ページ1に含まれる内容の要旨
Viking Use/Installation Guide
Combination Beverage Center/
Ice Maker
Viking Range Corporation
111 Front Street
Greenwood, Mississippi 38930 USA
ページ2に含まれる内容の要旨
Retain for Future Reference IMPORTANT - PLEASE READ AND FOLLOW • Before beginning, please read these instructions completely and carefully. Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty. Please observe all local and national codes and ordinances. Please ensure that this product is properly grounded. The installer should leave these instructions with the consumer who should retain for local inspector’s use and for futu
ページ3に含まれる内容の要旨
UNDERCOUNTER CABINET CUTOUT A A 24” (61.0 cm)* A B B Min. 34 1/2” (87.6 cm) B Max. 35 1/8” (89.2 cm) C *Optional: Cutout for electrical C C 24” (61.0 cm) outlet can be * placed in adjacent *24” width for cabinet only. 24 1/4” (61.6 cm) cabinetry. need for cabinet and door width clearance if door is recessed between cabinets. SPECIFICATIONS/DIMENSIONS PROFESSIONAL SERIES B Ba as siic c E Elle ec ct tr riic c D Da at ta a 115 VAC/60 Hz 30 3/4” Maximum amps - 3.3 (78.1 cm) Approximate Shippi
ページ4に含まれる内容の要旨
Front View SPECIFICATIONS/DIMENSIONS DESIGNER SERIES B Ba as siic c E Elle ec ct tr riic c D Da at ta a 115 VAC/60 Hz Maximum amps - 3.3 Approximate shipping weight - 140 lbs (63.2 kg) Mín. 34 1/4” (87.0 cm) Max. 30 3/4” 35” (78.1 cm) (88.9 cm) with leveling legs fully extended 23 7/8” (60.6 cm) Side View 47 1/4” (120.0 cm) 22” (55.9 cm) 24 3/8” (61.9 cm) 25 3/8” ( 64.5 cm) 4
ページ5に含まれる内容の要旨
GENERAL INFORMATION U Un np pa ac ck k 1. Remove banding from bottom of carton. Lift carton up and off of the unit. 2. Remove all tape and packaging material from the outside and inside of the cabinet. 3. Keep all carton packaging until your unit has been thoroughly inspected and found to be in good condition. AREA REQUIREMENTS U Un niit ts s C Ce er rt tiif fiie ed d f fo or r IIn nd do oo or r U Us se e - - ((b blla ac ck k o ou ut te er r c ca ab biin ne et t)) MUST BE INSTALLED I
ページ6に含まれる内容の要旨
FULL OVERLAY PANEL INSTALLATION Note: Weight of wood panel must not exceed 20 lbs. W Wo oo od d S Sc cr re ew ws s 1. A #8 pan head wood screw should be used to properly secure the wood frame. A total of 10 screws will be needed for a 3 1/2” (8.9 cm) kickplate or 8 screws for a 4” (10.2 cm) kickplate. 2. Only use pan head screws. W Wo or rk kiin ng g M Ma at te er riia all W Wo oo od d S Sc cr re ew w S Siiz ze e # #8 8 3. DO NOT select a screw that is longer than the wood thickness a
ページ7に含まれる内容の要旨
SELECTING AND PREPARING THE OVERLAY PANEL F FO OR R A A 3 3- -1 1/ /2 2” ” T TO OE E K KIIC CK K ((C CO OV VE ER RS S T TH HE E E EN NT TIIR RE E D DO OO OR R E EX XT TR RU US SIIO ON N)) 1/4” x 3/8” Deep hinge screw clearance hole. Locate and drill using door hinge hole after the door has been aligned to the unit and when the wood M Miin n.. 5 5/ /8 8” ” ((1 1..7 7 c cm m)) is positioned on door. M Ma ax x.. 3 3/ /4 4” ” ((1 1..9 9 c cm m)) M Mo ou un nt tiin ng g s su ur rf fa
ページ8に含まれる内容の要旨
O OP PT TIIO ON NA AL L F FO OR R 4 4” ” T TO OE E K KIIC CK K T TO O M MA AT TC CH H E EX XIIS ST TIIN NG G C CA AB BIIN NE ET TR RY Y T TO OE E K KIIC CK K H HE EIIG GH HT T 1/4” x 3/8” Deep hinge screw clearance hole. Locate and drill using door hinge hole after the door has been aligned to the unit and when the wood M Miin n.. 5 5/ /8 8” ” ((1 1..7 7 c cm m)) is positioned on door. M Ma ax x.. 3 3/ /4 4” ” ((1 1..9 9 c cm m)) M Mo ou un nt tiin ng g s su ur rf fa ac ce e (
ページ9に含まれる内容の要旨
ATTACHING THE OVERLAY PANEL TO THE DOOR 1. If the door is attached to the unit, remove by unscrewing the top allen head set screw at the top hinge. Remove the door by angling the door off of the bottom hinge pin. 2. Peel back the door gasket to expose the screw holes. 3. Set the overlay panel flush to the front of the door in the desired location. Clamp the overlay panel to the door if necessary. 4. Insert the wood screws through the back of the door into the pilot holes in the overlay p
ページ10に含まれる内容の要旨
ELECTRICAL CONNECTION WARNING ELECTRICAL SHOCK HAZARD Failure to follow these instructions could result in fire or electrical shock. Grounding type wall E Elle ec ct tr riic ca all R Re eq qu uiir re em me en nt ts s Power Supply receptacle A 115 volt, 60 Hz, AC only 15 amp fused electrical supply is required. (A with 3-prong time delay fuse or circuit breaker is recommended.) It is recommended grounding plug that a separate circuit, serving only this appliance, be provided. E EL LE EC C
ページ11に含まれる内容の要旨
