ページ1に含まれる内容の要旨
Model 3000 ESP
Owner's Guide
ページ2に含まれる内容の要旨
Limited Lifetime Consumer Warranty ® Directed Electronics, Inc. ("DEI ") promises to the original purchaser to repair or replace with a comparable reconditioned model any DEI unit (hereafter the "unit"), excluding without limitation the siren, the remote transmitters, the associated sensors and accessories, which proves to be defective in workmanship or material under reasonable use during the lifetime of the vehicle provided the following condi- tions are met: the unit was professionally ins
ページ3に含まれる内容の要旨
VANDALISM. THIS WARRANTY DOES NOT COVER LABOR COSTS FOR MAINTENANCE, REMOVAL OR REINSTALLATION OF THE UNIT OR ANY CONSEQUENTIAL DAMAGES OF ANY KIND. IN THE EVENT OF A CLAIM OR A DISPUTE INVOLVING DEI OR ITS SUBSIDIARY, THE PROPER VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA. CALIFORNIA STATE LAWS AND APPLICABLE FEDERAL LAWS SHALL APPLY AND GOVERN THE DISPUTE. THE MAXIMUM RECOVERY UNDER ANY CLAIM AGAINST DEI SHALL BE STRICTLY LIMITED TO THE AUTHORIZED DEI DEALER'S PURCHASE PRICE OF
ページ4に含まれる内容の要旨
Table of Contents Limited Lifetime Consumer Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . i Standard Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 What Is Included. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Important Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 System Maintenance . . . . . . . . . . . . . . . . . . . . . . .
ページ5に含まれる内容の要旨
Standard Configuration controls the Arm, Disarm and Panic functions. is used for Silent Mode, Remote Valet and optional Trunk Release. controls an optional Auxiliary Output. controls another optional Auxiliary Output. and pressed simultaneously control another optional Auxiliary Output. and pressed simultaneously control another optional Auxiliary Output. 2 2001 Directed Electronics, Inc. ©
ページ6に含まれる内容の要旨
What is Included 7-Channel Receiver A pair of four-button transmitters ® ® A Stinger DoubleGuard dual-output shock sensor ® ® The Revenger Soft Chirp six-tone programmable siren The red status LED indicator light ® A push-button Valet switch Your warranty card ® FailSafe Starter Kill ready circuitry (may require additional labor) Important Information Congratulations on the purchase of your state-of-the-art vehicle security system. This system has been designed to provide year
ページ7に含まれる内容の要旨
System Maintenance This system requires no specific maintenance. Your remote control is powered either by a miniature 12V battery, type GP23A, or a lightweight 3-volt lithium battery, both of which will last approx- imately one year under normal use. Contact your dealer if you have any questions. When the battery weakens, operating range will be reduced and the LED on the remote will dim. Your Warranty Your warranty card must be returned and the bar code serial number must not be removed. If the
ページ8に含まれる内容の要旨
Transmitter Functions The receiver uses a computer-based Learn Routine to learn the transmitter buttons. This makes it possible to assign any button on the remote transmitter to any receiver function. Two possible transmitter configurations are described in this section. Remember that there are many alternate custom configurations that can be programmed by your dealer. Standard Configuration The standard configuration is how the transmitters come programmed initially. If you would like a custom
ページ9に含まれる内容の要旨
Button IV Another optional auxiliary convenience or expansion function that you may have added to your system can be activated by pressing . This auxiliary output controls _____________________________. Buttons I and II Another optional auxiliary convenience or expansion function that you may have added to your system can be activated by pressing and simultaneously. This auxiliary output controls _____________________________. Buttons III and IV Another optional auxiliary convenience or expa
ページ10に含まれる内容の要旨
Button I The arming and Multi-Level Security functions are usually controlled by . Pressing for one second will arm the system. Pressing again within five seconds of arming activates Multi-Level Security. Button II Pressing for one second will disarm the system. If configured for optional progressive unlocking, pressing when disarming will only unlock the driver’s door. A second press of will then unlock the passenger doors. Button III ™ Silent Mode , Remote Valet®, and optional trunk release
ページ11に含まれる内容の要旨
Using Your System The remote button numbers in this manual correspond to the standard configuration unless otherwise specified. Remember, this is not the only way your transmitters can be programmed. Your transmitters may also be programmed for expanded configuration or custom configured by a dealer to meet your needs. Arming You can activate, or arm, the system by pressing for one second. When the system arms, you will hear a short siren sound, or chirp, and the parking lights will flash once
