ページ1に含まれる内容の要旨
VEC259
CORDED, CORDLESS,
RECHARGEABLE COMPRESSOR, INFLATOR
AND LANTERN LIGHT COMBO
OWNER’S MANUAL
& WARRANTY INFORMATION
THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY,
OPERATION, MAINTENANCE AND STORAGE OF THIS PRODUCT. BEFORE USE, READ
AND UNDERSTAND ALL CAUTIONS, WARNINGS, INSTRUCTIONS AND PRODUCT
LABELS. FAILURE TO DO SO COULD RESULT IN INJURY AND/OR PROPERTY DAMAGE.
4140 SW 28th Way, Ft. Lauderdale, FL 33312
4140 SW 28th Way, FT. LAUDERDALE, FL 33312
PH: 954-584-4446 • TOLL
ページ2に含まれる内容の要旨
NOTE: This product is shipped in a partially charged state. Before use, CONTENTS charge battery using AC method for 24 hours. 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 IMPORTANT SAFETY INFORMATION Be sure to read and understand all WARNINGS and CAUTIONS before using this 2. Additional key features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 product. Please read this guide carefully before use to ensure optimum perform
ページ3に含まれる内容の要旨
The compressor on/off switch controls operation of the compressor. It can be 1. INTRODUCTION conveniently depressed and released to control inflation. An exact pressure is obtained by observing the gauge and releasing the trigger when the correct pressure is Congratulations on selecting the Vector AirPro™ Model VEC259 Compressor/Inflator achieved. For longer inflation operations, the trigger lock can be moved laterally to and Lantern Light combo. This system is an advanced, high-pressure (up to
ページ4に含まれる内容の要旨
The DC power adapter has a fused DC plug and connecting cord stored inside the DC 3. ATTACHING THE COMPRESSOR’S AIR HOSE power adapter. To use the DC power adapter, first remove the DC plug from it’s storage in the adapter. Remove the cord from storage, and connect the DC power The air hose is supplied as a separate item from the compressor body. The hose has adapter to the compressor. Make sure it snaps into position. Connect the DC plug to a a ribbed brass fitting at one end and a standard ti
ページ5に含まれる内容の要旨
CONTACT FIGURE 4 IMPORTANT: Always leave the tire chuck thumb latch in the open position when storing unit. RECHARGE PORT 6.2 INFLATE OTHER ARTICLES (WITHOUT VALVE STEM) RECHARGE LED Inflation of items, others than tires, requires use of one of the nozzles (adapters). A nozzle can be attached to the tire chuck, or it can directly be connected to the compressor’s outlet, if the hose is removed. To attach a nozzle to the tire chuck, open the nozzle hatch cover and remove the required nozzle. Pl
ページ6に含まれる内容の要旨
FIGURE 6 8. INFLATING 1. Connect the inflator/deflator to either the battery pack or the DC power adapter. SPOTLIGHT 2. Be sure the appropriate nozzle head is attached to the tapered inflating port of the SPOTLIGHT TRIGGER SWITCH inflator/deflator unit. Push the nozzle onto the inflation port to attach. The inflat- (LATCHING) ing port can be identified by location. It is on the side of the unit. 3. Position the nozzle against the valve of the inflatable item. Turn on the unit, and inflate th
ページ7に含まれる内容の要旨
4. Push the pins on the new bulb into the socket and make sure the bulb is FIGURE 6 - LANTERN LIGHT PARTS REPLACEMENT fully inserted. 5. Replace the lens and bezel. 6. Tighten (clockwise) the bezel until it is snug. BULB REFLECTOR 7. Test the light for proper operation by turning it on and then off. 9.3 FLUORESCENT LAMP REPLACEMENT The bulb type is a standard 4 watt, F4T5/D fluorescent tube. A replacement bulb can be purchased from local lighting, hardware or camping stores. The fluo
ページ8に含まれる内容の要旨
11. SPECIFICATIONS FOR COMPRESSOR: 1 YEAR LIMITED WARRANTY PROGRAM Battery . . . . . . . . . . . .12 volt, 3 Amp hour, non-spillable, sealed lead acid This limited warranty program is the only one that applies to this product, and it sets forth all the Compressor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .260 PSI maximum responsibilities of Vector Manufacturing, Ltd., regarding this product. There is no other warranty, Weight . . . . . . . . . . . . . . . . . . . . . . .
