ページ1に含まれる内容の要旨
user manual
Fridge-Freezer
ERN28700
ページ2に含まれる内容の要旨
2 electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information 2 What to do if… 9 First use 5 Technical data 10 Daily use 5Installation 11 Helpful hints and tips 6 Environmental concerns 16 Care and cleaning 7 Subject to change without notice SAFETY INFORMATION In the interest of your safety and to ensure lid, be sure to make that spring lock un- the correct use, before installing and first usable before you discard the old appli-
ページ3に含まれる内容の要旨
electrolux 3 damage to the cord may cause a short- • Appliance's manufacturers storage rec- circuit, fire and/or electric shock. ommendations should be strictly adhered to. Refer to relevant instructions. Warning! Any electrical component • Do not place carbonated or fizzy drinks in (power cord, plug, compressor) must the freezer compartment as it creates be replaced by a certified service agent pressure on the container, which may or qualified service personnel to avoid cause it to explode, res
ページ4に含まれる内容の要旨
4 electrolux • Make sure that the mains plug is accessi- in either its refrigerant circuit or insula- ble after the installation of the appliance. tion materials. The appliance shall not 4) • be discarded together with the urban Connect to potable water supply only. refuse and rubbish. The insulation foam Service contains flammable gases: the appli- • Any electrical work required to do the ance shall be disposed according to servicing of the appliance should be car- the applicable regulations t
ページ5に含まれる内容の要旨
electrolux 5 FIRST USE Cleaning the interior Important! Do not use detergents or abra- sive powders, as these will damage the fin- Before using the appliance for the first time, ish. wash the interior and all internal accesso- ries with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. DAILY USE Freezing fresh food of the upper section (where applicable) The freezer compartment is suitable for freezing fresh food and storing froze
ページ6に含まれる内容の要旨
6 electrolux To make these adjustments proceed as fol- lows: gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Positioning the door shelves To permit storage of food packages of vari- ous sizes, the door shelves can be placed at different heights. HELPFUL HINTS AND TIPS Hints for energy saving Cooked foods, cold dishes, etc..: these should be covered and may be placed on • Do not open the door frequently or leave any shelf. it open longer t
ページ7に含まれる内容の要旨
electrolux 7 to make it possible subsequently to thaw Hints for storage of frozen food only the quantity required; To obtain the best performance from this • wrap up the food in aluminium foil or pol- appliance, you should: ythene and make sure that the packages • make sure that the commercially frozen are airtight; foodstuffs were adequately stored by the • do not allow fresh, unfrozen food to retailer; touch food which is already frozen, thus • be sure that frozen foodstuffs are trans- avoidin
ページ8に含まれる内容の要旨
8 electrolux 3. Leave the door open and insert the plastic scraper in the appropriate seat- ing at the bottom centre, placing a basin underneath to collect the defrost water In order to speed up the defrosting process, place a pot of warm water in the freezer compartment. In addition, remove pieces of ice that break away before defrosting is complete. Defrosting the freezer A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when
ページ9に含まれる内容の要旨
electrolux 9 • leave the door/doors ajar to prevent un- If the cabinet will be kept on, ask some- pleasant smells. body to check it once in a while to prevent the food inside from spoiling in case of a power failure. WHAT TO DO IF… Warning! Before troubleshooting, Important! There are some sounds during disconnect the mains plug from the normal use (compressor, refrigerant mains socket. circulation). Only a qualified electrician or compe- tent person must do the troubleshoot- ing that is not in
ページ10に含まれる内容の要旨
10 electrolux Problem Possible cause Solution The product temperature is too Let the product temperature de- high. crease to room temperature be- fore storage. Many products are stored at the Store less products at the same same time. time. The temperature in the There is no cold air circulation in Make sure that there is cold air refrigerator is too high. the appliance. circulation in the appliance. The temperature in the Products are too near to each Store products so that there is freezer i
ページ11に含まれる内容の要旨
electrolux 11 The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. INSTALLATION Read the "Safety Information" carefully for your safety and correct operation of 1 2 the appliance before installing the appliance. Positioning Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Climate Ambient temperature class SN +10°C to + 32°C N
ページ12に含まれる内容の要旨
12 electrolux 5. Make sure the electricity supply voltage is the same as that indicated on the ap- pliance rating plate. 6. Switch on the appliance. The appliance is supplied with a 13 amp plug fitted 2 . In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. Warning! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it is disposed of safely. Door reversibility The door of the appliance opens
ページ13に含まれる内容の要旨
electrolux 13 2. Install the appliance in the niche. min. Push the appliance in the direction of 2 200 cm the arrows (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrows (2) against the cupboard on the opposite side of the hinge. min. 2 200 cm 2 Installing the appliance Caution! Make sure that the mains 1 cable can move freely. Do these steps. 1. If necessary cut the adhesive sealing strip and then apply it to the appliance as shown
ページ14に含まれる内容の要旨
14 electrolux 3. Adjust the appliance in the niche. 5. Remove the correct part from the hinge Make sure that the distance between cover (E). Make sure to remove the part the appliance and the cupboard front- DX, in the case of right hinge, SX in op- edge is 44 mm. posite case. The lower hinge cover (in the accesso- ries bag) makes sure that the distance between the appliance and the kitchen furniture is correct. Make sure that the clearance between the appliance and the cupboard is 4 mm. Open th
ページ15に含まれる内容の要旨
electrolux 15 7. Connect the appliance laterally to the 9. Install the part Ha on the inner side of kitchen furniture sidewall: the kitchen furniture. a) Loosen the screws of the part (G) and move the part (G) till the furni- ca. 50 mm ture sidewall. b) Tighten the screws of the part (G) 90° again. c) Attach the part (H) to the part (G). 21 mm 90° G ca. 50 mm H 21 mm 10. Push the part Hc on the part Ha. Ha 8. Disconnect the parts Ha, Hb, Hc and Hd Hc Ha Hb Hc Hd
ページ16に含まれる内容の要旨
16 electrolux 11. Open the appliance door and the kitch- 13. Place the small square on the guide en furniture door at an angle of 90°. again and fix it with the screws sup- Insert the small square (Hb) into guide plied. (Ha). Align the kitchen furniture door and the Put together the appliance door and appliance door by adjusting the part the furniture door and mark the holes. Hb. 8 mm Ha Hb Hb 12. Remove the brackets and mark a dis- 14. Press the part Hd on the part Hb. tance of 8 mm from the ou
ページ17に含まれる内容の要旨
electrolux 17
ページ18に含まれる内容の要旨
18 electrolux
ページ19に含まれる内容の要旨
electrolux 19
ページ20に含まれる内容の要旨
www.electrolux.com/shop 222301056-A-482010