ページ12に含まれる内容の要旨
as fast as it does when the system is armed. The siren will chirp one time 20 seconds after the last door has been closed. The system is not actually armed at that point. The system arms and the doors lock (if connected and programmed for passive locking) at the 30-second mark, but the siren will not chirp. The early chirp provides you with a 10-second warning prior to arming. NOTE: If any protected entry point (such as a door or a switch-protected trunk or hood) is open, the system will not pa
ページ13に含まれる内容の要旨
Arming While Driving Your system can be armed while driving the vehicle! Simply press and hold on your transmitter for 1.5 seconds while the vehicle is running or the ignition is on. The system will chirp once and then once more to indicate that the ignition is on. The system will not respond to any input except the door triggers and the starter kill relay (if installed) will not be activated. The system will disarm automatically when the ignition is turned off. The siren will chirp twice and th
ページ14に含まれる内容の要旨
Press a fourth time within five seconds: The siren chirps four times followed by a long chirp. Zones Two, Four, Five and Six are now bypassed. Press a fifth time within five seconds: The siren chirps five times followed by a long chirp. All input zones are now bypassed with the exception of Zones Seven and Eight. IMPORTANT: Multi-Level Security is only available with a system using the expanded configuration. This feature cannot be accessed through a standard configuration transmitter. Disa
ページ15に含まれる内容の要旨
state. The system will not disarm, but rather reset. This prevents you from having to disable the system should you wish to stop the triggered sequence without visually checking the vehicle. Pressing the disarm button again, after resetting the system, will disarm the system. Pressing the disarm button on the trans- mitter during the first six seconds of the triggered sequence will disarm the system immediately. The six second timer is provided for your convenience, in case you inadvertently
ページ16に含まれる内容の要旨
Ghost Switch A Ghost Switch is actually a factory switch that already exists in your vehicle that can be set up to function as an optional protected disarm switch. Any factory switch in your vehicle may be used as long as it switches positive voltage. Your installer can help you to determine which switches will work in your vehicle. Some possible switches are power window, radio turn-on, or defroster switches. Once a switch has been selected, you may choose the number of pulses (from 1 to 5) tha
ページ17に含まれる内容の要旨
Silent Mode ™ To temporarily turn off the arm or disarm chirps, use Silent Mode . Simply press briefly before arming or disarming, and the confirmation chirp(s) will be eliminated for that one operation only. If you want the arm/disarm chirps turned off permanently, your dealer can do this for you. ® NOTE: The Warn Away response to lighter impacts is bypassed if the system is armed using Silent Mode. This ensures that no chirps will be emitted by the siren in an area you want chirp-free. The sy
ページ18に含まれる内容の要旨
To enter or exit Valet Mode: 1. Turn the ignition on. 2. Turn the ignition off. DRW-35 3. Press and release the Valet switch within 10 seconds. The status LED will light solid if you are entering Valet Mode, and it will go out if you are exiting Valet Mode. Remote Valet The operations described in this section indicate transmitter buttons that correspond to the standard configuration. Remember, this may not be how your transmitter is set up. 1. Open any door. 2. Press . 3. Press . 4.Pre
ページ19に含まれる内容の要旨
Here’s how Nuisance Prevention Circuitry works: The alarm triggers three times. Each time, the same sensor or switch is triggering the alarm. The three triggers activate within 60 minutes of each other. NPC will interpret this pattern of triggers as false alarms. After the third trigger, NPC bypasses that sensor or switch (along with any other sensors or switches sharing the same zone) for 60 minutes. If the bypassed sensor attempts to trigger the system while it is being bypassed, the 60-minute
ページ20に含まれる内容の要旨
Diagnostics The microprocessor at the heart of your system is constantly mon- itoring all of the switches and sensors connected to it. It detects any faulty switches and sensors and prevents them from disabling the entire system. The microprocessor will also record and report any triggers that occurred during your absence. Arming Diagnostics If the system is armed while an input is active (door open, sensor triggering, etc.) the unit will chirp once when arming and then again a few seconds
