ページ1に含まれる内容の要旨
Side by Side Refrigerator
Refrigerador de dos puertas
R_frig_rateur c6te & c6te
Sears Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. www.sears.com
2308154 Sears Canada Inc., Toronto, Ontario, Canada M5B 2B8 www.sears.ca
ページ2に含まれる内容の要旨
TABLE OF CONTENTS WARRANTY WARRANTY ..................................................................................... 2 ONE-YEAR FULL WARRANTY ON REFRIGERATOR REFRIGERATOR SAFETY .............................................................. 3 For one year from the date of purchase, when this refrigerator is operated and maintained according to the instructions supplied Proper Disposal of Your Old Refrigerator .................................... 3 with it, Sears will repair this refrigerato
ページ3に含まれる内容の要旨
REFRIGERATOR SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING." These words mean: You can be killed or seriously injured if you don't immediately
ページ4に含まれる内容の要旨
INSTALLATION INSTRUCTIONS Excessive Weight Hazard Use two or more people to move and install refrigerator. Failure to do so can result in back or other injury. Explosion Hazard Keep f}ammable mateda{s and vapors, such as Remove the Packaging gasoline, away from refrigeratoro Remove tape and glue residue from surfaces before turning Failure to do so can resu}t in death, explosion, or fire° on the refrigerator. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with w
ページ5に含まれる内容の要旨
Water Pressure A cold water supply with water pressure of between 30 and 120 psi (207 - 827 kPa) is required to operate the water dispenser and ice maker. If you have questions about your water pressure, call a licensed, qualified plumber. Reverse Osmosis Water Supply IMPORTANT: The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 30 and 120 psi (207 - 827 kPa). If a reverse osmosis water filtration system
ページ6に含まれる内容の要旨
Gather therequired tools andparts andread allinstructions before starting installation. TOOLS NEEDED: 1/4", 1A", and%6" hex-head socket wrenches. IMPORTANT: Before youbegin, turntherefrigerator control OFR Unplug refrigerator ordisconnect power. Remove food, theice storage bin,andanyadjustable doororutilitybinsfromdoors. NOTE: Itmayonlybenecessary to remove either thedoorhandle orthedoors togetyourproduct through thedoorway ofyour home. Measure thedoorway tosee whether youneed toremove therefrig
ページ7に含まれる内容の要旨
Remove the Handles (optional - on some models) Replace the Doors and Hinges 1. Apply firm pressure on the handle to slide it up and off of the 1. Replace both bottom hinges, if removed. Tighten screws. shoulder screws. Do not push the handle toward the door; 2. Feed the water dispenser tubing and wiring through the only apply pressure upward. See Graphic 1. bottom left hinge before replacing the freezer door on the 2. Move refrigerator into place. Replace handles as shown. See hinge. You will ne
ページ8に含まれる内容の要旨
Thread the provided nut onto the coupling on the end of the copper tubing. _ii:;iiiiiii,',O_ii_;i_,_i!!_!_Oii_iii: If:!! _,i_!!i!_ _ii_ii_i:ji_:ii_!!iiiiii:,_ili!i!!_ S_i_:ii_:i:ii_,!i:::i_,i_j ¸ NOTE: Tighten the nut by hand. Then tighten it with a wrench Read all directions before you begin. two more turns. Do not overtighten. IMPORTANT: If you turn the refrigerator on before the water line is connected, turn the ice maker OFR Connect to Water Line 1. Unplug refrigerator or disconnect power. A
ページ9に含まれる内容の要旨
2. Flush thewater system. See "Prepare theWater System." • If your refrigerator is equipped with an ice maker, you will hear a buzzing sound when the water valve opens to fill the ice NOTE: Itmay takeupto24hours foryouricemaker tobegin maker for each cycle. producing ice. Your refrigerator is designed to run more efficiently to keep your food items at the desired temperatures and to minimize energy usage. The high efficiency compressor and fans may Please readbefore using thewater system. cause
ページ10に含まれる内容の要旨
IMPORTANT: • The set point range for the freezer is -5°F to 5°F (-21°C to -15°C) and 33°F to 41°F (1°C to 5°C) for the refrigerator. • The Refrigerator Control adjusts the refrigerator compartment temperature. The Freezer Control adjusts the freezer CONDITION: TEMPERATURE compartment temperature. ADJ USTM ENT: • Wait 24 hours after you turn on the refrigerator before you put REFRIGERATOR too cold REFRIGERATOR food into it. If you add food before the refrigerator has cooled - Not set correctly fo
ページ11に含まれる内容の要旨
NOTE: The lockout feature does not shut off power to the • The dispensing system will not operate when the freezer door refrigerator or freezer. It simply deactivates the control panel is open. buttons. The digital control panel display will remain lit and the After connecting the refrigerator to a water source, flush the buttons will beep when pressed, but no settings will be changed. water system by dispensing water into a sturdy container until you draw and discard 1.5 gal. (5.4 L) of water,