WIRING DIAGRAM UNDERCOUNTER 24” W. COMBINATION BEVERAGE CENTER/ICE MAKER W WA AR RN NIIN NG G:: E EL LE EC CT TR RIIC CA AL L G GR RO OU UN ND DIIN NG G IIN NS ST TR RU UC CT TIIO ON NS S This appliance is equipped with a three prong grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded three prong receptacle. Do not cut or remove the grounding prong from this plug. OPERATING INSTRUCTIONS G Ge en ne er ra all T Tiip ps s a an nd d
ページ12に含まれる内容の要旨
S Se et tt tiin ng g t th he e C Co on nt tr ro olls s The temperature control knob is located in the grille below the door. There is a pointer on the grille at the 12:00 position to indicate knob position. The “OFF” position will turn the refrigeration system off. Position 1 is the warmest setting and position 7 is the coldest. Wait at least 2 hours between temperature adjustments to find a temperature that suits you. The refrigerator section temperature of the unit can be adjusted using
ページ13に含まれる内容の要旨
The ice maker must have all water drained and removed to prevent damages as well as possible water damage to the surrounding area in freezing conditions. CAUTION These damages are not covered under warranty. WARNING Do not use any type of anti-freeze or other solutions as a substitution for properly draining the icemaker P Pr re ep pa ar riin ng g t th he e u un niit t f fo or r s st to or ra ag ge e If the unit is move, not used for an extended period of time, or will be in an area that wil
ページ14に含まれる内容の要旨
LIGHT BULB REPLACEMENT WARNING Screws ELECTRICAL FIRE HAZARD Do not replace bulb with a bulb higher than 15 watts. This unit uses a 15-watt appliance bulb with an intermediate base located inside the light shield. The light shield is on the back of the unit and is held in place by the use of three screws. Remove the three screws and light shield to remove the light bulb. DO NOT replace the bulb with a Light bulb higher than 15 watts. Shield E EN NE ER RG GY Y S SA AV VIIN NG G T TIIP PS S
ページ15に含まれる内容の要旨
TROUBLESHOOTING CHART P Pr ro ob blle em m P Po os ss siib blle e C Ca au us se e S So ollu ut tiio on n Odor in cabinet Interior needs cleaning. Clean the interior using a solution of baking soda and war water or water and mild soap Unit operates but does not The unit has just been started and it Typical ice production is 2 lbs per day. Allow produce any ice has been less than 24 hours. for the freezer section to reach temperature and the ice maker to cycle and accumulate ice. Water supply is
ページ16に含まれる内容の要旨
TROUBLESHOOTING CHART P Pr ro ob blle em m P Po os ss siib blle e C Ca au us se e S So ollu ut tiio on n Moisture collects on Hot and humid conditions. Extremely hot and humid conditions can cause outside surface of cabinet condensation on the outside of unit. As humidity and/or temperature decreases, condensation will disappear Moisture collects inside Too many door openings. Limit the amount of door openings. of the unit. Prolonged door openings Limit the amount of time door is open. Hot and
ページ17に含まれる内容の要旨
SERVICE INFORMATION It is assumed that your combination beverage center/ice maker has been properly installed in accordance with all specifications and local codes and the appliance has been properly grounded. If your unit should fail to operate, review the troubleshooting chart before calling for service. If service is required: 1. Call your dealer or authorized service agency. The name of the authorized service agency can be obtained from the dealer or distributor in your area. 2. Have t
ページ18に含まれる内容の要旨
UNDERCOUNTER/FREESTANDING COMBINATION BEVERAGE CENTER/ICE MAKER WARRANTY (Units certified for Outdoor Use) O ON NE E Y YE EA AR R F FU UL LL L W WA AR RR RA AN NT TY Y Undercounter/freestanding combination beverage center/ice makers and all of their components and accessories, except as detailed below*, are warranted to be free from defects in material or workmanship under normal household use for a period of one (1) year from the date of original retail purchase. Viking Range Corporation, w
ページ19に含まれる内容の要旨
UNDERCOUNTER/FREESTANDING COMBINATION BEVERAGE CENTER/ICE MAKER WARRANTY (Units certified for Indoor Use) T TW WO O Y YE EA AR R F FU UL LL L W WA AR RR RA AN NT TY Y Undercounter/freestanding combination beverage center/ice makers and all of their components and accessories, except as detailed below*, are warranted to be free from defects in material or workmanship under normal household use for a period of two (2) years from the date of original retail purchase. Viking Range Corporation,
ページ20に含まれる内容の要旨
Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information call 1-888-VIKNG1 (845-4641) or visit the Viking Web Site at vikingrange.com F20404A 41009271 Rev B (PS0806VR)
