weekday or Single day alarm is set, the Ice Warning Alarm can be handled carefully. Here are a few precautions: programmed. • Do not immerse the units in water. • Press the back panel ALARM button once to enter into the Ice • Do not
ページ13に含まれる内容の要旨
Main unit: 2 AA size (UM-3) 1.5V batteries (not included) SPECIFICATIONS Remote sensor: 2 AA size (UM-3) 1.5V batteries (not included) Main Unit Remote rain gauge: 2 AA size (UM-3) 1.5V batteries (not included) TIME 12/24 hour display in hh: mm format Dimensions Date format: month-day or day-month format Main unit: 2.75(L) x 5.43(H) x 1.02(D) inches Day of the week is selectable in five languages (English, Spanish, Remote sensor: 2.37(L) x 4(H) x 1(D) inch French, German, Italian)
ページ14に含まれる内容の要旨
FCC STATEMENT DECLARATION OF CONFORMITY This device complies with Part 15 of the FCC Rules. Operation is subject We to the following two conditions: (1) This device may not cause harmful Name: Hideki Electronics, Inc. interference, and (2) This device must accept any interference received, Address: 7945 SW Mohawk, Tualatin, OR 97062 including interference that may cause undesired operation. Telephone No.: 1-503-612-8395 Warning: Changes or modification to this unit not expressly approved b
ページ15に含まれる内容の要旨
STANDARD WARRANTY INFORMATION This product is warranted from manufacturing defects for one year from date of retail purchase. It does not cover damages or wear resulting from accident, misuse, abuse, commercial use, or unauthorized adjustment and repair. Note that online product registration is required to ensure valid warranty protection. To register your product, go to our Company website at: www.honeywellweatherstations.com. Click Online Product Registration under the Customer Servic