ページ12に含まれる内容の要旨
2. You can dispense water by the ounce, cup, or liter. The • The faucet rotates up to 90° to allow for easy dispensing into default unit is ounces. To switch to cups or liters, press the large containers. To rotate it, push in and release the left-hand UNITS button. side of the faucet as shown. Default, minimum, and maximum volumes are listed below. The faucet rotates 90° automatically. However, you must rotate it back into place manually. When in place, it will click. Units Default Minimum Maxi
ページ13に含まれる内容の要旨
Remove the glass to stop dispensing. NOTE: Ice may continue to dispense for up to 10 seconds after removing the glass from the pad. The dispenser may The water filter status light will help you know when to change continue to make noise for a few seconds after dispensing. your water filter. When the status light changes from green to yellow, it is almost time to change the water filter. It is recommended that you replace the filter when the status light The Dispenser Light (on some models) chang
ページ14に含まれる内容の要旨
2. Remove the cap by turning it counterclockwise until it stops. Using the Dispenser Without the Water Filter Cartridge IMPORTANT: Do not discard the cap. It is part of your refrigerator. Keep the cap to use with the replacement filter. You can run the dispenser without a water filter cartridge. Your 3= Take the new cartridge out of its packaging and remove the water will not be filtered. protective cover from O-rings. 1. Remove the filter by pressing the eject button and pulling on the cap. See
ページ15に含まれる内容の要旨
Style 2: The ON/OFF switch is located on the top right side of the freezer REFRIGERATOR FEATURES compartment. 1. Slide the control to the ON (left) position. Your model may have some or all of these features. Features that 2. To manually turn the ice maker off, slide the control to the can be purchased separately as product accessories are labeled OFF (right) position. with the word "Accessory." Not all accessories will fit all models. If you are interested in purchasing one of the accessories,
ページ16に含まれる内容の要旨
2. Lift crisper cover frame and remove. Repeat steps to remove the meat drawer cover. Drop-Down Shelf (on some models) To Remove and Replace the Drop-down Shelf: 1. Remove the drop-down shelf by sliding it up and back. Pull forward slightly to release the rear pegs from the track as shown. 3. Replace back of meat drawer cover frame into supports or slides on side walls of the refrigerator and lower or slide the front of the cover frame into place. 4. Slide rear of glass insert into cover frame a
ページ17に含まれる内容の要旨
Frozen Food Storage Guide C::_A%I%!!i!_i ¸,¸ iiii-i_ii:ii_ii _iiii_,[:liiiii:ii_ ¸C,o__iii;_iii_oiii You can control the amount of humidity in the moisture-sealed Storage times will vary according to the quality and type of food, crisper. Humidity Control is located on the crisper drawer. Adjust the type of packaging or wrap used (should be airtight and the control to any setting between LOW and HIGH. moisture-proof), and the storage temperature. Ice crystals inside a sealed package are normal.
ページ18に含まれる内容の要旨
2. Replace the rails by sliding the shelf rail into the slots on the door and pushing the rail straight down until it stops. Cool air from the freezer is directed to the door bin directly beneath the vent. NOTE: The dairy compartment and can rack are not chilled. To Remove and Replace the Bins: 1. Remove the bin by lifting it and pulling it straight out. 2. Replace the bin by sliding it in above the desired supports and pushing it down until it stops. Chilled Door Bin Control The chilled door bi
ページ19に含まれる内容の要旨
NOTES: 2. Remove all removable parts from inside, such as shelves, crispers, etc. • The bin can not be removed if it is tilted out all the way. 3. Hand wash, rinse, and dry removable parts and interior Tilt it only part of the way before pressing the curved levers to remove it. surfaces thoroughly. Use a clean sponge or soft cloth and a mild detergent in warm water. • Clean the parts as instructed in the "Cleaning" section. • Do not use abrasive or harsh cleaners such as window sprays, scouring
ページ20に含まれる内容の要旨
• Replace the light shield by inserting the left tab into the freezer wall. Align top tab with screw hole and replace screw. NOTE: Not all appliance bulbs will fit your refrigerator. Be sure to replace the bulb with one of the same size and shape. The lights require a 40-watt appliance bulb. Replacement bulbs are available from your dealer. 1. Unplug refrigerator or disconnect power. 2. Remove light shield when applicable as shown. NOTE: To clean the light shield, wash it with warm water and liq
